Electro-Voice TK-150 Handleiding

Bekijk gratis de handleiding van Electro-Voice TK-150 (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 16 mensen en kreeg gemiddeld 4.1 sterren uit 8 reviews. Heb je een vraag over Electro-Voice TK-150 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Installation Instructions

F.01U.301.246 Rev 03 08/2014

TK-150

150 Watt Transformer for 70.7/100 Volt Lines

Tools Required:

1. #2 Phillips screwdriver

2. 3/16 in (5 mm) at blade screwdriver

High Pass Filter Requirements:

The TK-150 is designed to be used with a 50 Hz Butterworth

24 dB/octave active high-pass lter inserted in the signal chain

at the input to the driving amplier. This lter protects the

amplier from damage caused by transformer saturation at

low frequencies and allows any number of transformers to be

driven on the same line, up to the rated power of the amplier.

The TK-150 is capable of delivering up to 300 Watts to the

loudspeaker using the following conguration. Connect a 100 V

drive line to the tap labeled, DO NOT USE (150 W at 70.7 V).

Insert a Butterworth 24 dB/octave active high-pass lter tuned

to 66 Hz or higher in the signal chain at the input to the driving

amplier. Due to the band limited spectrum of the EN54-24

simulated program signal (89 Hz - 11.2 kHz) the EN54-24 rated

power handling is certied up to 400 Watts at the100 V drive line.

!

Caution!

Failure to use the proper high-pass lter may result

in damage to the amplier.

Instructions:

To install the TK-150, do the following:

1. Remove the input panel by removing the eight (8) screws

securing it.

Make note of the original orientation prior to removing the

input panel.

2. Unplug the crossover wiring harness from the 7-pin header.

3. Place the input panel horizontally face down with the green

circuit board on the right.

4. Place the transformer in the pocket on the left.

The lead wires from the transformer should be pointed

toward you.

5. Secure the transformer mounting ears to the four (4)

input panel bosses with the four (4) #10 screws provided.

Carefully tighten the screws evenly in an X-cross pattern to

avoid warping the plastic input panel.

6. Unplug the 8-position jumper connector located at right

angle to the 7-pin crossover header.

Product specificaties