Draper 90064 Handleiding

Draper Lamp 90064

Lees hieronder de 📖 handleiding in het Nederlandse voor Draper 90064 (2 pagina's) in de categorie Lamp. Deze handleiding was nuttig voor 6 personen en werd door 3.5 gebruikers gemiddeld met 4.8 sterren beoordeeld

Pagina 1/2
Helpline: +44 (0) 23 8049 4344 Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355 Website: drapertools.com Email: sales@drapertools.com
Draper Tools Limited, Hursley Road, Chandler’s Ford, Eastleigh, Hampshire, SO53 1YF, UK 0224
RECHARGEABLE
HEAD TORCH
90064 – INSTRUCTIONS FOR USE
EN
3. Identication and Unpacking
2. Health and Safety Information
operate, maintain or repair this product. Failure to follow these instructions
may result in injury or damage to the user or the product.
• DO NOT turn the light on when it is being charged.
• DO NOT shine the light directly into eyes.
• DO NOT allow children to use the light.
• DO NOT handle or move the light whilst it is being charged.
• DO NOT leave battery in a discharged state, recharge battery immediately.
• If the battery is replaced ensure that it is tted in the correct +/- orientation.
• WARNING! To reduce the risk of burns or re:
– DO NOT crush, puncture, short external contacts or dispose of in re
or water.
– DO NOT expose to temperatures above 50°C.
– DO NOT use this product if the casing or battery is damaged in any way
or if there is evidence of battery leakage.
– Recycle or dispose of used battery as stipulated by local regulation.
1. Product Introduction
1.1 Intended Use
This rechargeable head torch has 4 light settings, an adjustable elasticated
headband and supplied with a Micro USB charging cable.
1. ON/OFF button
2. Light
3. Adjustable head strap
4. USB Charging port cover
5. Battery compartment
6. USB charging cable
Original Instructions
Version 1 – February 2024
Fig. 1
(1)
(5)
(4)
(6)
(4)
(2)
(3)
Important: Before the light can be used open the battery compartment (5)
and remove the clear plastic disc (Refer to 6.2 Replacing the battery).
1. Charge the light before initial use.
2. Lift up the charging port cover (4). Then t the USB charging cable (6)
supplied into the USB charging port and plug into a suitable power output.
3. Charging will take approximately 4hours.
4. The red indicator light will be solid when fully charged.
4. Charging the Light
Helpline: +44 (0) 23 8049 4344 Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355 Website: drapertools.com Email: sales@drapertools.com
Draper Tools Limited, Hursley Road, Chandler’s Ford, Eastleigh, Hampshire, SO53 1YF, UK 0224
5. Operation
Please visit for the latest version of this manual and the associated parts list, if applicable.drapertools.com/manuals
6. Maintenance and Storage
7. Spares, Returns and Disposal
5.1 ON/OFF
Press the button to switch on and keep pressing to cycle through the ON/OFF
settings.
6.1 General Maintenance and storage
• Clean the torch with a damp cloth.
• Store in a dry child proof area.
• Before storage, fully charge the battery, subsequently recharge the battery
at least once every six months of non-use.
6.2 Replacing the Battery
1. If the battery needs replacing, unscrew the battery compartment cover (5).
2. Fit 1 X 3.7V 2200mAh Li-ion battery - ensure that the battery is tted in the
correct +/- orientation.
3. Re-t the battery compartment cover.
8. Warranty
Visit for full details.drapertools.com/warranty
For spare parts, servicing, and repair and replacement options, please contact
the Draper Tools Product Helpline for details of your nearest authorised agent.
Any servicing or repairs carried out by unauthorised personnel or installation
of spare parts not supplied by Draper Tools will invalidate your warranty.
At the end of its working life, dispose of the product responsibly and in line with
local regulations. Recycle where possible.
• DO NOT dispose of this product with domestic waste; most local authorities
provide appropriate recycling facilities.
• DO NOT burn or mutilate batteries; this may release toxic or corrosive
substances.
Press Mode Fast Flashing or SOS/Slow Flashing
X1 On/Low
Whilst a mode is selected press and hold
the ON/OFF button for 2 – 3 seconds.
X 1 – Fast ashing
X 2- SOS/slow ashing
X2 Mid
X3 High
X4 OFF
WEEE –
Waste Electrical & Electronic Equipment
Do not dispose of Waste Electrical & Electronic Equipment
in with domestic rubbish
Do not incinerate or throw onto re


Product specificaties

Merk: Draper
Categorie: Lamp
Model: 90064

Heb je hulp nodig?

Als je hulp nodig hebt met Draper 90064 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden