Ditek DTK-GLI Handleiding
Pagina's 1 Engels Niet gecategoriseerd
Bekijk de handleiding van Ditek DTK-GLI gratis online of download de PDF. 103 mensen vonden deze handleiding nuttig. Vraag over dit model? Stel een vraag
Doc # INT-100151-001
Part No. 191576 Rev. 1
INSTALL INSTRUCTIONS
DTK-GLI
DITEK Technical Support Available 24/7
1-888-472-6100
www.ditekcorp.com
DITEKCorporation
ONE DITEK CENTER
1720 Starkey Road
Largo, FL 33771
INSTALLATION
This is a high performance device, designed to provide protection
from video signal distortion caused by video ground loops.
Please read and follow the installation instructions carefully.
NOTICE: This SPD should be installed by a qualied electrician in accordance with the National
and Local Electrical Codes and the following instructions.
APPLICATION
Ground Loop Isolator for use on analog CCTV systems experiencing video distortion.
INSTRUCTIONS:
Caution: This unit must be connected in series with the equipment to be protected.
Improper installation voids the warranty.
1. Connect the incoming coaxial feed normally intended for the Input side of the “Head End” equipment.
Such as the multiplexer, switcher, DVR, and monitor. To the “Input” side of the DTK-GLI.
2. Connect a 3’ BNC patch cable from the DTK-GLI “Output” to the Input side of the “Head End” equipment.
3. For mounting, use double sided tape (supplied), or two (2) #8 screws (not supplied).
Note: The DTK-GLI does not provide any surge protection and is vulnerable to the same path of surge as
your CCTV components. We recommend using the DTK-PVP27B (xed analog cameras) or the DTK-DP4P
(PTZ analog cameras) installed using a 3’ BNC patch cable from the DTK-PVP27B or DTK-DP4P Output
to the DTK-GLI Input.
Drawn By: R. Mitchell 7-3-13
Approved By: J. Ramirez 7-3-13
DTK-GLI
3’ BNC Patch Cord
Camera
Camera Output
Input
Output
DTK-GLI
3’ BNC Patch Cords
Camera
Camera Output
Input
Output
GND
VIDEO
DTK-DP4P
OUTIN
5V DATA
5V DATA
5V DATA
5V DATA
12/24V PWR
12/24V PWR
Input
Output
DTK-DP4P
Product specificaties
| Merk: | Ditek |
| Categorie: | Niet gecategoriseerd |
| Model: | DTK-GLI |
| Kleur van het product: | Zwart |
| Gewicht: | 113 g |
| Breedte: | 76.2 mm |
| Hoogte: | 33.02 mm |
| Aantal: | 1 |
| Frequentiebereik: | - Hz |
| Synchronisatie ingangsimpedantie: | 75 Ohm |
| Output impedance: | - Ohm |
| Verlies van insertion: | 1.1 dB |
Heb je hulp nodig?
Als je hulp nodig hebt met Ditek DTK-GLI stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Niet gecategoriseerd Ditek
Ditek DTK-HVACKIT Handleiding Ditek DTK-DR120P1 Handleiding Ditek DTK-MB10 Handleiding Ditek D50-CM Handleiding Ditek DTK-2MB Handleiding Ditek DTK-DF120S1 Handleiding