Danby Designer DUF808BSL Handleiding

Danby Vriezer Designer DUF808BSL

Lees hieronder de 📖 handleiding in het Nederlandse voor Danby Designer DUF808BSL (14 pagina's) in de categorie Vriezer. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/14
Owners Use and Care Guide
Guide d’utilisation et soins de Propriètaire
Guía utilice y cuide del Proprietario
Model Modèle Modelo
DUF808BSLE
Danby Products Limited, PO Box 1778, Ontario, Canada N1H 6Z9
Danby Products Inc., PO Box 669, Findlay, Ohio, USA 45839-0669
V 1.07.09 JF
CAUTION: Read
and follow all safety
rules and operating
instructions before
first use of this
product.
PRECAUTION:
Veuillez lire
attentivement les
consignes de sécurité
et les instructions
d’utilisation avant
l’utilisation initiale
de ce produit.
PRECAUCION:
Lea y observe todas
las reglas de
seguridad y las
instrucciones de
operación antes de
usar este producto
por primera vez.
UPRIGHT FREEZER
Owner’s Use and Care Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 5
Important Safety Information
Installation Instructions
Features
Operating Instructions
Care and Maintenance
• Troubleshooting
• Warranty
CONGÉLATEUR VERTICAL
Guide d’utilisation et soins de Propriètaire . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 10
Information de Sécurité Importante
Consignes d’installation
Caractéristiques
Consignes d’utilisation
Soins et Entretien
Dépannage
Garantie
CONGELADOR VERTICAL
Guía utilice y cuide del Propietario . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 - 15
Información Importante de Seguridad
Instrucciones de Instalación
Caracteristicas
Instrucciones Operadoras
Cuidado y Maintenimiento
Solución Sugerida
Garantía
Remove exterior and interior packings, wipe the
outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth. Avoid placing the
cabinet in a narrow recess or near any heat source,
direct sunlight, or moisture. Let air circulate freely
around the cabinet. Keep the rear of the freezer 5
inches away from the wall.
Location:
1) Select a place with a strong, level floor.
2) Allow 5 inches of space between the back of the
freezer and any adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight
may affect the acrylic coating. Heat sources nearby
will cause higher electricity consumption.
4) Avoid very moist places. Too much moisture in
the air will cause frost to form very quickly on the
evaporator, and your freezer will have to be defrosted
more frequently.
IMPORTANT SAFETY INFORMATION
GROUNDING
INSTRUCTIONS
1
This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must
be connected to an outlet that is properly installed and
grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician of serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the appliance is properly grounded.
DO NOT USE AN EXTENSION CORD.
Use an exclusive wall outlet; Do not connect your
freezer to extension cords, or together with any other
appliance in the same wall outlet. Do not splice the
cord.
IMPORTANT WARNING: An empty freezer is a
very dangerous attraction to children. Remove either
the gasket, latches, lids, or doors from unused
appliances, or take some other action that will
gaurantee it harmless.
DON’T WAIT! DO IT NOW!
This appliance must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electrical shock by providing an escape wire for the electrical current.
INSTALLATION INSTRUCTIONS
FEATURES
1) THERMOSTAT DIAL: For controlling the temperature
inside the freezer. Turns the motor on as soon as the
temperature rises above the desired level.
2) REFRIGERATED SHELVES:3 full width refrigerated
shelves.
3) MAGNETIC GASKET: Tight fitting door seal keeps all
the cooling power locked inside. No hooks or latches.
4) DOOR BINS (4)
5) DRIP TRAY
1
3
4
2
5
DOOR REVERSAL
INSTRUCTIONS
1) To access the lower hinge
assembly, tilt back the freezer
cabinet or lay the freezer on its
back. (Fig.A)
2) Remove both leveling legs
located at the front of the
cabinet.
3) Remove the screws holding
the lower hinge assembly to the
cabinet.
4) Remove the main door
assembly from the freezer
cabinet (lift door slightly and
pull downward).
5) Using a flat head
screwdriver, remove the main
door top hinge pin.(Fig.B)
6) Re-install the main door top
hinge pin on the opposite side of
the cabinet.
7a) Remove the door plug and
door bushing located on the top
of the main door.
7b) Interchange their positions
(eg.door plug right side, door
bushing left side).
8) Re-install main door
assembly on cabinet.
9) Remove door bushing
(bottom door) and install on
opposite side.
10) Re-install the lower hinge
assembly on the opposite side.
11) Make sure the door
assembly is properly aligned on
the cabinet before tightening
lower hinge screws.
12) Re-install both leveling legs.
The process is now complete.
Fig. A
Fig. B
2
CAUTION: To avoid personal injury to yourself and/or property, we recommend
someone assist you during the door reversal process.
OPERATION
To start the freezer, turn the temperature control to the position corresponding to the
desired cooling.
0 = No Cooling 1= Minimum Cooling
3, 4 = Medium Cooling MAX= Maximum Cooling
The freezer temperature will vary depending on the quantity of the food stored and
on the frequency with which the door is opened.
DEFROSTING
INSTRUCTIONS
IMPORTANT: Do not use an ice pick, knife or other
sharp-pointed tool to defrost freezer. Damage can
occur.
1) Turn temperature control to ‘0’(off) and unplug
power cord.
2) Remove all frozen food.Wrap frozen food in
several layers of newspaper and cover with a blanket.
Food will say frozen for several hours OR store
frozen food in a cooler, additional refrigerator-freezer
or in a cool area.
3) Place pans of hot water in freezer with door open
to speed melting. Directing air from an electric fan
into freezer will also help. Do not place fan in freezer.
4) Remove frost.
5) Wipe water from walls and bottom of freezer with
a towel or sponge.
6) Wash inside walls.
7) Rinse and dry thoroughly.
8) Replace all frozen food.
9) Plug in power cord and refer to “Operation.”
OPERATING INSTRUCTIONS
Defrost and clean your freezer when frost has built up to about 1 1/4”(6mm) thickness.
Complete defrosting and cleaning should be done at least once a year. In high humidity
areas, a freezer may need more frequent defrosting and cleaning.
To avoid vibration, the cabinet must be set level.This is accomplished by adjusting the (2)
front leveling legs located under the freezer cabinet.


Product specificaties

Merk: Danby
Categorie: Vriezer
Model: Designer DUF808BSL

Heb je hulp nodig?

Als je hulp nodig hebt met Danby Designer DUF808BSL stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vriezer Danby

Handleiding Vriezer

Nieuwste handleidingen voor Vriezer