EPH Elektronik GS24S/10/P DC Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor EPH Elektronik GS24S/10/P DC (9 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 123 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
Stand Juni 2017 Z385-MG
Assembly instruction / User manual
Chopper controller for DC motors type GS 24 S - 360
Technical data under reserve technical changes
Please read these instruction before using and please keep safe for future.
You may download further technical advice under . www.eph-elektronik.de
Stand Juni 2017 Z385-MG
Table of contents
1. Safety Instructions and Safeguarding ................................................................ 3
1.1. Installation note .......................................................................................... 3
1.2. ESD-protection / Hazard note .................................................................... 3
3. Connecting ......................................................................................................... 5
3.1. Connecting diagram ................................................................................... 5
4. Option change of rotating direction – Type:393 .................................................. 6
4.1. Generell information / Operation ................................................................ 6
4.2. Terminal block layout x1: Type 393 ........................................................... 7
4.3. Connection for change of rotating direction option..................................... 8
5. CE Declaration of Conformity ............................................................................. 9
Stand Juni 2017 Z385-MG
1. Safety Instructions and Safeguarding
1.1. Installation note
An external mains adapter is required for the electrical supply of the controller
EPH 360. If this mains adapter is itself supplied with a voltage >75V AC or
>50V DC the following points have to be considered:
The unit should only be installed by qualified specialist personnel. Installation
and operation of the unit should comply with the local regulations for electrical
installations as well as health and safety regulations. The protection of people
and property must be warranted by applying the currently applicable safety
regulations (VDE, electrical safety regulations, IEC, etc.). High start-up
currents can occur at the moment of tuning on a controller device / mains
adapter due to charging process of the intermediate circuit. An effective
safeguard is therefore required on the mains input side (e.g. a C-Rated 16A
line circuit breaker). The use of RCD circuit breakers before control unit /
mains adapter is not recommended because of the leakage currents
generated by EMC interference suppressing devices. The regulator card /
mains adapter must not be operated without an effective connection to earth!
The connection to earth must comply with local regulations.
1.2. ESD-protection / Hazard note
Attention during
installation of the
electronic board!
It must be warranted on
your part that there is
sufficient ESD-protection.
Danger to burn -
Beware!
Parts of this controller
card can be reach a
temperature up to
80°C.
Increased risk at
controller cards
without protective
cover.
Danger to fire-
Beware!
Unprofessional
handling and
installation can
cause a fire.
Danger to life-Beware!
Parts of this controller
card are under
intermediate circuit
voltage and remain
energised >50VAC
respectively 75VDC after
turning main power off.
Coming into contact with
the terminals, lines and
unit parts can cause
serious injuries or result in
death!


Product specificaties

Merk: EPH Elektronik
Categorie: Niet gecategoriseerd
Model: GS24S/10/P DC

Heb je hulp nodig?

Als je hulp nodig hebt met EPH Elektronik GS24S/10/P DC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd EPH Elektronik

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd