Clas Ohlson 34-7357 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Clas Ohlson 34-7357 (8 pagina's) in de categorie Stappentellers. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
GREAT BRITAIN
For consumer contact, please visit www.clasohlson.co.uk and click on customer service.
ENGLISH
Step Counter Art. Nr 34-7357
Please read the entire instruction manual before using and save it for future use.
Step counter’s buttons
S1 – Mode/UP
S2 - Down
S3 - Clear
S4 - Set
Use
Step counting
1. Push until “STEP” shows on display.MODE/UP
2. The display now shows the total amount of steps.
3. Push and hold in to programme the length unit. SET
4. Use and to change between Km or Miles. Push to MODE/UP DOWN SET
conïŹrm.
5. Push to reset the counter in the display.CLEAR
Distance counter
1. Push to walk with distance counter. “KM” or “MILE” is shown on MODE/UP
the display.
2. Push to choose ”KM” or MILE”.DOWN
3. The distance counter is reset to zero at the same time as the step counter.
Set the stride length
1. Push MODE/UP until the distance counter (the distance you have walked
in km or miles) is shown on the display.
2. Push and hold in SET for 2 seconds. The length of strides blink in the display.
3. Use and to set the stride length (your length of strides).MODE/UP DOWN
4. Push to conïŹrm.SET
Calorie counter
1. Push MODE/UP to walk with distance counter. “KCAL” is shown on the display.
2. Push and hold in for approx. 2 secs to indicate your weight. Set weight SET
blinks in display.
3. Use and to set the weight.MODE/UP DOWN
4. Push to conïŹrm.SET
Use stopwatch
1. Push to activate the stopwatch.MODE/UP
2. Push to start or stop the timer.DOWN
3. When the timer is stopped, push to reset the timer. SET
‱ For time intervals, push once on while the timer is in progress. The SET
display stops and shows the time interval. The timer continues in the
background.
‱ Push again to resume the time keeping.SET
Use assault alarm
Activate: Pull out the alarm pin from the back of the step counter to activate the
assault alarm.
Shut off: Replace the alarm pin to shut off the alarm.
Open the battery cover
‱ Take away the battery cover by
unscrewing the screws and then pushing
the battery cover backwards according to
the picture.
Adjust the step counter’s sensitivity
1. Remove the battery cover.
2. Change the step counter’s sensitivity by
pushing the control laterally. Try it out by
ïŹnding the correct position.
‱ Example: Walking 100 steps. If the step
counter shows more than 100 steps
adjust your sensitivity downward.
If the step counter shows less than 100
steps adjust your sensitivity upward.
Change of battery
1. Remove the battery cover.
2. Lift out the batteries with the help of a
small screwdriver and replace them with
new ones. Be careful to put the battery
in with correct polarity according to the
picture.
Disposal
Follow local ordnances when disposing this product. If you are unsure about how
to dispose this product contact your municipality
SpeciïŹcations
Battery type : 1x SR54 (included)
Battery, assault alarm: 2x CR2016 (included)
Step counter: Up to 99 999 steps
Calorie counter: Up to 9999.9 kcal
Distance: Up to 9999.9 km/mile
Preparations
Step counter’s menus
Push to choose function in following order:MODE/UP
TMR (clock) -> ALM (alarm) -> STEP (step counting) -> KM (distance) ->
KCAL (calorie measurement) -> STW (stopwatch)
Set time
1. Push until “TMR” is shown on display.MODE/UP
2. Push and hold for approx. 2 secs to walk in setting position.SET
3. Use and to change the hours. ConïŹrm with .MODE/UP DOWN SET
4. Use and to change the minutes. ConïŹrm with .MODE/UP DOWN SET
5. Push to change between 12 or 24 hour display.DOWN
Set alarm
1. Push until “ALM” is shown on display.MODE/UP
2. Push to change between 12 or 24 hour display.DOWN
3. Push and hold for approx. 2 secs to walk in setting position.SET
4. Use and to change the hours. ConïŹrm with .MODE/UP DOWN SET
5. Use and to change the minutes and conïŹrm with . MODE/UP DOWN SET
The alarm time now blinks on the display.
6. Push to turn on/off the alarm. An alarm symbol shows on the MODE/UP
display when the alarm is activated.
7. Push to conïŹrm.SET
Wearing the step counter
‱ Attach step counter to belt or to another item of clothing at waistline height
on the side of the body. For the step counter to function correctly it is
important that it is attached in a horizontal position.
Ver. 200802
SVERIGE ‱ KUNDTJÄNSTî€€î€€î€Žî€„î€Źî€šî€€î€î€’î€”î€—î€î€”î€”î€•î€€î€î€î€Œî€€î€Šî€Ąî€žî€šî€€î€î€’î€”î€—î€î€”î€”î€•î€€î€î€™î€Œî€€î€„î€î€°î€Żî€łî€Žî€šî€€î‹î•îŽî„î”îŠîîŽî“î”î€ îƒîŒîî“îîˆîŒî“îîŽî€Žî“î…î€Œî€€î€©î€źî€Žî€„î€Čî€źî€„î€Žî€šî€€î—î—î—î€ŽîƒîŒîî“îîˆîŒî“îîŽî€Žî“î…
SVENSKA
StegrÀknare Artikelnummer: 34-7357
LÀs igenom hela bruksanvisningen före anvÀndning och spara den sedan för
framtida bruk.
StegrÀknarens knappar
S1 – Mode/UP
S2 - Down
S3 - Clear
S4 - Set
AnvÀndning
StegrÀkning
1. Tryck pĂ„ tills ”STEP” visas i displayen.MODE/UP
2. Displayen visar nu totala antalet steg.
3. Tryck och hÄll in för att stÀlla in lÀngdenhet. SET
4. AnvÀnd och för att vÀxla mellan Km eller Miles. MODE/UP DOWN
Tryck pÄ för att bekrÀfta.SET
5. Tryck pÄ för att nollstÀlla rÀkneverket i displayen.CLEAR
DistansrÀknare
1. Tryck pĂ„ för att gĂ„ in i distansrĂ€knare. ”KM” eller ”MILE” MODE/UP
visas i displayen.
2. Tryck pĂ„ för att vĂ€lja ”KM” eller ”MILE”.DOWN
3. DistansrÀknaren nollstÀlls samtidigt som stegrÀknaren.
StÀlla in steglÀngden
1. Tryck pÄ tills att distansrÀknaren (strÀckan du gÄtt i km eller MODE/UP
miles) visas i displayen.
2. Tryck och hÄll in i ca 2 sekunder. SteglÀngden blinkar i displayen.SET
3. AnvÀnd och för att stÀlla in steglÀngden (hur lÄngt ditt MODE/UP DOWN
steg Àr).
4. Tryck pÄ för att bekrÀfta.SET
KalorirÀknare
1. Tryck pĂ„ för att gĂ„ in i distanslĂ€get. ”KCAL” visas i displayen.MODE/UP
2. Tryck och hÄll in i ca 2 sekunder för att ange din vikt. InstÀlld vikt SET
blinkar i displayen.
3. AnvÀnd och för att stÀlla in vikten.MODE/UP DOWN
4. Tryck pÄ för att bekrÀfta.SET
AnvÀnda stoppuret
1. Tryck pÄ för att aktivera stoppuret.MODE/UP
2. Tryck pÄ för att starta eller stoppa tidtagningen.DOWN
3. NÀr tidtagningen Àr stoppad, tryck pÄ för att nollstÀlla tidtagningen.SET
‱ För mellantider, tryck en gĂ„ng pĂ„ samtidigt som tidtagningen pĂ„gĂ„r. SET
Displayen stannar och visar mellantiden. Tidtagningen fortsÀtter
i bakgrunden.
‱ Tryck igen pĂ„ för att Ă„teruppta tidtagningen.SET
AnvÀnda överfallslarmet
Aktivera: Dra ut alarmpinnen frÄn stegrÀknarens baksida för att
aktivera överfallslarmet.
StÀnga av: SÀtt tillbaka alarmpinnen för att stÀnga av alarmet.
Öppna batteriluckan
‱ Ta bort batteriluckan genom att skruva ur
skruven och sedan skjuta batteriluckan
bakÄt enligt bilden.
Justera stegrÀknarens kÀnslighet
1. Ta bort batteriluckan.
2. Ändra stegrĂ€knarens kĂ€nslighet genom att
skjuta reglaget i sidled. Prova dig fram för
att hitta rÀtt instÀllning.
‱ Exempel: GĂ„ 100 steg. Om
stegrÀknaren visar mer Àn 100 steg
justerar du kÀnsligheten nedÄt. Visar
stegrÀknaren mindre Àn 100 steg
justerar du kÀnsligheten uppÄt.
Byte av batteriet
1. Ta bort batteriluckan.
2. Lyft ur batterierna med hjÀlp av en liten
skruvmejsel och ersÀtt dem med nya. Var
noga med att vÀnda batterierna med rÀtt
polaritet enligt bilden.
Avfallshantering
NÀr du ska göra dig av med produkten ska detta ske enligt lokala föreskrifter.
Är du osĂ€ker pĂ„ hur du ska gĂ„ tillvĂ€ga, kontakta din kommun.
SpeciïŹkationer
Batteri, stegrÀknare: 1 x SR54 (medföljer)
Batteri, överfallslarm: 2 x CR2016 (medföljer)
StegrÀknare: Upp till 99 999 steg
KalorirÀknare: Upp till 9999,9 kcal
Distans: Upp till 9999,9 km/mile
Förberedelser
StegrÀknarens menyer
Tryck pÄ för att vÀlja funktion i följande ordning:MODE/UP
TMR (klocka) -> ALM (alarm) -> STEP (stegrÀkning) -> KM (distans) ->
KCAL (kalorimÀtning) -> STW (stoppur)
StÀlla in tiden
1. Tryck pĂ„ tills ”TMR” visas i displayen.MODE/UP
2. Tryck och hÄll in i ca 2 sekunder för att gÄ in i instÀllningslÀget.SET
3. AnvÀnd och för att Àndra timmarna. BekrÀfta med .MODE/UP DOWN SET
4. AnvÀnd och för att Àndra minuterna. BekrÀfta med .MODE/UP DOWN SET
5. Tryck pÄ för att vÀxla mellan 12- eller 24-timmarsvisning.DOWN
StÀlla in alarmet
1. Tryck pĂ„ tills ”ALM” visas i displayen.MODE/UP
2. Tryck pÄ för att vÀxla mellan 12- eller 24-timmarsvisning.DOWN
3. Tryck och hÄll in i ca 2 sekunder för att gÄ in i instÀllningslÀget.SET
4. AnvÀnd och för att Àndra timmarna. BekrÀfta med .MODE/UP DOWN SET
5. AnvÀnd och för att Àndra minuterna och bekrÀfta med MODE/UP DOWN
SET. Alarmtiden blinkar nu i displayen.
6. Tryck pÄ för att slÄ av eller pÄ alarmet. En alarmsymbol visas MODE/UP
i displayen nÀr alarmet Àr aktiverat.
7. Tryck pÄ för att bekrÀfta.SET
BÀra stegrÀknaren
‱ FĂ€st stegrĂ€knaren i bĂ€ltet eller i annat klĂ€desplagg i midjehöjd pĂ„ sidan av
kroppen. För att stegrÀknaren ska fungera korrekt Àr det viktigt att den fÀsts
i horisontellt lÀge.
Ver. 200802


Product specificaties

Merk: Clas Ohlson
Categorie: Stappentellers
Model: 34-7357

Heb je hulp nodig?

Als je hulp nodig hebt met Clas Ohlson 34-7357 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden