Electrolux EFT9516X Handleiding

Electrolux Afzuigkap EFT9516X

Lees hieronder de đź“– handleiding in het Nederlandse voor Electrolux EFT9516X (11 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/11
USER MANUAL : COOKER HOOD
EFT7516K
EFT7516X
EFT9516K
EFT9516X
Description................................................1
Installation ................................................1
Installation Ducting Version ... ....................1
Installation Filtering Version .. ....................2
Operation ................................................. 3
Warning ....................................................3
Wiring Diagram .........................................4
Diagram ....................................................4
Warranty Condition ...................................8
CONTENTS
DESCRIPTION
The hood may be installed in the filtering or the ducting version.
Ducting version (Fig.1): The hood aspirates the kitchen air saturated with fumes and odour,
passes it through the grease filters and expels it to the outside through an outlet pipe. With
this version the charcoal filters are not required.
Decide from the outset on the type of installation (filtering or ducting). For greater efficiency,
we recommend you install the hood in the ducting version (if possible).
Filtering version (Fig.2): The hood aspirates the kitchen air saturated with fumes and odour.
Purifies it through the grease filters and charcoal filters and returns clean air into the room.
For constant efficiency, the charcoal filters must be replaced periodically.
INSTALLATION
-Before beginning installation, to better handle the hood, we advise removing the grease
filters.
-To remove the grease filter/s (Fig.3), in line with the handle, push the stop inwards and pull the
filter down.
INSTALLATION IN DUCTING VERSION:
-Before fixing, the outlet pipe for air evacuation to the outside must be installed. Use an outlet
pope with: - minimum indispensable length; -Minimum possible bends (maximum angle of
bend:90°); -certified material (according to the state); _ an as smooth as possible inside. It is
also advisable to avoid any drastic changes in pipe cross-section (recommended diameter:
155mm).
-Decide on the position of the hole for the air outlet: The hole may be in the wall or the ceiling,
according to your requirements, but must be in vertical line with your hood. Bear in mind that
the hood just expel air through the top opening A (Fig.4).
-Mounting the air outlet adapter to the top opening A by securing two screws. Bear in mind that
the opening B(Fig.4) must be closed by two ventilation cover with 4 screws(Fig.5) then insert
the nameplate into the ventilation covers(Fig.6).
-Drill the hole in the wall for the air outlet (163 mm diameter) referring to Fig.7 where the
measurements for the various possibilities are indicated.
-Prepare a suitable power supply. For the electrical connection, follow all the other instructions
on the other instructions on the page 3.
-Proceed with fixing the hood: Based on your requirements, you can fit the hood on the wall or
on a wall unit of your kitchen. IMPORTANT: Respect the distance between the hob and lower
part of the hood which must be at least 650 cm.
-Fixing to the wall:
Before fixing the hood to the wall, mount two mounting brackets to the hood
from two side with 4 screws provided(Fig.8) and drill a hole of 163mm diameter in the wall unit
(Fig.7). In any case, check the position of the power outlet and consider where the power
cable will run, since a hole might have to be made in the wall unit to accommodate it. Draw a
line on the wall in vertical line with your hob. Mark the2 holes to be drilled in the wall,
respecting the distances indicated in Fig. 7; Make the 2 holes and fit the 2 screw anchors
provided then without screwing that 2 of screws down completely. Hang the hood on the 2
screws; tighten the 2 screws completely. Now proceed with connecting a flexible tube to the
hood outlet adapter tight well by mounting 2 screws. Tube is not provided. Make the electrical
connection.
Page1

Product specificaties

Merk: Electrolux
Categorie: Afzuigkap
Model: EFT9516X

Heb je hulp nodig?

Als je hulp nodig hebt met Electrolux EFT9516X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Afzuigkap Electrolux

Electrolux

Electrolux ERCE9025BK Handleiding

17 April 2024
Electrolux

Electrolux ERCG9030AS Handleiding

17 April 2024
Electrolux

Electrolux ERI812SE Handleiding

17 April 2024
Electrolux

Electrolux UltimateTaste 700 ERI635DSE Handleiding

17 April 2024
Electrolux

Electrolux ERCM9010AS Handleiding

17 April 2024
Electrolux

Electrolux UltimateTaste 700 ERI935DSE Handleiding

17 April 2024
Electrolux

Electrolux ERI512SE Handleiding

17 April 2024
Electrolux

Electrolux ERCE90AS Handleiding

17 April 2024
Electrolux

Electrolux LFE116W Handleiding

3 April 2024
Electrolux

Electrolux EFG50300W Handleiding

29 Juli 2023

Handleiding Afzuigkap

Nieuwste handleidingen voor Afzuigkap

IKEA

IKEA LAGAN 304.660.02 Handleiding

2 Mei 2024
IKEA

IKEA ALLMĂ„NBILDAD 704.621.44 Handleiding

2 Mei 2024
Bauknecht

Bauknecht BHVS 91F LT DP K Handleiding

27 April 2024
Venmar

Venmar Jazz VJ603302SS Handleiding

25 April 2024
Blomberg

Blomberg BIRC24102SS Handleiding

25 April 2024
Bosch

Bosch DWK67FN20 Handleiding

21 April 2024
Euro Appliances

Euro Appliances EA90SX2 Handleiding

20 April 2024
Euro Appliances

Euro Appliances E276IFBM Handleiding

20 April 2024
Emilia

Emilia CK75UCF Handleiding

17 April 2024
Fisher And Paykel

Fisher And Paykel HS90CSX3 Handleiding

17 April 2024