Flir FC-313 ID Handleiding

Flir Bewakingscamera FC-313 ID

Lees hieronder de 📖 handleiding in het Nederlandse voor Flir FC-313 ID (74 pagina's) in de categorie Bewakingscamera. Deze handleiding was nuttig voor 28 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/74

Installation

Manual

FC-Series

FC-Series S

FC-Series R

427-0073-12-12 Version 120 May 2015 ii

copied, photocopied, translated, or transmitted to any electronic medium or machine readable form without the

prior written permission of FLIR Systems, Inc.

Names and marks appearing on the products herein are either registered trademarks or trademarks of FLIR

Systems, Inc. and/or its subsidiaries. All other trademarks, trade names, or company names referenced herein are

used for identification only and are the property of their respective owners.

This product is protected by patents, design patents, patents pending, or design patents pending.

The contents of this document are subject to change.

FLIR Systems, Inc.

70 Castilian Drive

Goleta, CA 93117

Phone: 888.747.FLIR (888.747.3547)

International: +1.805.964.9797

http://www.flir.com

Important Instructions and Notices to the User:

Modification of this device without the express authorization of FLIR Commercial Systems, Inc. may void the user’s

authority under FCC rules to operate this device.

Note 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna;

• Increase the separation between the equipment and receiver;

• Connect the equipment into an outlet on a circuit different from that of the receiver; and/or

• Consult the dealer or an experienced radio/television technician for help.

Note 2: This equipment was tested for compliance with the FCC limits for a Class B digital device using a shielded

cable for connecting the equipment to an analog video output to a monitor and using a shielded USB cable for

connecting the equipment to a personal computer. When making such connections, shielded cables must be used

with this equipment.

Industry Canada Notice:

This Class B digital apparatus complies with Canadian ICES-003.

Avis d’Industrie Canada:

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Proper Disposal of Electrical and Electronic Equipment (EEE)

The European Union (EU) has enacted Waste Electrical and Electronic Equipment Directive 2002/96/EC

(WEEE), which aims to prevent EEE waste from arising; to encourage reuse, recycling, and recovery of EEE

waste; and to promote environmental responsibility.

In accordance with these regulations, all EEE products labeled with the “crossed out wheeled bin” either on the

product itself or in the product literature must not be disposed of in regular rubbish bins, mixed with regular

household or other commercial waste, or by other regular municipal waste collection means. Instead, and in

order to prevent possible harm to the environment or human health, all EEE products (including any cables that

came with the product) should be responsibly discarded or recycled.

To identify a responsible disposal method nearby, please contact the local waste collection or recycling service, the original place

of purchase or product supplier, or the responsible government authority in the area. Business users should contact their supplier

or refer to their purchase contract.

Document History

Version Date Comment

100 April 2014 Initial Release

110 June 2014 Minor corrections

120 May 2015 Added description of Analytics setup, description of IDR, other minor corrections

427-0073-12-12 Version 120 May 2015 iii

Table of Contents

Camera Installation

1.1 Warnings and Cautions ............................................................................................ 1-1

1.2 References ...............................................................................................................1-1

1.3 Installation Overview ................................................................................................. 1-2

1.3.1 Camera Connection Options ............................................................................ 1-2

General Purpose Input/Output (GPIO) ............................................................. 1-2

PoE+ Power Supplies ...................................................................................... 1-2

1.3.2 Camera Accessories ........................................................................................ 1-3

1.3.3 Supplied Components ..................................................................................... 1-3

1.3.4 Required Supplies ........................................................................................... 1-3

1.4 Location Considerations ........................................................................................... 1-3

1.4.1 Camera Mounting for Rear Cable Access ........................................................ 1-4

1.4.2 Camera Mounting with Concealed Cable Wall Mount ...................................... 1-5

1.4.3 Sunshield ......................................................................................................... 1-6

1.5 Removing the Cover ................................................................................................. 1-6

1.6 Camera Connections ................................................................................................ 1-7

1.6.1 Prior to Cutting/Drilling Holes ........................................................................... 1-7

1.6.2 Configuring the Lens Heater Jumper ............................................................... 1-8

1.6.3 Bench Testing .................................................................................................. 1-8

1.6.4 Analog Video Connections ............................................................................... 1-8

1.6.5 Connecting Power ........................................................................................... 1-9

1.6.6 Ethernet ........................................................................................................... 1-9

1.6.7 GPIO Connections ......................................................................................... 1-10

1.6.8 Camera Grounding ........................................................................................ 1-11

1.7 Rear Access Cable Gland Sealing .......................................................................... 1-11

1.8 Concealed Cable Mount Accessory ........................................................................ 1-12

1.9 Camera specifications ............................................................................................ 1-15

Basic Operation and Configuration

2.1 IP Camera, ONVIF Profile S Compliant .....................................................................2-1

2.1.1 Server Configuration ........................................................................................ 2-1

2.2 Basic Test and Configuration Steps .......................................................................... 2-2

2.3 Camera Bench Test .................................................................................................. 2-2

2.3.1 Testing IP Communications ............................................................................. 2-2

2.3.2 Log in to the Camera Web Page ...................................................................... 2-3

2.3.3 Live Video Page ...............................................................................................2-4

Temperature—FC-Series R camera only ........................................................ 2-5

Camera Control and Status ............................................................................. 2-5

Web Control Panel .......................................................................................... 2-5

2.3.4 Using FSM ....................................................................................................... 2-7

2.3.5 Running FSM ...................................................................................................2-8

2.4 Basic Camera Configuration ................................................................................... 2-10

Product specificaties

Merk:	Flir
Categorie:	Bewakingscamera
Model:	FC-313 ID
Kleur van het product:	Wit
Gewicht:	2200 g
Breedte:	129 mm
Diepte:	282 mm
Hoogte:	115 mm
Soort:	IP-beveiligingscamera
Gebruikershandleiding:	Ja
Materiaal behuizing:	Metaal
Internationale veiligheidscode (IP):	IP66, IP67
Bluetooth:	Nee
Type verpakking:	Doos
Maximale capaciteit van de geheugenkaart:	32 GB
Vormfactor:	Rond
Ondersteuning voor plaatsing:	Binnen & buiten
Connectiviteitstechnologie:	Bedraad
Ethernet LAN:	Ja
Montagewijze:	Muur
Maximum resolutie:	320 x 240 Pixels
Totaal aantal megapixels:	0.0768 MP
Videocompressieformaten:	H.264,M-JPEG,MPEG4
Type stroombron:	DC,PoE
Stroomuitvoer (volt):	12,24
Minimale belichting:	- Lux
Aantal cameras:	1
Geïntegreerde geheugenkaartlezer:	Ja
Compatibele geheugenkaarten:	SD,SDHC
Ingebouwde HDD:	Nee
Nachtvisie:	Ja
Vaste focale lengte:	25 mm
Zoomcapaciteit:	Ja
Aantal Ethernet LAN (RJ-45)-poorten:	1
Vermogensverbruik (max):	32 W
Certificering:	CE: EN55032 Class A\nFCC 47 CFR Part 15, Subpart B, Class A \nEN 50130-4:2011\nIEC 62599-2:2010\nIEC 60068-2-1:2007\nIEC 60068-2-2:2007\nISTA-1A\nWEEE
Formaat analoog signaal:	NTSC,PAL
Type beeldsensor:	Microbolometer
Digitale zoom:	4 x
Duurzaamheidscertificaten:	RoHS
Plug and play:	Ja
Effectieve sensorresolutie:	76800 Pixels
Temperatuur bij opslag:	-50 - 85 °C
Ondersteunde netwerkprotocollen:	IPV4, HTTP, Bonjour, UPnP, DNS, NTP, RTCP, TCP, UDP, ICMP, IGMP, DHCP, ARP, SCP, FTP, RTP/RTSP, Unicast/Multicast, TCP/IP, HTTP, IEEE 802.1X
Web-gebaseerd management:	Ja
Ethernet interface type:	Fast Ethernet
Aantal lenzen:	1
Maximum aperture number:	1.1
Controle camerapanning:	Nee
Kantelfunctie camera:	Nee
BNC output ports:	1
Aantal sensoren:	1
Videostreaming:	Ja
Inclusief geheugenkaart:	Nee
Achtergrondverlichting compensatie:	Ja
Vooraf ingestelde punten:	Ja
Aanpassing van de afbeeldingskwaliteit:	Brightness,Contrast,Sharpness
Stroomverbruik (voeding via Ethernet (PoE)):	5.5 W
Wifi:	Nee
Stroomverbruik (typisch):	5.5 W
Bedrijfstemperatuur (T-T):	-50 - 70 °C
Relatieve vochtigheid in bedrijf (V-V):	0 - 95 procent
Kijkhoek lens, horizontaal:	13 °
Kijkhoek lens, verticaal:	10 °
Video-intelligentie met analytische capaciteit:	Ja
Interessegebied-codering (ROI):	Ja
Thermische module:	Ja
Thermische framesnelheid (PAL):	25 Hz
Inclusief zonnescherm:	Ja
Thermische framesnelheid (NTSC):	30 Hz