FMS J-3 Cub V3 Handleiding

FMS Radiografisch bestuurbaar speelgoed J-3 Cub V3

Lees hieronder de 📖 handleiding in het Nederlandse voor FMS J-3 Cub V3 (52 pagina's) in de categorie Radiografisch bestuurbaar speelgoed. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/52

FLOAT

Optional float

RIGID

Strong durable EPO

STABLE

Smooth flying performance

Manuel d’utilisation

Instruction Manual

Bedienungsanleitung

操作手册

WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating.

Failure to operate the product correctly can result in damage to the product,personal property and cause serious injury.

This is a sophisticated hobby product and NOT a toy. It must be operated with caution and common sense and failure to do so

could result in injury or damage to the product or other property. This product is not intended for use by children without direct

adult supervision.

This manual contains instructions for safety operation and maintenance. It is essential to read and follow all the instructions and

warnings in the manual prior to assembly, setup or use, in order to operate and avoid damage or serious injury.

WARNING

As the user of this product, you are solely responsible for operating in a manner that does not endanger yourself and others or

result in damage to the product or the property of others. This model is controlled by a radio signal subject to interference from

many sources outside your control. This interference can cause momentary loss of control so it is advisable to always keep a

safe distance in all directions around your model, as this margin will help avoid collisions or injury.

Age Recommendation: Not for children under 14 years. This is not a toy.

·Never operate your model with low transmitter batteries.

·Always operate your model in an open area away from cars, traffic or people.

·Avoid operating your model in the street where injury or damage can occur.

·Never operate the model in populated areas for any reason.

·Carefully follow the directions and warnings for this and any optional support equipment you use (chargers,rechargeable

battery packs, etc.)

·Keep all chemicals, small parts and anything electrical out of the reach of children.

·Moisture causes damage to electronics. Avoid water exposure to all equipment not specifically designed and protected for this

purpose.

·Never lick or any place of any your model in your mouth as it could cause serious injury or even death.

Lithium Polymer (Li-Po) Battery Warning

CAUTION: Always follow the manufacturer’s instructions for safe use and disposal of batteries. Fire, property

damage, or serious injury can result from the mishandling of Li-Po batteries.

By handling, charging or using a Li-Po Battery you assume all risks associated with lithium batteries.

If at any time the batteries begin to swell or balloon, discontinue use immediately!

Always store the batteries at room temperature in a dry area to extend the life of the battery. Always transport

or temporarily store the battery in a temperature range of 40-120F. Do not store the battery or model in a car or in direct sunlight.

If stored in a hot car, the battery can be damaged or even catch fire.

Never use a Ni-Mh Charger to charge Li-Po Batteries. Failure to charge the battery with a Li-Po compatible charger

may cause fire resulting in personal injury and property damage.

Never discharge Li-Po Cells below 3V.

Never leave charging batteries unattended.

Never charge damaged batteries.

Charging the Flight Battery Warning

Use a battery charger that is designed to safely charge the Li-Po Battery. Read the charger instructions care

fully before use. When charging the battery, make certain the battery is on a heat resistant surface. It is also highly

recommended to place the Li-Po Battery inside a fire resistant charging bag readily available at hobby shops or

online.

p w

Before assembly, please inspect the contents of the kit. The

photo below details the contents of the kit with labels. If any

parts are missing or defective, please identify the name or

part number (refer to the spare parts list near the end of the

manual) then contact your local shop or email us: support

Kit contents

A: Fuselage

B: Main wing set

C: tHorizon al stabilizer

D: Vertical stabilizer

E: Main landing gear set PI: ipe and cabl Y e

J:Tail strut

K:Float set

F: Supporting bar

G: Propeller set

H: Linkage rods and screws

Introduction

Kit contents

Model assembly

Battery installation

Receiver diagram

Preflight check

Clevis installation

Control horn and servo arm settings

Center of gravity(CG)

Before flying the model

Flying course

Troubleshooting

Spare parts list content

Table of contents

·····························································

·····

·························································3

·······················································4

············································· ········ 9

·········································

··

········ 9

··································

·····

····················································11

··························

·················

··············································· 11

··············································12

···························································12

······················································13

············································13

Introduction

The Piper J-3 Cub is an American light aircraft that was built

between 1937 and 1947 By the Piper Aircraft Company as an

affordable trainer. The aircraft has a simple, lightweight design

which gives it good low-speed handling properties and short-

field performance. During the WWII, J-3 Cub was designated as

L-4 Grasshopper, used extensively for reconnaissance,

transporting supplies, artillery spotting duties and medical

evacuation of wounded soldiers.

Like its full-sized counterpart, the all-new FMS 1400mm J-3 V3

has excellent short takeoff and landing (STOL) and slow speed

handling characteristics. FMS has dedicated significant amount

of resources in making this aircraft as detailed as possible-

components such as the engine and landing gear, among many

others, are replicated in loving detail. Something worth noting is

that FMS has made scale floats for the Cub as a response to

popular demand from the community.

To mix things up a little, FMS has selected an attractive,

historically accurate red paint scheme for the V3 Cub. Not all

J-3’s were yellow!

For pilots who are looking for an easy-to-fly, scale aircraft that

has gentle trainer characteristics, plenty of power and graceful l

ines from the golden-age of flight- the 1400mm FMS J-3 V3 is

all of that, and more.

Wingspan: 1400mm(55.1in)

Overall length: 900mm(35.4in)

Flying weight: ~ 1320g

Motor size: 3536-KV850

Wing load: 47g/dm²(0.11oz/in²)

Wing area: 28dm²(434sq.in)

ESC: 40A

Servo: 9g Servo x 4

Recommended battery: 11.1V 2200mAh 25C

Specifications

@fmsmodel.com.

Features:

• Powerful 3536-850KV motor, Predator 40A ESC

• Highly detailed scale engine and landing gear

• Simple structure for quick assembly

• Durable EPO material

• Optional scale floats

D. I. J.

Product specificaties

Merk:	FMS
Categorie:	Radiografisch bestuurbaar speelgoed
Model:	J-3 Cub V3
Kleur van het product:	Red, White
Gewicht:	1320 g
Materiaal behuizing:	Uitgebreide polyolefine (EPO)
Capaciteit van de accu/batterij:	2200 mAh
Aanbevolen leeftijd (min):	14 jaar
Accu/Batterij voltage:	11.1 V
Lengte:	900 mm
Constructietype:	Plug en Play (PNP)
Aantal kanalen:	4 kanalen
Montage vereist:	Ja
Type product:	Vliegtuig
Type motor:	Elektromotor
Motorafmeting:	3536-KV850
Reproductie:	Ja
Spanwijdte:	1400 mm
Montagetijd:	45 min
Vliegtijd:	5 min
Aantal servo's:	4
Moeilijkheidsgraad:	Tussenliggend
Gewicht servo:	9 g
Zwaartepunt (CG):	65 mm