CTA Digital PAD-PARACGS Handleiding

Bekijk gratis de handleiding van CTA Digital PAD-PARACGS (1 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 5 mensen. Heb je een vraag over CTA Digital PAD-PARACGS of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Compact Mobile Floor Stand with

Universal Security Enclosure (Black)

USER MANUAL

PAD-PARACGS

METAL CONNECTION

HEIGHT

ADJUSTMENT

KNOB

POLE

METAL CROSS

BASE X 2

CONNECTION SCREW BOLT,

WASHERS AND NUT

Pole Assembly and Pole Nut

Cross Base Sections (2)

Allen Key

1) Place the metal base pieces with the higher

piece on top of the cross base. Align the holes

at the bottom of the pole with the holes on the

cross base.

2) Insert a screw bolt with a washer into each

of 4 holes. Place another washer on the

underside of each screw bolts.

3) Grip the nut on the underside with one hand,

and use the other to tighten each screw with

the Allen key. Repeat to tighten all four

screw bolts.

1. Base, Wheel Assembly and Connecting the Metal Cover:

x4

x1

x1

x1

x1

x2

x1

x1

x4

Screw in ADD-POLE to the main body component.

2. VESA Pole Assembly to Base:

4. Cable Routing/Cable Management:

3. Mounting Item to VESA plate:

Combine nuts and bolts through VESA plate from the front & back as

shown with provided tools.

Route the cable through the hole at the top of the body and out

the bottom.

Contents:

Instructions:

4) Rotate the grip counter

clockwise to loosen completely

and remove from top of pole.

(Shown Above)

5) Place the square metal cover over the top of the pole and

slide down to stand base. (Shown Above)

6) Place grip back over stand

pole and tighten (Shown Above)

888-733-4448

888-733-4448

Wheel

Spring

Washer

Metal

Base

x4

7) Place spring washer over

the screw bolt on wheel

8) Place the screw bolt from each wheel through the metal

base. Then place nut cover over the top of each. Screw down

clockwise by hand, then use wrench to tighten

9) Unscrew butterfly bolt

completely (red) before adding

on gooseneck component (blue)

x1

1 - Unlock the tablet enclosure by rotating the

key until it pops open

2 - Find the appropriate size included foam padding

for the tablet you wish to use. Make sure device is

compatible for the enclosure

3- Lay your device in and connect any cables or

cords you may have

4 - If needed, make sure to lay-in the correct masking

cover. Then close and lock the enclosure and you’re

ready to go.

Setting up Enclosure and Tablet

Product specificaties