ECS BAT-I (V1.0) Handleiding

ECS Moederbord BAT-I (V1.0)

Lees hieronder de 📖 handleiding in het Nederlandse voor ECS BAT-I (V1.0) (62 pagina's) in de categorie Moederbord. Deze handleiding was nuttig voor 37 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/62
BAT-I USER MANUAL
i
Preface
Copyright
This publication, including all photographs, illustrations and software, is protected
under international copyright laws, with all rights reserved. Neither this manual, nor
any of the material contained herein, may be reproduced without written consent of
the author.
Version 1.0
Disclaimer
The information in this document is subject to change without notice. The manufac-
turer makes no representations or warranties with respect to the contents hereof
and specifically disclaims any implied warranties of merchantability or fitness for
any particular purpose. The manufacturer reserves the right to revise this publica-
tion and to make changes from time to time in the content hereof without obligation
of the manufacturer to notify any person of such revision or changes.
Trademark Recognition
Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp.
MMX, Pentium, Pentium-II, Pentium-III, Celeron are registered trademarks of Intel
Corporation.
Other product names used in this manual are the properties of their respective owners
and are acknowledged.
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment onto an outlet on a circuit different from that to
which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Shielded interconnect cables and a shielded AC power cable must be employed with
this equipment to ensure compliance with the pertinent RF emission limits govern-
ing this device. Changes or modifications not expressly approved by the system’s
manufacturer could void the users authority to operate the equipment.
BAT-I USER MANUAL
ii
Declaration of Conformity
This device complies with part 15 of the FCC rules. Operation is subject to the follow-
ing conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference
that may cause undesired operation.
Canadian Department of Communications
This class B digital apparatus meets all requirements of the Canadian Interference-
causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du glement
sur le matériel brouilieur du Canada.
The manual consists of the following:
Describes features of the
motherboard.
page 1
Describes installation of
motherboard components.
page 7
page 23
page 51
Installing the Motherboard
Introducing the Motherboard
Provides information on us-
ing the BIOS Setup Utility.
Describes the motherboard
software.
Limits and methods of mesurement of radio disturbance char-
acteristics of information technology equipment
EN 55022
EN 61000-3-2 Disturbances in supply systems caused
EN 61000-3-3 Disturbances in supply systems caused by household appli-
ances and similar electrical equipment Voltage fluctuations
EN 55024 Information technology equipment-Immunity characteristics-
Limits and methods of measurement
EN 60950 Safety for information technology equipment including electri-
cal business equipment
CE marking
About the Manual
This device is in conformity with the following EC/EMC directives:
Chapter 4
Chapter 1
Chapter 2
Chapter 3
Using BIOS
Using the Motherboard Software
Chapter 5
Trouble Shooting
Provides basic trouble shoot-
ing tips.
page 55
BAT-I USER MANUAL
iii
Chapter 2 7
Installing the Motherboard 7
Safety Precautions.............................................................................7
Installing the Motherboard in a Chassis......................................7
Checking Jumper Settings...........................................................8
Installing Hardware..................................................................10
Installing Memory Modules...................................................10
Installing Add-on Cards...........................................................11
Connecting Optional Devices..................................................13
Installing a SATA Hard Drive...................................................18
Connecting Case Components................................................19
TABLE OF CONTENTS
Preface i
Chapter 1 1
Introducing the Motherboard 1
Introduction...................................................................................1
Pakage Contents............................................................................1
Specifications................................................................................2
Motherboard Components..........................................................4
I/O Ports..............................................................................................6
Chapter 3 23
Using BIOS 23
About the Setup Utility........................ .......................................23
The Standard Configuration......................... ...........................23
Entering the Setup Utility........................................................23
Resetting the Default CMOS Values.....................................24
Using BIOS.......................................................................................24
BIOS Navigation Keys..............................................................25
Main Menu.............................................................................26
Advanced Menu......................................................................26
Chipset Menu..........................................................................40
M.I.B III (MB Intelligent BIOS III) Menu..................................42
Security Menu.........................................................................44
Boot Menu..............................................................................47
Exit Menu................................................................................49
Updating the BIOS.........................................................................50


Product specificaties

Merk: ECS
Categorie: Moederbord
Model: BAT-I (V1.0)
Breedte: 170 mm
Diepte: 170 mm
Processormodel: J1800
Grafische adapter: HD Graphics
Ethernet LAN: Ja
Type stroombron: ATX
Aantal USB 2.0-poorten: 4
VGA (D-Sub)poort(en): 1
Aantal HDMI-poorten: 1
Microfoon, line-in ingang: Ja
Aantal Ethernet LAN (RJ-45)-poorten: 1
Certificering: CE/FCC, ErP/EuP, WHQL, WHCK
Meegeleverde software: Norton Internet Security , CyberLink PowerDVD, CyberLink PowerDirector 9
Ondersteunt Windows: Windows 8 Enterprise x64, Windows 8 Pro x64, Windows 8 x64
Aantal poorten USB 3.2 Gen 1 (3.1 Gen 1) Type A: 1
Processor socket: BGA 1170
Processorfabrikant: Intel
Trial-software: Muzee
Maximum intern geheugen: 8 GB
Ingebouwde grafische adapter: Ja
Audio-uitgangskanalen: 5.1 kanalen
Ethernet interface type: Gigabit Ethernet
Geheugen slots type: SO-DIMM
Audiochip: VIA VT1705
Grafische adapter-familie: Intel
Type koeling: Passief
Aantal displays ondersteund: 2
Ondersteunde opslagstationinterfaces: SATA II
PS/2 poort(en): 1
Intel® Virtualization Technology (Intel® VT): VT-x
Component voor: PC
LAN controller: Realtek 8111G
Mini PCI Express slots: 1
DirectX versie: 11
Compatibele processors: Intel® Celeron®
Ondersteunde geheugen types: DDR3-SDRAM
Max. aantal SMP-processoren: 1
PCI Express x1 (Gen 2.x) slots: 1
Moederbord chipset familie: Intel
Moederbord form factor: mini ITX
Aantal geheugenslots: 1
Supported memory clock speeds: 1333,1600 MHz
BIOS type: AMI
Grootte BIOS-geheugen: 64 Mbit
ACPI version: 5.0
Ondersteuning voor parallel processing: Niet ondersteund
Aansluiting voor CPU koeler: Ja
Aansluiting voor ventilator van voeding: Ja
USB 2.0 aansluitingen: 1
Aansluiting voor audiopaneel aan voorzijde: Ja
Aantal SATA II connectors: 2
Serial port headers: 1
Parallele connector: Ja

Heb je hulp nodig?

Als je hulp nodig hebt met ECS BAT-I (V1.0) stel dan hieronder een vraag en andere gebruikers zullen je antwoorden