Draper Traveller Handleiding

Bekijk gratis de handleiding van Draper Traveller (1 pagina’s), behorend tot de categorie Projectiescherm. Deze gids werd als nuttig beoordeeld door 55 mensen en kreeg gemiddeld 4.0 sterren uit 9 reviews. Heb je een vraag over Draper Traveller of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Operating Instructions

Traveller Portable Projection Screen by Draper

Copyright © 2010 Draper Inc. Form Traveller_Inst10 Print ed in U.S.A.

Setting Up the ScreenCollapsing the Screen

①Generally reverse procedures used for screen setup.

Caution: Do not let go of the screen bail when collapsing the screen;

damage to screen could result. Slowly allow screen to roll into the case.

①Rotate legs (attached to bottom) until they are perpendicular to screen

case (see Fig. 1).

Troubleshooting

Screen will not fully extend:

Make sure the screen surface is not “catching” on anything. Make sure case

lid is fully open. Make sure roller is properly seated.

Screen will not close:

Check roller to make sure nothing is interfering with operation.

Screen tips forward or backward:

Make sure legs are perpendicular to screen case. If they are, screen may be

located on too severe an incline.

Case Latches will not open:

Press gently down on screen case just above each latch while opening.

Case Latches will not close:

Press gently down on screen case just above each latch while closing.

Carrying strap will not rotate out of the way so case will open:

Loosen or remove carrying strap altogether (see below).

Figure 2 (side view)

Caution

①Read instructions through completely before proceeding, and save for

future reference.

②Nothing should be fastened to screen case or viewing surface.

③Do not write on viewing surface.

④Do not let go of the screen handle when collapsing the screen; damage

to the screen could result. Slowly allow the screen to roll into the case.

⑤Do not use solvents or abrasives for cleaning.

⑥Beware of pinching hands and fi ngers when adjusting upright.

NOTE: Screen has been thoroughly inspected and tested at factory and

found to be operating properly prior to shipment.

Figure 3

®

⑤Place upright in upright stand, located inside case and centered on back

of screen. Adjust upright according to necessary screen height (see

Fig. 3).

⑥Grasp screen bail and pull up in steady motion to raise screen. Hook bail

onto upright gooseneck (see Fig. 4). Adjust upright again if necessary.

Figure 4

②Rotate carrying strap so it does not interfere with opening case. You can

also remove the carrying strap by sliding down then off (see Fig. 2).

Figure 1

③Unlatch and open screen case.

④Remove upright from clips in case behind screen.

If you encounter any diffi culties installing or ser vic ing your Traveller, call your

dealer or Draper, Inc., in Spiceland, Indiana, 765/987-7999; or fax 765/987-7142.

A dienceu

Telescoping

Upright

Screen case

Lid

Legs

Case latches

Caution:

Beware of pinching

hands and fi ngers when

adjusting upright.

Caution:

Beware of pinch-

ing hands and

fi ngers when

adjusting upright.

Product specificaties