DNA MIX 4 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor DNA MIX 4 (7 pagina's) in de categorie DJ Gear. Deze handleiding was nuttig voor 4 personen en werd door 2.5 gebruikers gemiddeld met 4.8 sterren beoordeeld
Pagina 1/7
MIX 4 / MIX 4 EQ
User manual
Instrukcja obsługi
ENGLISH
1. Use this balanced XLR jack to connect a microphone to the machine
(applies to channels 1 through 5) The phantom power required for conden-
ser mics can be acvated with switch.
2.PAD
If the [PAD] switch is turned on, set the [LEVEL] 10 knob to “0” (minimum),
and then turn o the switch.
3.HPF
Opening the switch enables a high-pass lter that can aenuate the fre-
quency below 80Hz. When speaking to the microphone, you can open the
switch to minimize the unwanted vibraon and disrupve operaon of the
microphone.
4.The GAIN MIC control determines the channels input gain, both for a mi-
crophone connected via the XLR jack and for other signal sources con-
nected to the 1/4 jack.
5. Use the PAN control to adjust the signal s positon on the stereo ba-
sis.
6. The CHANNEL fader adjusts the volume of the corresponding channel
7. Your machine comes with a 3-band equalizer. the HI control governs
the high frequency range, the MID control can be used to boost/cut the
midrange frequencies, and the LOW control allows you to raise or lower
the gain of the bass range.
8. Use the AUX control to determine the channel volume sent to the
AUX mix bus. When set fully to the le, the channel volume in the AUX mix
is zero.
9. The EFF control adjusts the eects volume for the corresponding
channel.
10.PEAK LED
Lights when the volume of input and/or post-equalizer sound is too high. If
it is lit, turn the [GAIN] 4 knob to the le to lower the volume.
1. Use the TAPE OUT jacks to connect, for example, a tape deck for recording applicaons.
2. The TAPE IN jacks (on stereo RCA) allow for the connecon of play-back devices such as CD,
MIXER, players, etc.
3. These are the two balanced LINE inputs on 1/4 jacks for the le and right sides of the stereo
channels, which can be used in parallel to the microphone inputs.
4. These are the balanced 1/4' jack MAIN OUTPUTS of your machine that can be used to connect,
e.g. a power amplier.
5. The AUX SEND connector provides the monitor signal of your machine, for example, to control a
monitor amplier or acve monitor speaker.
6. Connect the EFF SEND connector to the input of an external eects device.
7. Use the PHONES jack to connect a commercially available pair of headphones.
8. USB INPUT (Use this input for connect your devices).
9. DISPLAY
10. Press this buon to loop the song.
11. Using buon, press one song at a me to lower the volume for more than a few seconds.
12. Using buon, press one song at a me to raise the volume in more than a few seconds.
13. Use buons to control player playback or pause.
Note: the signal of MP3 player is controlled by stereo channel 3 and 4.
Product specificaties
| Merk: | DNA |
| Categorie: | DJ Gear |
| Model: | MIX 4 |
Heb je hulp nodig?
Als je hulp nodig hebt met DNA MIX 4 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding DJ Gear DNA
20 Mei 2025
20 Mei 2025
Handleiding DJ Gear
- DJ Gear Headliner
- DJ Gear Dual
- DJ Gear IConnectivity
- DJ Gear Korg
- DJ Gear Kenwood
- DJ Gear Chauvet
- DJ Gear Pyle
- DJ Gear Music Hall
- DJ Gear Behringer
- DJ Gear Cambridge
- DJ Gear Zoom
- DJ Gear Ecler
- DJ Gear Audient
- DJ Gear Reloop
- DJ Gear Suonobuono
Nieuwste handleidingen voor DJ Gear
10 Juni 2025
3 Juni 2025
28 April 2025
28 April 2025
14 Maart 2025
4 Maart 2025
3 Maart 2025
7 Februari 2025
7 Februari 2025
30 Januari 2025