FireAngel NM-CO-10X-INT Handleiding

FireAngel Alarmsysteem NM-CO-10X-INT

Lees hieronder de 📖 handleiding in het Nederlandse voor FireAngel NM-CO-10X-INT (71 pagina's) in de categorie Alarmsysteem. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/71

NM-CO-10X-INT

Positioning

This CO alarm is suitable to

use in domestic premises

(caravan holiday homes),

caravans, motor caravans & boats.

NOTE: This alarm must be installed by a competent

person, able to install according to the instructions.

Where in the room should I place the alarm?

Alarms located in the same room as a fuel-burning

appliance should be:

• at a horizontal distance of between 1m & 3m from the

potential source.

• located on the same side of a partition as the potential

source.

• located at the high side of the room, if sloped ceilings

are present.

If on a wall the alarm should be:

• close to the ceiling;

• at a height greater than any door or window;

• at least 150mm from the ceiling.

If the alarm is on the ceiling it should be at least 300mm

from any wall & any ceiling obstruction e.g. light ttings

Additional alarms may be installed to ensure that adequate

warning is given for occupants in other rooms, by locating

alarms in:

• Remote rooms in which the occupant(s) spend

considerable time whilst awake and from which they

may not be able to hear an alarm from apparatus in

another part of the premises, and;

• Every sleeping room.

Alarms located in sleeping rooms and in rooms remote

from a fuel-burning appliance should be located relatively

close to the breathing zone of the occupants.

Caravans & Boats

Caravans & boats have additional risks due to the

presence of other vehicles, engines, generators or

barbecues, however this does not change the basic

guidance on locating the alarm. Caravans & boats should

have an alarm in the same room as any fuel-burning

appliance, located in accordance with advice above. If the

caravan has a single living space, one alarm is sufcient.

However, any sleeping accommodation which is in a

separate room from the fuel-burning appliance should

also contain an alarm.

The two most important considerations when positioning

your alarm are:

• Not to place the alarm directly above a source of heat

or steam;

• Positioning the alarm at a distance of 1 – 3 m from the

nearest edge of the potential source.

Deactivating your alarm

If you are travelling or storing your alarm, the unit can be

deactivated by retting the disabling tag into the small

holes on the underside of the alarm. You can check the

product is disabled by pressing the test button.

Store the disabling tag on page 71 of this

manual.

How Carbon Monoxide Can Affect You & Your Family

The following symptoms may be related to CO poisoning

which all household members should be aware of:

• Mild Exposure: Slight headache, vomiting, fatigue

(often described as ‘u-like’ symptoms).

• Medium Exposure: Severe throbbing headache,

drowsiness, confusion, fast heart rate.

• Extreme Exposure: Unconsciousness, convulsions,

cardiorespiratory failure, death.

The original English version of the manual, from which these translations were taken, has

been independently approved. In case of discrepancy with translated parts, Sprue Safety

Products Ltd conrms that the English guide is true and correct.

Your CO alarm monitors levels of CO as parts per million

(ppm) in the air surrounding the detector.

35ppm The maximum allowable concentration for

continuous exposure for healthy adults in

any 8 hour period, as recommended by the

Occupational Safety & Health Administration

200ppm Slight headache, fatigue, dizziness, nausea

after 2 - 3 hours.

400ppm Frontal headaches within 1 - 2 hours, life

threatening after 3 hours.

800ppm Dizziness, nausea & convulsions within 45

minutes. Unconsciousness within 2 hours.

Death within 2 - 3 hours.

If you suspect CO may be affecting you, open the doors

& windows to ventilate. Turn off your appliances & leave

the premises.

Common Sources of CO

• Oil & gas boilers

• Portable generators

• Oil or solid fuel cookers

• Gas or parafn heaters

• Barbecues

• Clogged chimneys

• Wood or gas replaces

• Cigarette smoke

• Gas appliances

• Any fossil fuel-burning appliance

This CO alarm should not be seen as a substitute for the

proper installation, use & maintenance of fuel-burning

appliances (including appropriate ventilation & exhaust

systems), nor the sweeping of chimneys.

What To Do In The Event Of An Alarm

WARNING: A loud alarm is a warning that potentially lethal

levels of carbon monoxide are present. Never ignore this

alarm, further exposure can be fatal. Immediately check

residents for symptoms of CO poisoning. Contact the

proper authorities to resolve all CO problems.

• Keep calm; open doors & windows to ventilate the

property.

• Stop using all fuel-burning appliances & if possible,

turn them off.

• Evacuate the property, leaving doors & windows open.

• Ring your fuel supplier on their emergency number.

Write their number here:

__________________________________________

• Depending on the level of CO detected, it can take

up to 10 minutes to clear the sensor and the alarm to

stop. Do not re-enter the property until the alarm has

stopped.

• Get medical help immediately for anyone suffering

the effects of CO poisoning (headache, nausea), and

advise that carbon monoxide poisoning is suspected.

• Do not use appliances again until they have been

checked by an expert.

Understanding the Product’s Indicators

The higher the concentration of CO detected, the quicker

the alarm will respond. When sufcient CO is detected a

loud audible signal of 4 chirps repeated (85 dB at 1m/3

feet) will sound & the Alarm LED will ash red once every

second. The alarm will sound:

Between 60 & 90 mins when exposed to 50ppm of CO.

Between 10 & 40 mins when exposed to 100ppm of CO.

Within 3 mins when exposed to 300ppm or more of CO.

Fault / End of Life Signal:

The alarm constantly checks the settings of its sensor &

circuitry. If the battery power is low, the alarm will chirp

once per minute & the Fault LED will ash amber.

If the amber LED ashes at a separate time from the chirp,

a fault is indicated.

IMPORTANT: If you experience an error condition or low

battery warning and the product is still within warranty

then contact Customer Support. If the product is no longer

in warranty replace immediately.

Product specificaties

Merk:	FireAngel
Categorie:	Alarmsysteem
Model:	NM-CO-10X-INT

Heb je hulp nodig?

Als je hulp nodig hebt met FireAngel NM-CO-10X-INT stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Alarmsysteem FireAngel

FireAngel FS1524W2-T Handleiding

22 November 2023

FireAngel ST-622T Handleiding

14 November 2023

FireAngel NM-CO-10X-INT Handleiding

15 April 2023

Handleiding Alarmsysteem

Nieuwste handleidingen voor Alarmsysteem

Qolsys IQ4 NS Handleiding

25 April 2024

Hikvision DS-PS110-WE Handleiding

17 April 2024

Hikvision DS-PS110-WB Handleiding

17 April 2024

EVOLVEO Defender D5 Handleiding

17 April 2024

Olymp BMD 210 Handleiding

19 Maart 2024

Somfy io Handleiding

12 Maart 2024

Hikvision DS-PDP15P-EG2 Handleiding

12 Maart 2024

Somfy Smoove Lighting io Handleiding

12 Maart 2024

M-e DGF-300 Handleiding

29 Februari 2024

Woonveilig ALARM-03 Handleiding

28 Februari 2024