Electro-Voice XLE191-FG Handleiding

Bekijk gratis de handleiding van Electro-Voice XLE191-FG (4 pagina’s), behorend tot de categorie Speaker. Deze gids werd als nuttig beoordeeld door 38 mensen en kreeg gemiddeld 4.8 sterren uit 9 reviews. Heb je een vraag over Electro-Voice XLE191-FG of wil je andere gebruikers van dit product iets vragen? Stel een vraag

X-Line Very Compact

Crossover Retrofit

Installation Instructions

YOU WILL NEED:

- ONE SHORT-HANDLED PHILLIPS SCREWDRIVER

- ONE SHORT-HANDLED ¼” NUT DRIVER

- SMALL SCRAPER OR PUTTY KNIFE

- SMALL WIRE (SIDE) CUTTER TO SNIP CABLE TIES

- CARPENTERS’ WOOD GLUE

- 3M SUPER 77 SPRAY ADHESIVE OR LIQUID

CONTACT CEMENT

1)REMOVE THE 6 SCREWS HOLDING THE INPUT PANEL. CAREFULLY UNPLUG THE MOLEX CONNECTOR

FOR THE TRANSDUCER WIRING AND PEEL OFF THE CONTACT INFORMATION LABEL COVERING THE

“BIAMP” INDICATOR WINDOW ON XLD OR “PASSIVE” INDICATOR WINDOW ON XLE.

2)REMOVE THE GRILLE.

3)REMOVE THE WOOFER THAT SHARES THE SAME CHAMBER AS THE INPUT PANEL.

4)STAND THE ENCLOSURE ON ONE END WITH THE NOW OPEN CHAMBER ON TOP. REMOVE THE BATTING

FROM THIS CHAMBER AND DISCARD.

5)USING THE ¼” NUT DRIVER, UNSCREW THE TWO CABLE TIES SECURING THE WIRES TO THE DIVIDER

PANEL. SAVE THE SCREWS.

6)CAREFULLY SNIP THROUGH THE CABLE TIES TO FREE THE WIRES FROM THEIR BUNDLE, TAKING CARE

NOT TO DAMAGE THE INSULATION ON THE WIRES.

7)SCRAPE OFF ANY EXCESS GLUE DRIBBLES, ADHESIVE AND LEFTOVER BATTING FROM THE SIDEWALLS

OF THIS CHAMBER, ESPECIALLY THE DIVIDER PANEL. TAKE CARE NOT TO ALLOW WIRING TO BE

DAMAGED BY YOUR SCRAPER BLADE. DO NOT DISTURB CAULKING MATERIAL IN WIRING THRU-HOLE

TO HF CHAMBER. IF YOU DO, IT MUST BE RE-SEALED WITH SILICONE RTV CAULK.

8)NOTE THE CHANNELS MILLED INTO ONE SIDE OF THE NEW MOUNTING BOARD. (THE SIDE WITH THE T-

NUTS SHOWING) APPLY AN EVEN LAYER OF WOOD GLUE TO THE FLAT AREAS ADJACENT TO THESE

CHANNELS. (SEE FIGURE 1)

Glue

Rounded Corner

Glue

Rounded Corner

Glue

000-649103TSILSTRAPTIFORTERREVOSSORCE/DLX

N/PNOITPIRCSED.YTQ

000-080207DRAOBGTMTIFORTERREVOXE/DLX1

000-804065E/DLX,REVOX1

90883NOLYN,TALF,REHSAW7

PCL4127068

/7X42-01,WERCS7

31437EITELBAC1

000-126195GNITTABFL1

000-141185WERCSLLAWYRD”¼1x8#6

47401183TIFORTERREVOXE/DLX,SNOI

TCURTSNI1

This End of Mounting Board

to Rear of Enclosure

T-Nuts

Figure 1: Apply Glue to Mounting Board

Channel

Channel

Product specificaties