Dyson CR01 Aqua Handleiding

Bekijk gratis de handleiding van Dyson CR01 Aqua (13 pagina’s), behorend tot de categorie Wasmachine. Deze gids werd als nuttig beoordeeld door 94 mensen en kreeg gemiddeld 4.1 sterren uit 3 reviews. Heb je een vraag over Dyson CR01 Aqua of wil je andere gebruikers van dit product iets vragen? Stel een vraag

DYSON CR01

DRUM BEARING REPAIR

I have written this guide assuming that the reader has no knowledge on how to dismantle

any part of the Dyson CR01. Having never worked on a CR02, I am unaware if the

construction of that model differs greatly.

I have borrowed various images from the net and thank everyone for their contribution.

Read each paragraph twice before starting that phase of dismantling.

Tools required.

a) Set of Torx bits / screwdrivers

b) Large hammer

c) Bolster.

d) Set of metric spanners / sockets

e) Digital Camera. (Always a good idea to photograph in situ before your remove)

1) Disconnect from the water and electricity supply and remove hoses. Drain as much

water from the machine as possible by removing the coin trap cover and putting the drain

pipe as low as possible.

2) Remove the top cover. Remove the two Phillips screws at the rear of the cover and slide

it backwards

3) Remove soap dispenser. The yellow catch at the rear of the dispenser allows it to be

removed.

4) Remove front controls / display.

a)This is held on with two torx screws and when removed should be slid downwards.

This will release the plastic tabs that hold it in place.

b) Disconnect the ribbon cable from where it attached to the machine body.

c)Remove the pressure sensor pipe. This just pulls off.

d) Disconnect the four power cables to the main on / off switch. The position of the

cables should be recorded for reassembly.

The entire control panel assembly should now be free

5) Remove exterior door. This is held in place with spring clips / hinges that are visible. I

found it easy to insert a flat screw driver into the hinge and push down the yellow clip.

6) Remove front panel. This is held in place with 4 torx screws and a number of plastic

tabs. Care should be taking not to break the plastic tabs. 2 screws are clearly visible on

the top of the panel and the other two are recessed into the hinge of the exterior door. If

you have not already removed the coin trap cover then this is the time do it as the front

Product specificaties