Eaton ETN-GD428BAS Handleiding

Eaton Niet gecategoriseerd ETN-GD428BAS

Lees hieronder de 📖 handleiding in het Nederlandse voor Eaton ETN-GD428BAS (11 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 128 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/11

Installation guide

RE SERIES ENCLOSURE

Installation guide

TABLE OF CONTENTS

SAFETY WARNINGS ........................................................................................................ 3

600 WIDE EXPLODED VIEW............................................................................................ 4

800 WIDE EXPLODED VIEW............................................................................................ 5

SWITCHING DOOR HANDING ......................................................................................... 6

STABILIZING ..................................................................................................................... 7

BAYING THE ENCLOSURE.............................................................................................. 8

SIDE PANEL ..................................................................................................................... 9

RACK MOUNT ADJUSTMENT ....................................................................................... 10

Installation guide

1. SAFETY WARNINGS

This manual contains important instructions that you should follow during installation and

maintenance of the RE Series Enclosure. Please read all instructions before operating

the equipment and save this manual for future reference.

1. WARNING! RE Series enclosure components can be very heavy. It is recommended

that several people take part in the unpacking process. When lifting heavy

components or electronic equipment, ensure that all safety regulations are observed.

2. WARNING! The enclosure must be stabilized before installing any roll-out type

accessory, component or electronic device. Failure to stabilize prior to installing

equipment may cause the enclosure to tip over.

3. WARNING! First, load the heaviest electronic devices and accessories into the bottom

of the enclosure to prevent the enclosure from becoming top-heavy.

4. WARNING! Never extend more than one roll-out type electronic device or accessory

from a stabilized enclosure at a time. Do not sit, stand, or climb on any extended roll-

out type electronic device or accessory. Never extend a roll-out type electronic device

or accessory component from an enclosure rack that is supported by casters. Doing

so may cause a stabilized enclosure rack to tip over.

5. WARNING! It is the customer’s responsibility to ensure that the floor has a structural

load capacity that will safety bear the weight of the RE series Enclosure and installed

components.

6. WARNING! There must be an uninterruptable safety earth ground from the main

power source to the Power Distribution Unit’s (PDU) power cord set. Whenever it is

likely that ground has been impaired, disconnect the PDU’s power cord until the

ground has been restored.

7. WARNING! High leakage current may be present. Grounding connection essential

before connecting supply.

8. WARNING! Rack is intended to be used with equipment complying with IEC 60950.

Use with non-compliant equipment may result in electrical hazard.

9. WARNING! A grounding kit is pre-installed on RE Series enclosures. The installer is

responsible for grounding the enclosure to the building electrical system. Additional

equipment can be electronically bonded to the rack's frame using additional grounding

points.

Product specificaties

Merk:	Eaton
Categorie:	Niet gecategoriseerd
Model:	ETN-GD428BAS
Kleur van het product:	Zwart
Gewicht:	17300 g
Breedte:	1905 mm
Diepte:	795 mm
Hoogte:	15 mm
Gewicht verpakking:	21240 g
Compatibiliteit:	Eaton RE
Rackcapaciteit:	42U