Da-Lite Tensioned Professional Electrol Handleiding

Da-Lite Projectiescherm Tensioned Professional Electrol

Bekijk gratis de handleiding van Da-Lite Tensioned Professional Electrol (12 pagina’s), behorend tot de categorie Projectiescherm. Deze gids werd als nuttig beoordeeld door 59 mensen en kreeg gemiddeld 4.3 sterren uit 30 reviews. Heb je een vraag over Da-Lite Tensioned Professional Electrol of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Download PDF

Pagina 1/12

INSTRUCTION BOOK FOR

Tensioned Professional Electrol®

Important Safety Instructions

When using your video equipment, basic safety precautions

should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or

contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating

at least equal to that of the appliance should be used. Cords

rated for less amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric

shock when the appliance is used subsequently.

5. The use of an accessory attachment not recommended by

the manufacturer may cause a risk of ire, electric shock, or

injury to persons.

6. Failure to provide adequate structural strength for this

component can result in serious personal injury or damage

to equipment! It is the installer’s responsibility to make sure

the structure to which this component is attached can

support the weight of all equipment. Reinforce the structure

as required before installing the component.

7. Use this projection screen only for its intended use as

described in these instructions. Do not use attachments not

recommended by the manufacturer.

Save These Instructions

Pre-Installation

1. Carefully unpack screen.

2. Make sure to recheck measurements of screen location

before installation.

3. Remove instruction cover plate (Fig. 1). Do not remove

wrapping paper until screen is installed.

4. Remove the retainer screws from the slat bar before the

case has been installed (Fig. 2).

Figure 2

Slat Retainer Bracket

(3 Screws)

1 On Bottom of Slat

2 On Inside of Case

Figure 1

Instruction Cover

Case

Original Instructions

Disclaimer

Milestone and its ailiated corporations and subsidiaries

(collectively "Milestone"), intend to make this manual accurate

and complete. However, Milestone makes no claim that the

information contained herein covers all details, conditions or

variations, nor does it provide for every possible contingency in

connection with the installation or use of this subject to change

without notice or obligation of any kind. Milestone makes no

representation of warranty, expressed or implied, regarding the

information contained herein. Milestone assumes no

responsibility for accuracy, completeness or suiciency of the

information contained in this document.

Da-Lite® is a registered trademark of Milestone AV Technologies.

Hangers (If required)

1. See Figure 3 for hanger placement.

2. Make sure hangers are placed to it into notches of

ironing board..

Installation

⁄

Screens Over 22' Wide

Figure 3

⁄

Screens 22' Wide And Under

Case Length ÷ 2

(Case Length – 23") ÷ 3

Product specificaties

Merk:	Da-Lite
Categorie:	Projectiescherm
Model:	Tensioned Professional Electrol
Kleur van het product:	Wit
Gewicht:	- g
Oorspronkelijke beeldverhouding:	16:9
Diagonaal:	220 "
Totale grootte van het scherm (hoogte x breedte):	274 x 488 cm
Formaat:	HDTV
Schermgain:	1
Case L1:	547 mm