Eaton Network Card-MS Handleiding

Eaton Netwerkkaart/adapter Network Card-MS

Lees hieronder de 📖 handleiding in het Nederlandse voor Eaton Network Card-MS (89 pagina's) in de categorie Netwerkkaart/adapter. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/89

Eaton® Network Card-MS

User’s Guide

Class B EMC Statements

FCC Part 15 Class B

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

lReorient or relocate the receiving antenna.

lIncrease the separation between the equipment and the receiver.

lConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.

lConsult the dealer or an experienced radio/TV technician for help.

Requesting a Declaration of Conformity

Units that are labeled with a CE mark comply with the following harmonized standards and EU directives:

lSafety for ATI: IEC/EN 60950-1 2002

lEN 61000-6-2 (2002)

EN 61000-6-3 (2002)

IEC/EN 62040-2 (2002).

lEU Directives: 99/336/EEC and 93/68/EEC.

Low voltage: 73/23/EEC and 93/68/EEC.

The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC

Declaration of Conformity, contact:

Eaton Power Quality Oy

Koskelontie 13

FIN-02920 Espoo

Finland

Phone: +358-9-452 661

Fax: +358-9-452 665 68

Eaton is a registered trademark of Eaton Corporation or its subsidiaries and affiliates. Phillips and Pozidriv are a

registered trademarks of Phillips Screw Company. National Electrical Code and NEC are registered trademarks

of National Fire Protection Association, Inc. All other trademarks are properties of their respective companies.

reproduced in any way without the express written approval of Eaton Corporation.

Special Symbols

The following are examples of symbols used on the UPS or accessories to alert you to important information:

RISK OF ELECTRIC SHOCK - Observe the warning associated with the risk

of electric shock symbol.

CAUTION: REFER TO OPERATOR'S MANUAL - Refer to your operator's

manual for additional information, such as important operating and

maintenance instructions.

This symbol indicates that you should not discard the UPS or the UPS

batteries in the trash. This product contains sealed, lead-acid batteries and

must be disposed of properly. For more information, contact your local

recycling/reuse or hazardous waste center.

This symbol indicates that you should not discard waste electrical or

electronic equipment (WEEE) in the trash. For proper disposal, contact your

local recycling/reuse or hazardous waste center.

Product specificaties

Merk:	Eaton
Categorie:	Netwerkkaart/adapter
Model:	Network Card-MS
Connectiviteitstechnologie:	Bedraad
Ethernet LAN:	Ja
Aantal Ethernet LAN (RJ-45)-poorten:	2
Interface:	Ethernet
Intern:	Ja
Ondersteunde netwerkprotocollen:	HTTP, SNMP, SMTP, Telnet, SSL, SSH
Hostinterface:	MiniSlot
Maximale overdrachtssnelheid van gegevens:	- Mbit/s