Fender Passport Event Series 2 Handleiding
Fender
Hifi systeem
Passport Event Series 2
Bekijk gratis de handleiding van Fender Passport Event Series 2 (44 pagina’s), behorend tot de categorie Hifi systeem. Deze gids werd als nuttig beoordeeld door 51 mensen en kreeg gemiddeld 4.7 sterren uit 26 reviews. Heb je een vraag over Fender Passport Event Series 2 of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/44
OWNER’S MANUAL | MANUAL DE INSTRUCCIONES
MODE D’EMPLOI | MANUAL DO PROPRIETÁRIO
MANUALE UTENTE | BEDIENUNGSHANDBUCH
INSTRUKCJA OBSŁUGI | NÁVOD K POUŽITÍ
NÁVOD NA POUŽITIE | UPORABNIŠKI PRIROČNIK
SYSTEM SETUP
Congratulations on purchasing a Fender® Passport Event Series 2
audio system—a self-contained portable audio system designed for
great sound anywhere. Carry Passport like a suitcase, and simply flip
open the cabinet-release latches to access two full-range speaker
cabinets, a powered mixer, and power and speaker cables.
Use Passport as a public address system or to amplify musical
instruments and vocals. Connect mobile devices for easy
accompaniment, including Bluetooth pairing. Passport's quick
and easy setup, its ability to cover large audiences and its simple
operation are the hallmarks of this innovative product. Its control
panel features mono mic/line channels and stereo line channels
with a variety of input jacks to provide superb connectivity
flexibility.
Register your Passport Event Series 2 online at start.fender.com.
ENGLISH
PASSPORT
®
EVENT SERIES 2
1
1. OPEN: Flip open cabinet latches on top of Passport
and detach speaker cabinets from powered
mixer section:
3. SPEAKER CABLE/POWER CORD STORAGE: Open storage
compartment on rear of mixer and remove power cord and
speaker cables:
2. PLACEMENT: For optimal results, elevate speaker cabinets on
Passport speaker stands or sturdy tables. Place the speakers far
apart to maximize stereo separation. Position mixer close by
for easy access to control panel:
4. Plug POWER CORD/SPEAKER CABLE CONNECTION:
speaker cables into left and right speaker jacks on back of
the mixer ( ), then connect corresponding upper right arrow
left and right speakers. Make sure power switch is off before
connecting power cord (included) into power inlet on back of
mixer (lower left arrow); plug other end into a grounded AC
power outlet:
ENGLISH
2
5. INPUTS: Connect microphones to channels 1 through 4;
connect other mono sound sources such as instruments to any
channel ( ). Use channel 6/7 inputs (large arrows smaller arrows) for
stereo/mono sound sources such as keyboards, other line-level
audio sources, and mobile devices:
7. POWER UP: Turn on all external equipment connected to
Passport first, then turn Passport on. Power LED will illuminate
green:
9. SETTING LEVELS: Connect a microphone or other sound
source and slowly turn up that channel's VOLUME control
(curved yellow arrow). LED above VOLUME control will
illuminate green when signal is present. LED will illuminate
yellow when signal is approaching clipping level; will
illuminate red when clipping (distortion) occurs. For best
performance, set channel VOLUME and TONE controls (curved
green arrows) so that LED is green and occasionally yellow.
If LED turns red, reduce VOLUME or TONE control settings.
If LED is still turning red after adjusting VOLUME and TONE
controls, press MIC/LINE button in (straight arrow):
Adjust each channel the same way. Use channel VOLUME
knobs to set relative loudness of each channel for overall
balance, then adjust MASTER VOLUME knob for overall mix
loudness. MASTER VOLUME has a SIGNAL LEVEL METER
just to the right; if meter illuminates red, decrease MASTER
VOLUME accordingly.
6. INITIAL VOLUME/REVERB: Turn MASTER VOLUME knob,
all channel VOLUME knobs and all REVERB knobs fully
counterclockwise to start:
8. SETTING MASTER VOLUME: Turn MASTER VOLUME up to
1/4 volume:
10. SETTING TONE/REVERB: Starting with each TONE
control (TREBLE, BASS) in the center-detented position (flat
equalization), set each TONE control to preference for best
clear and consistent sound coverage throughout the area.
REVERB controls (green arrows) are not center detented; set
these to preference:
Product specificaties
| Merk: | Fender |
| Categorie: | Hifi systeem |
| Model: | Passport Event Series 2 |
Heb je hulp nodig?
Als je hulp nodig hebt met Fender Passport Event Series 2 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Hifi systeem Fender
6 Juni 2023
29 Mei 2023
24 Mei 2023
Handleiding Hifi systeem
- AmpliVox
- Massive
- Meridian
- Griffin
- Focal
- SPC
- Monster
- Xact
- Proscan
- Starkey
- Vantage Point
- Alpine
- Pyle Pro
- Bigben Interactive
- Orbitsound
Nieuwste handleidingen voor Hifi systeem
17 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
10 Juni 2025
10 Juni 2025
9 Juni 2025
9 Juni 2025
3 Juni 2025