Federal UCRSL7233S Handleiding

Bekijk gratis de handleiding van Federal UCRSL7233S (2 pagina’s), behorend tot de categorie Koelkast. Deze gids werd als nuttig beoordeeld door 5 mensen en kreeg gemiddeld 4.6 sterren uit 4 reviews. Heb je een vraag over Federal UCRSL7233S of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Quick Start Guide

E4037 UCR Quick Reference Guide

For

S

ervice

or Technical assistance

please call

(833) 238

-

8168

or email

[email protected]

For

S

ervice

or Technical assistance

please call

(833) 238

-

8168

or email

[email protected]

Important safety information is presented throughout this document using the following signal words:

DANGER: Severe injury or death will occur if you ignore the message.

WARNING: Severe injury or death can occur if you ignore the message.

CAUTION: Minor injury or damage to your case can occur if you ignore the message.

NOTICE:

This is important installation, operation, or service information. If you ignore the

message, you may damage your case.

This is the safety-alert symbol. When you see this symbol on your case or in the manual, be alert to the potential

for personal injury or damage to your equipment.

NOTICE

Read this manual before installing your case. Keep this manual and refer to it before doing any service on the

equipment. Failure to do so could result in personal injury or damage to the case.

NOTICE

Installation and service of the electrical components in the case must be performed by a licensed electrician. The

portions of this manual covering components contain technical instructions intended only for persons qualified to

perform electrical work.

DANGER

Improper or faulty hookup of electrical components in the case can result in severe injury or death. All electrical

wiring hookups must be done in accordance with all applicable local, regional, or national standards.

NOTICE TO EMPLOYERS

You must make sure that everyone who installs, uses, or services your case is thoroughly familiar with all safety

information and procedures.

Locating The Display Case

Avoid locating this unit next to sources of air flow and heat:

Heating ducts, grills/fryers, radiators, ceiling fans, exterior doors/entrances/exits, and other sources of moving air and/or

extreme hot/cold temperatures.

Avoid locating this unit in humid locations:

Misters/foggers and humidification devices or their discharge areas.

If this case or cases are to be located against a wall there should be at least 6” between the case and the wall to allow air

circulation. Failure to give adequate space may cause exterior surfaces to sweat.

Removing Case From Shipping Skid

Be sure to leave shelf packaging material intact for this step. Two or more people should be involved in moving the unit

from the pallet onto the ground. Remove the (8) #10 screws that secure the brackets to the skid. These screws are

located in the front and rear corners of the case.

Once all the screws are removed, the shipping brackets can be removed. Slide the unit off the back of the shipping pallet

and tilt it so the rear corner touches the ground. Then have someone move pallet out from under the case and gently tilt

the case forward until it touches the floor.

Product specificaties