Extron WPB 109 Handleiding

Bekijk gratis de handleiding van Extron WPB 109 (2 pagina’s), behorend tot de categorie Stopcontact. Deze gids werd als nuttig beoordeeld door 15 mensen en kreeg gemiddeld 4.7 sterren uit 2 reviews. Heb je een vraag over Extron WPB 109 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

IMPORTANT:

Go to www.extron.com for the

complete user guide, installation

instructions, and specifications.

WPB 109 Wallplate • Installation Guide

The Extron WPB 109 wallplate is a single gang

pass-through wallplate with audio, VGA, and HDMI

connectors and 10-inch pigtails. It can be installed in

the supplied single gang mud ring or a junction box.

Install the wallplate directly into the wall using the

supplied mud ring or a UL-approved 1-gang junction

box (not supplied). Follow the steps in the “Installation”

section.

Planning - Check the Proposed Installation Location

Before starting the installation it is important that you do the following:

WARNING:Failure to check these items may result in property damage, personal injury,

or both.

c

Ensure there are no utility cables or pipes at the intended location that might be damaged

or cause injury when you are installing the device.

c

Check that the installation meets the local and state regulatory requirements, including

building, electrical, and safety codes, and UL and ADA accessibility requirements.

During installation ensure the space behind the device is sufficient for the bend radius of the

pigtail. The recommended minimum bend radius is 2.4 inches.

WPB 109

HDMI

COMPUTER

AUDIO

FrontSide

Extron

WPB 109

Wall Mounting

Bracket

Locking Arms

WPB 109

HDMI

COMPUTER

AUDIO

Installation

1. Using the supplied mud ring or a junction box (not included) as a guide, mark and cut out

the appropriate material within the marked area.

2. Either:

zInsert the mud ring into the opening, rotate the

locking arms, and secure it with the supplied screws

(as shown at right), or

zInsert the junction box and secure it with nails or

screws.

3. Run the cables (video, audio, and HDMI) from the output

or input device locations (as applicable), behind the wall,

and to the WPB location, then thread the cables through

the mud ring or junction box.

4. Video — Insert the HDMI and VGA cable connector into

the appropriate connector on the pigtail.

NOTE:If using a DVI display with the WPB 109, connect a HDMIM-DVIDF adapter (part

number 26-617-01) and a separate audio cable.

5. Audio — Secure the output audio cable into the 3-pole captive screw connector. Wire as

described in “Cable Preparation for Audio Connections” on page 2.

NOTE:This may be easier to do before attaching the device to the mud ring.

6. Mount the cabled device into either the mud ring or the junction box.

CONTINUED ON SIDE 2

1

Product specificaties