Federal Vision VHSS4860SLD Handleiding

Bekijk gratis de handleiding van Federal Vision VHSS4860SLD (2 pagina’s), behorend tot de categorie Koelkast. Deze gids werd als nuttig beoordeeld door 3 mensen en kreeg gemiddeld 4.5 sterren uit 3 reviews. Heb je een vraag over Federal Vision VHSS4860SLD of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Quick Start Guide

E3981-10 VHSS Quick Reference Guide

For

S

ervice

or Technical assistance

please call

(833) 238

-

8168

or email

[email protected]

For

S

ervice

or Technical assistance

please call

(833) 238

-

8168

or email

techservice@partstown.com

Important safety information is presented throughout this document using the following signal words:

DANGER:

Severe injury or death will occur if you ignore the message.

WARNING:

Severe injury or death can occur if you ignore the message.

CAUTION:

Minor injury or damage to your case can occur if you ignore the message.

NOTICE:

This is important installation, operation, or service information. If you ignore the

message, you may damage your case.

This is the safety-alert symbol. When you see this symbol on your case or in the manual, be alert to the potential

for personal injury or damage to your equipment.

NOTICE

Read this manual before installing your case. Keep this manual and refer to it before doing any service on the

equipment. Failure to do so could result in personal injury or damage to the case.

NOTICE

Installation and service of the electrical components in the case must be performed by a licensed electrician. The

portions of this manual covering components contain technical instructions intended only for persons qualified to

perform electrical work.

DANGER

Improper or faulty hookup of electrical components in the case can result in severe injury or death. All electrical

wiring hookups must be done in accordance with all applicable local, regional, or national standards.

NOTICE TO EMPLOYERS

You must make sure that everyone who installs, uses, or services your case is thoroughly familiar with all safety

information and procedures.

Locating The Display Case

Avoid locating this unit next to sources of air flow and heat:

Heating ducts, grills/fryers, radiators, ceiling fans, exterior doors/entrances/exits, and other sources of moving air and/or

extreme hot/cold temperatures.

RemovingCaseFromShippingSkid

Be sure toleaveshelfpackagingmaterialintactforthisstep. First remove the base front and rear panels Two or more

people shouldbeinvolvedinmovingtheunitfromthepalletontotheground.Removethe(4)1/4”screws thatsecurethe

case to theskid.Thesescrewsarelocatedinthefrontandrearcornersofthebaserails.Basefrontandrearpanels must

be removedtoaccessthesebolts.

LAGBOLT

LOCATIONS

REMOVE CASE OFF OF FRONT OR BACK OF SKID ONLY

PULL SKID AWAY FROM CASE

AND GENTLY SET CASE ON FLOOR

Once all the bolts are removed, slide the unit off the back of the shipping pallet, and tilt it so the rear corner touches the

ground. Then have someone move pallet out from under the case and gently tilt the case forward until it touches the floor.

Product specificaties