Eureka Tundern Cove 6 Handleiding

Bekijk gratis de handleiding van Eureka Tundern Cove 6 (2 pagina’s), behorend tot de categorie Tent. Deze gids werd als nuttig beoordeeld door 50 mensen en kreeg gemiddeld 4.1 sterren uit 7 reviews. Heb je een vraag over Eureka Tundern Cove 6 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1.Unroll your tent and separate the tent from the fly. Assemble

the frame poles being sure all connections are complete.

2.Spread out the tent in desired site location. Stake corner fac-

ing into wind in windy conditions.

3.Locate the pole sleeves found on the top of the tent. Slide

poles through sleeves so they form an X pattern on the still

flat tent. In one corner insert the corner pin into the base of

the pole. Move to the other end of the same pole, diagonally

opposite, and insert the corner pin into this pole end. In this

process the pole will flex into a hoop shape. Be careful dur-

ing this process to not over stress the pole. You can relieve

excess pressure by grabbing the pole sleeve end and pull to

center the sleeves over the mid section of the hoop.

4.Repeat step 3 with the second long frame pole.

5.Attach remaining clips to frame at the peak.

6.Tent can now be staked in location.

7.Spread the fly sheet over the tent positioning the vestibule

over the tent door that has yellow webbing in one corner as

this is the front.

8.Feed the vestibule pole through the vestibule pole sleeve al-

ways pushing, never pulling.

9.Take one end of the vestibule pole and insert a pin into the

pole end. The pin will be located on the corner ring of the

tent.

10.Repeat step 9 with the other end of the pole. During this

step the vestibule pole will flex into a hoop. Attach any re-

maining clips

11.Attach all four fly sheet corners, with the hooks provided, to

the four tent corner rings.

12.Stretch out the vestibules and stake out using the fabric

loops

13.On each side are positions supplied to pull out the fly sheet

and stake.

14. On the underside of the tent fly sheet locate the Velcro fas-

teners and wrap around the tent poles.

15. If required, for windy

conditions you can

use the pre-rigged

guylines to stake out

for more stability.

ASSEMBLY INSTRUCTIONS for Tundern Cove 6/Evasion

Important

• Please set up your tent prior to your first trip to ensure you

are familiar with set up and the tent is in proper condition.

• Always choose a site with good drainage. Inspect the site and

remove any sharp or protruding objects that could damage

the tent floor.

• Although major seams are taped we recommend seam seal-

ing guy out locations due to stitching through tape, and any

other seams where taping may not have been possible

1.The suns UV rays can be harmful even with technical ad-

vances in fabrics. Prolonged exposure could result in fading

and possibly fabric disintegration. When choosing a site try

to pitch the tent in a shaded area. Do not leave a tent up

longer than necessary.

2.Fuels can damage tents as can DEET found in many insect

repellents.

3.All major seams are factory taped. Over time seams could

experience delamination. Simply clean the seam and apply

seam sealer that can be purchased at most outdoor stores.

4.Avoid storing your tent in a hot location.

5.Please be sure to store your tent dry. Mildew can occur on

waterproof coatings if stored when wet.

TIPS

SET UP

Product specificaties