Daytronic IL70A Handleiding
Pagina's 14 Niet gecategoriseerd
Bekijk de handleiding van Daytronic IL70A gratis online of download de PDF. 9 mensen vonden deze handleiding nuttig. Vraag over dit model? Stel een vraag
The Model IL70Ais a single-channel instrument which is easily configured, rugged, analog based
signal conditioner made to operate with traditional Wheatstone mv/Vstain gage bridge sensors
used to measure force, pressure, torque and other DC strain gage related measurements. The Model
IL70A has an extremely wide DC power input rangewith user selectable gain, zero and anaolg output
making it adaptable to any users sensor application that requires stable, repeatable and noise free
analog signals for control or data acquisition.
1GENERALDESCRIPTIONANDSPECIFICATIONS
IN-LINE DC Strain Gage Conditioner
MODELIL70A
DC Strain Gage
C
ONDITIONERModule
IL70A
GENERAL DESCRIPTION ANDSPECIFICATIONS
IL70A.1
Top View of the Model IL70A DC Strain Gage Module (cover removed)
DC Strain Gage Symmetry Operation:
For applications requiring precision in both tension and compression (CW & CCW for
torque cells), the IL70A contains a symmetry adjustment which corrects for negative span or slope of the transducer.
The Model IL70A is best calibrated by means of a “two-point (dead-weight)” or shunt-calibration
technique, which is outlined in section three. The supplied calibration resistor is 59 kilohms,1%
which islocated internally to the IL70Apcb circuit.
ShuntOperation:Located between the two screw terminal connectors, t
he IL70A contains a Shunt resistor jumper
selection. "EXT" is for an external - user installed shunt or "INT" for the internal - built in - 59K Ohm shunt. Installing the jumper
enables the selected feature. For an external shunt resistor, install the leaded resistor between the "Cal Sense" (pin 7) terminal
and either the + Signal (pin 5) or the - Signal (pin 6) terminals. Use the SW4 "Shunt" button to engage the shunt resistor across
the selected side of the bridge or "SHP or "SHN" logic input lines. For transducers with an installed shunt resistor, place the
jumper on the "EXT" teminals and wire the "Cal Sense" line to the transducer's shunt connector pin.
92375.00 rev. B
Product specificaties
| Merk: | Daytronic |
| Categorie: | Niet gecategoriseerd |
| Model: | IL70A |
Heb je hulp nodig?
Als je hulp nodig hebt met Daytronic IL70A stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Niet gecategoriseerd Daytronic
Daytronic AA30-4F1 Handleiding Daytronic 10A40 Handleiding Daytronic 10A15-8 Handleiding Daytronic AA72-4F1 Handleiding Daytronic 10ACC-4 Handleiding Daytronic IL40A Handleiding Daytronic 5D78V Handleiding Daytronic SPS6116D-CE Handleiding