ECS IC43T-A2 (V1.0) Handleiding

ECS Moederbord IC43T-A2 (V1.0)

Lees hieronder de 📖 handleiding in het Nederlandse voor ECS IC43T-A2 (V1.0) (66 pagina's) in de categorie Moederbord. Deze handleiding was nuttig voor 17 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/66

Preface

This publication, including all photographs, illustrations and software, is protected

any of the material contained herein, may be reproduced without written consent of

the author.

Version 2.0

Disclaimer

The information in this document is subject to change without notice. The manufac-

turer makes no representations or warranties with respect to the contents hereof and

specifically disclaims any implied warranties of merchantability or fitness for any

particular purpose. The manufacturer reserves the right to revise this publication and

to make changes from time to time in the content hereof without obligation of the

manufacturer to notify any person of such revision or changes.

Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installa-

tion. This equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful inter-

ference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the equipment onto an outlet on a circuit different from that to

which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

Shielded interconnect cables and a shielded AC power cable must be employed with

this equipment to ensure compliance with the pertinent RF emission limits govern-

ing this device. Changes or modifications not expressly approved by the system’s

manufacturer could void the user’s authority to operate the equipment.

Trademark Recognition

Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp.

MMX, Pentium, Pentium-II, Pentium-III, Celeron are registered trademarks of Intel

Corporation.

Other product names used in this manual are the properties of their respective

owners and are acknowledged.

Preface

Declaration of Conformity

This device complies with part 15 of the FCC rules. Operation is subject to the

following conditions:

• This device may not cause harmful interference, and

• This device must accept any interference received, including interfer-

ence that may cause undesired operation

Canadian Department of Communications

This class B digital apparatus meets all requirements of the Canadian Interference-

causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur

le matériel brouilieur du Canada.

About the Manual

The manual consists of the following:

Chapter 1

Introducing the Motherboard

Chapter 2

Installing the Motherboard

Chapter 3

Using BIOS

Chapter 4

Using the Motherboard Software

Describes features of the

motherboard.

Go to Hpage 1

Describes installation of

motherboard components.

Go to Hpage 7

Provides information on using

the BIOS Setup Utility.

Go to Hpage 25

Describes the motherboard soft-

ware

Go to Hpage 45

Chatper 5

Setting Up eJIFFY

Describes the eJIFFY setting up

Go to Hpage 49

Chatper 6

Trouble Shooting

Provides basic troubleshooting

tips

Hpage 59

Go to

iii

TTTABLE OF CONTENTSABLE OF CONTENTS

ABLE OF CONTENTSABLE OF CONTENTSABLE OF CONTENTS

Preface i

Chapter 1

Introducing the Motherboard 1

Introduction......................................................................................1

Feature ..............................................................................................2

Motherboard Components.............................................................4

Chapter 3 25

Using BIOS 25

About the Setup Utility................................................................ 25

The Standard Conﬁguration...............................................25

Entering the Setup Utility....................................................25

Resetting the Default CMOS Values...................................26

Using BIOS.....................................................................................27

Standard CMOS Setup.......................................................28

Advanced Setup..................................................................30

Advanced Chipset Setup.....................................................31

Chapter 2 7 7 7 7 7

Installing the Motherboard 7

Safety Precautions...........................................................................7

Choosing a Computer Case............................................................7

Installing the Motherboard in a Case...........................................7

Checking Jumper Settings..............................................................8

Setting Jumpers....................................................................8

Checking Jumper Settings....................................................9

Jumper Settings....................................................................9

Installing the Processor......................................................10

Installing Memory Modules................................................12

Expansion Slots....................................................................15

Connecting Optional Devices.............................................17

Connecting I/O Devices...............................................................20

Connecting Case Components....................................................21

Front Panel Header............................................................23

Installing Hardware........................................................................10

Installing a SATA Hard Drive............................................19

Product specificaties

Merk:	ECS
Categorie:	Moederbord
Model:	IC43T-A2 (V1.0)
Breedte:	305 mm
Diepte:	210 mm
Type stroombron:	ATX
Aantal USB 2.0-poorten:	4
Microfoon, line-in ingang:	Ja
Aantal Ethernet LAN (RJ-45)-poorten:	1
Hoofdtelefoonuitgangen:	2
Certificering:	EuP
HDCP:	Ja
Processor socket:	LGA 775 (Socket T)
Processorfabrikant:	Intel
Maximum intern geheugen:	8 GB
Compatibele besturingssystemen:	Windows Vista, 7
Audio-uitgangskanalen:	5.1 kanalen
Netwerkfuncties:	Gigabit Ethernet
Audiochip:	Realtek ALC662
PCI Express x1 slots:	3
PCI Express x16 slots:	1
PS/2 poort(en):	2
Seriële poort(en):	1
LAN controller:	Realtek RTL8111C
PCI-slots:	2
Compatibele processors:	Intel Core 2 Duo, Intel Core 2 Extreme, Intel Core 2 Quad
Ondersteuning voor processor FSB:	1066,1333 MHz
Moederbord form factor:	ATX
Aantal geheugenslots:	4
BIOS type:	AMI
Grootte BIOS-geheugen:	64 Mbit
ACPI version:	3.0
Aansluiting voor CPU koeler:	Ja
ATX Power connector (24-pin):	Ja
Aantal SATA-aansluitingen:	6
USB 2.0 aansluitingen:	9
S/PDIF uitgang:	Ja