Elkay MFWS100 Handleiding

Bekijk gratis de handleiding van Elkay MFWS100 (1 pagina’s), behorend tot de categorie Water dispenser. Deze gids werd als nuttig beoordeeld door 2 mensen. Heb je een vraag over Elkay MFWS100 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620

98560C (Rev. C - 8/11)

1. Cut a square rectangular wall opening 18 3/4" (476mm) W x 40" (959mm) H and 4 1/2" (114mm)

above the floor line.

2. Reinforce the wall opening on all sides so that it will adequately support the bottle filling station. This

reinforcement must support up to 150 lbs static load and provide a means for securing the frame

assembly in place.

NOTE:Building construction must allow for adequate air flow on both sides and top of remote chiller

unit. Minimum of 4" (102mm) is required.

3. Install plumbing and electrical rough-ins.A junction box for a (3) wire, 10 amp branch circuit is

provided on the inside of the chiller. (Standard 120 Volts, 60 Hz and single phase)

4. Remove frame and related hardware from packaging. Install the frame squarely in wall opening

with frame upright edges ush with the nished wall face. Place shelf inside frame and line up

the (2) holes on each. Insert loose ends of rods into holes on sides of shelf panel. Using

appropriately sized screws or bolts (not provided), fasten the shelf and frame to bottom of wall

opening. Secure the frame sides and top to the wall using (10) 5/16" bolts or screws (not provided).

NOTE: Be sure that frame is squared in location. Do not use less than the required screw quantity and

size.

MFWS100 MOUNTING FRAME INSTRUCTIONS

40"

1016mm

4 1/2

114mm

18 3/4"

476mm

5 1/8"

130mm

BACK OF WALL TO

BE 12" (305mm)

MIN DEPTH

8"

203mm

TO FLOOR LINE

FLOOR LINE

WOOD OR STEEL FRAME SHOWN

(NOT PROVIDED)

ELECTRICAL INLET

LOCATION ON CHILLER

1"

25mm

CHILLER SHELF

P/N 27638C

HOOK RODS (2)

P/N 101567443730

SCREWS OR BOLTS

(NOT PROVIDED)

5/16" SCREWS OR BOLTS

(10 REQ'D-NOT PROVIDED)

FRAME

INSTALL (2) SCREWS

(P/N 111008343890) IN FRAME

BEFORE INSTALLING IN OPENING

IMPORTANT:

DOUBLE STUD OR 3 INCHES (76 mm)

BETWEEN MOUNTING FRAMES

IF PLACED NEXT TO ANOTHER

BOTTLE FILLER, FOUNTAIN OR WALL

Product specificaties