DataComm 45-0072-WH Handleiding

Bekijk gratis de handleiding van DataComm 45-0072-WH (3 pagina’s), behorend tot de categorie Kabels voor pc's en randapparatuur. Deze gids werd als nuttig beoordeeld door 30 mensen en kreeg gemiddeld 4.4 sterren uit 7 reviews. Heb je een vraag over DataComm 45-0072-WH of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Use DataComm Electronics’ Recessed Low Voltage Mid-Size Plate with Duplex Surge Supp to w d your flat panel TV, ressorinstalllovoltagecablesbehin

your amplifier or other audio and video devices. This midize plate can be inalled uprigh sideways. -sstt,

Features of the 45-0081 Recessed Low Voltage Mid-Size Plate with Duplex Surge Suppressor include:

Compa size fi behind all and large ’s cttssmTV

TV re y wa plugcessescompletelintothell

Duplex receptacle for additional devices

IMPINSTRUCTIONSORTANT :

This product is designed for retrofit work only because the electrical outlet x cannot be attached to a stud. bo

This product is designed to alert you if you ever lose surge protection. The Surge Suppressor Receptacle is designed to provide protection against short-

term over-voltage conditions as well as from RFI adio frequency interference). The Surge Suppressor cannot survive, or provide protection in the rare (r

event of a dire lightning strike on the service power line.ct

The Surge Suppressor alerts you to the failure of the surge protection component by means of

an audible signal. alarm sounds, device has “received” power surges in exce of y on as a surge protector. To shut Ifssitscapacitandisnolongerfunctiing

off alarm, simply turn the “Alarm Off” screw on theront of the receptacle clockwise. Note: When alarm sounds and the “Alarm Off” scr is turn off, the few

receptaclestillnctionsasnormalduple fu a x receptacle without surge protection.

WARNING:

Before you run your 12/2 or 14/2 w/ground UL approved building wire to the Recessed Low Voltage Mid-Size Plate with Duplex Surge

Suppressor, be sure the power is off by switching the circuit breaker to off or removing the fuse(s). Test the power to make sure the power is

off. Be sure to install the Mid-Size Plate with Duplex Surge Spressor in accordance with the National Electrical Code (NEC) and local codes. up

Installation Instructions:

DataCElecticIncomm rons, .

63achteeee49 Per Strt

Norcro, G 30-15 ssA 07172

8883.97.2277

7702.20.6685

wwwmlectronim.datacomecs.co

Inllion structstaion / InatSheet

DataComm Electronics 45-0081 Recessed Low Voltage Mid-Size Plate with Duplex Surge Suppressor

Parts Included:

1. 45-0081 Recessed Low Voltage Mid-Size Plate

2.ElectricalOutletBox

3. 15 Amp/125 Volt Duplex Surge Suppressor

4. Four (4) Screws

Tools Neede d:

1. Drywall Saw

2. 6 Ft. Tape Measure

3. Pencil

4. Screwdrer iv

Figure 1 – Front View

Figure 2 – Back View

Fig. 1

Fig. 2

Figure 1

Top view - shows needed space between the drywall and the studs.

Receptacle side of the Midize Plate should be 3” from the stud but no -S

more than 5” (review picture carefully).

Figure 2

Using the template supplied (see page 3 of instruction sheet), trace the opening needed. Using a drywall saw,

cut a hole in the drywall the size of the template. before tracing your opening. See Figure 1Remember, the

plates are designed to be mounted between the studs.

Page 1 of 3 10/1/12

Concealed Wiring

(hidden in wall)

Flat Screen TV

Concealed Wiring

(hidden in wall)

Flat Screen TV

Product specificaties