Danby DDW1802 Handleiding

Danby Vaatwasser DDW1802

Lees hieronder de 📖 handleiding in het Nederlandse voor Danby DDW1802 (41 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/41
OWNER’S USE AND CARE GUIDE
GUIDE D’UTILISATION ET D'ENTRETIEN
MODEL • MODÈLE
DANBY PRODUCTS LIMITED, ONTARIO, CANADA N1H 6Z9
DANBY PRODUCTS INC., FINDLAY, OHIO, USA 45840
DDW1801MW / DDW1802EBLS
Dishwasher Installation
Instructions
Instructions d’installation
lave-vaisselle
2016.02.25
CONTENTS
TABLE DES MATIÈRES
BUILT IN DISHWASHER
Installation Instructions ...............................................1-19
• Dishwasher Safety
• Installation Requirements
• Installation instructions
LAVE-VAISSELLE ENCASTRÉ
Instructions d’installation...........................................20-38
• Sécurité de lave-vaisselle
• Exigences d’installation
• Instructions d’installation
CAUTION:
Read and follow all safety rules and operating
instructions before  rst use of this product.
PRÉCAUTION :
Veuillez lire attentivement les consignes de
sécurité et les instructions d’utilisation avant
l’utilisation initiale de ce produit.
WARNING:
Tip Over Hazard
• Do not use dishwasher until completely installed.
• Do not push down on open door.
• Doing so can result in serious injury or cuts.
DISHWASHER SAFETY
Safety Tips:
• Slowly open dishwasher door while someone grasps the rear of the dishwasher. Remove shipping materials, drain
hose and lower rack. Close dishwasher door until latched.
• Observe all governing codes and ordinances.
• Install this dishwasher as specifi ed in these instructions.
• Installation should be performed by a qualifi ed service technician. The dishwasher must be installed to meet all electri-
cal and plumbing national and local codes and ordinances.
INSTALLATION REQUIREMENTS
Tools and Parts:
Gather the required tools and parts before starting installation.
Tools Needed for All Installations Parts Needed for All Installations
• Phillips screwdriver • 90° elbow with 3/8” N.P.T. external threads on one
end. (The other end must  t your water supply line).
• Flat - blade screwdriver • Thread seal tape
• 5/16" and 1/4" nut drivers • 3 UL listed wire nuts
• Measuring tape or ruler • One 1-1/2”-2” screw type clamp
• 6" adjustable wrench
• Small level Parts Needed for New Installations
• Flashlight • Copper tubing (3/8” recommended)
• Shallow pan • Clamp connector to fi t a 7/8” (22.2 cm) diameter hole
• One 1-1/2” -2” screw type clamp if connecting to
waste-tee
Tools Needed for New Installations
• Electric drill with 1/2”, 3/4” and 1-1/2” hole saw bits
• Small tube cutter
Parts Supplied:
A. 2 – # 8 x 5/8” Phillips fl at head wood screws
B. 4 – Phillips head, color matched toekick screws
Make sure these parts are included.
See separate parts list for accessories available for your dishwasher. AB
1


Product specificaties

Merk: Danby
Categorie: Vaatwasser
Model: DDW1802

Heb je hulp nodig?

Als je hulp nodig hebt met Danby DDW1802 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vaatwasser Danby

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser