CyberPower OR2200PFCRT2U Handleiding

CyberPower UPS OR2200PFCRT2U

Lees hieronder de 📖 handleiding in het Nederlandse voor CyberPower OR2200PFCRT2U (20 pagina's) in de categorie UPS. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/20

USER’S MANUAL

PFC SINEWAVE SERIES

OR1000PFCRT2U/OR1500PFCRT2U/

OR2200PFCRT2U

K01-00004 -02 88

This manual contains important instructions. Please read and follow all instructions carefully during

installation and operation of the unit. Read this manual thoroughly before attempting to unpack, install, or

operate the UPS.

CAUTION! To prevent the risk of re or electric shock, install in a temperature and humidity controlled

indoor area free of conductive contaminants. (Please see specications for acceptable temperature and

humidity range).

CAUTION! For pluggable equipment, the socket-outlet shall be installed near the equipment and shall

be easily accessible.

CAUTION! To reduce the risk of electric shock, do not remove the cover except to service the battery.

Ensure the input power is removed before servicing the batteries. There are no user serviceable parts

inside except for the battery.

CAUTION! Hazardous live parts inside can be energized by the battery even when the AC input power

is disconnected.

CAUTION! The UPS must be connected to an AC power outlet with fuse or circuit breaker protection.

Do not plug into an outlet that is not grounded. If you need to de-energize this equipment, turn o and

unplug the unit.

CAUTION! To avoid electric shock, turn off the unit and unplug it from the AC power source before

servicing the battery or installing a computer component.

CAUTION! To reduce the risk of re, connect only to a circuit provided with 20 amperes maximum

branch circuit over current protection in accordance with the National Electric Code, ANSI/NFPA 70.

CAUTION! The UPS is suitable for use in a computer room as dened in the Standard for the Protection

of Electronic Computer/Data Processing Equipment, ANSI/NFPA 75.

CAUTION! The EPO function is provided in UPS. EPO remote switch which is Push-Back button is

installed computer room outside by a phone line and not connected any other equipment.

CAUTION! DO NOT USE FOR MEDICAL OR LIFE SUPPORT EQUIPMENT! Under no circumstances

this unit should be used for medical applications involving life support equipment and/or patient care.

CAUTION! DO NOT USE WITH OR NEAR AQUARIUMS! To reduce the risk of re, do not use with or

near aquariums. Condensation from the aqua um can come in contact with metal electrical contacts and ri

cause the machine to short out.

CAUTION! DO NOT USE WITH LASER PRINTERS! The power demands of laser printers are too large

for a UPS.

CAUTION! DO NOT INSTALL THE UPS WHERE IT WOULD BE EXPOSED TO DIRECT SUNLIGHT

OR NEAR A STRONG HEAT SOURCE!

CAUTION! DO NOT BLOCK OFF VENTILATION OPENINGS AROUND THE HOUSING!

CAUTION! DO NOT CONNECT DOMESTIC APPLIANCES SUCH AS HAIR DRYERS TO UPS

OUTPUT SOCKETS.

IMPORTANT SAFETY INSTRUCTIONS

UNPACKING

The box should contain the following:

(a) UPS unit x1; (b) User manual x1; (c) USB A+B type cable x1; (d) Rackmount bracket x2 (e) Vertical ;

stand x2; (f) Warranty registration card x1

AUTOMATIC VOLTAGE REGULATOR(AVR)

The OR1000PFCRT2U/OR1500PFCRT2U/OR2200PFCRT2U can stabilize inconsistent utility power.

Incoming utility power uctuations may be damaging to important data and hardware but Automatic

Voltage Regulation (AVR) helps protect the computer against experiencing dangerous voltage levels. AVR

automatically adjusts low or high voltages to keep equipment working at safe AC power levels (110/120V)

without switching to battery. Your equipment can operate normally even during the power problems such

as brownouts and blackouts. The unit’s powerful sealed lead-acid batteries will provide power only if the

incoming voltage drops below 90V or increases above 0V. 14

SYSTEM BLOCK DIAGRAM

HARDWARE INSTALLATION GUIDE

1. Battery charge loss may occur during shipping and storage. The rst time the UPS is used, it is

strongly recommended to charge batteries for at least 18 hours ensure that the batteries are at the to

their maximum charge capacity. To recharge the batteries, simply plug the UPS into an AC outlet the ,

batteries will charge whether the UPS is powered on or not.

2. With the UPS o and unplugged, connect your computer, monitor, and any externally powered data

storage device (Hard drive, Tape drive, etc.) into the outlets. DO NOT plug a laser printer, copier,

space heater, vacuum, paper shredder or other large electrical device into the UPS. The power

demands of these devices will overload and possibly damage the unit.

3. To protect a fax, telephone, modem line or network cable, connect the telephone or network cable

from the wall jack outlet to the jack marked “IN” on the UPS. Then, connect a telephone cable or

network cable from the jack marked “OUT” on the UPS to the modem, computer, telephone, fax

machine, or network device.

4. Plug the UPS into a 2 pole, 3 wire grounded receptacle (wall outlet). Make sure the wall branch outlet

is protected by a fuse or circuit breaker and does not service equipment with large electrical demands

(e.g. air conditioner, copier, etc). The warranty prohibits the use of extension cords, outlet strips, and

surge strips.

INSTALLING YOUR UPS SYSTEM

Product specificaties

Merk:	CyberPower
Categorie:	UPS
Model:	OR2200PFCRT2U
Kleur van het product:	Zwart
Gewicht:	26988.7 g
Breedte:	431.8 mm
Diepte:	388.62 mm
Hoogte:	88.9 mm
Snoerlengte:	3 m
LED-indicatoren:	Ja
Vormfactor:	Rackmontage/toren
Aantal USB 2.0-poorten:	1
RS-232 port:	2
Geluidsalarm(en):	Ja
Responstijd:	4 ms
Duurzaamheidscertificaten:	RoHS
Uitgangsvermogen:	1320 W
Accu/Batterij oplaadtijd:	8 uur
Stroomspanning bescherming:	Overbelasting
Frequentie:	- Hz
Overbelastingsprotectie:	Ja
Modem (RJ-11) poort:	2
Beheerplatform:	SNMP, HTTP
Rackcapaciteit:	2U
Batterijtechnologie:	Sealed Lead Acid (VRLA)
Type beeldscherm:	LCD
Type batterij:	12 V, 9 Ah
Surge energy rating:	2060 J
Aantal AC uitgangen:	8 AC-uitgang(en)
Nominale input voltage:	90-140 V
Stopcontacttypes:	NEMA 5–20R
Output power capacity:	2 kVA
Typische backup tijd op halve lading:	20 min
Typische backup tijd op volledige lading:	8 min
Hot-swap batterij:	Ja
Netspanning, in bedrijf:	120 V
EMI/RFI geluidsfiltering:	Ja