Chief XCB7000 Handleiding

Chief Flat panel steun XCB7000

Lees hieronder de 📖 handleiding in het Nederlandse voor Chief XCB7000 (12 pagina's) in de categorie Flat panel steun. Deze handleiding was nuttig voor 28 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12

I N S T A L L A T I O N I N S T R U C T I O N S

XCB7000

(shown installed to 1-1/2" NPT

columns as example only)

Extra Large Back-to-Back Dual Column Ceiling Mount

Spanish Product Description

German Product Description

Portuguese Product Description

Italian Product Description

Dutch Product Description

French Product Description

XCB7000

XCB7000 Installation Instructions

DISCLAIMER

Milestone AV Technologies and its affiliated corporations and

subsidiaries (collectively "Milestone"), intend to make this

manual accurate and complete. However, Milestone makes no

claim that the information contained herein covers all details,

conditions or variations, nor does it provide for every possible

contingency in connection with the installation or use of this

product. The information contained in this document is subject

to change without notice or obligation of any kind. Milestone

makes no representation of warranty, expressed or implied,

regarding the information contained herein. Milestone assumes

no responsibility for accuracy, completeness or sufficiency of

the information contained in this document.

Chief® is a registered trademark of Milestone AV Technologies.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: A WARNING alerts you to the possibility of

serious injury or death if you do not follow the instructions.

CAUTION: A CAUTION alerts you to the possibility of

damage or destruction of equipment if you do not follow the

corresponding instructions.

WARNING: Failure to read, thoroughly understand, and

follow all instructions can result in serious personal injury,

damage to equipment, or voiding of factory warranty! It is the

installer’s responsibility to make sure all components are

properly assembled and installed using the instructions

provided.

WARNING: Failure to provide adequate structural strength

for this component can result in serious personal injury or

damage to equipment! It is the installer’s responsibility to

make sure the structure to which this component is attached

can support five times the combined weight of all equipment.

Reinforce the structure as required before installing the

component.

WARNING: Exceeding the weight capacity can result in

serious personal injury or damage to equipment! It is the

installer’s responsibility to make sure the combined weight of

all components located within the mounting system of the

XCB7000 does not exceed a maximum weight capacity of

600 lbs (272.2 kg) [300 lbs (136.1 kg) each display].

WARNING: Never operate this mounting system if it is

damaged. Return the mounting system to a service center for

examination and repair.

WARNING: Do not use this product outdoors.

NOTE: The XCB7000

dual column ceiling mounts are intended

to be used with the UL Listed CPA extension columns

and UL Listed CPA Ceiling Plates (not included):

CPA330, CPA365, CPA395.

The following UL Listed Chief ceiling plates WITHOUT

swaged collars (not included) may also be used:

CMA330, CMA345, CMA395.

--SAVE THESE INSTRUCTIONS--

XCB7000 Installation Instructions

DIMENSIONS

15.75

400.0

MAX VERTICAL

COLUMNS SOLD

SEPARATELY

2" TOTAL HEIGHT ADJUST

1" UP/1" DOWN

PADLOCK

HOLE

COLUMNS SHOULD BE APPROXIMATELY

CENTERED ON MOUNT

SPACING (X) NOT TO BE LESS THAN 18" (450 mm)

7.6°

MAX BACK

TILT

20°

MAX FORWARD

41.0

1041.0

TILT LOCKOUTS AT

-7.6°

-5°

0°

5°

10°

15°

20°

MOUNTING

PATTERN

DIMENSIONS: INCHES

[MILLIMETERS]

7.6°

5°

10°

15°

20°

DETAIL A

SCALE 1 : 2 -7.6° HOLE

DETAIL B

SCALE 1 : 2

-5° HOLE

DETAIL C

SCALE 1 : 2

0° HOLE DETAIL D

SCALE 1 : 2

5° HOLE

DETAIL E

SCALE 1 : 2

10° HOLE

DIMENSIONS: INCHES

[MILLIMETERS]

Product specificaties

Merk:	Chief
Categorie:	Flat panel steun
Model:	XCB7000
Kleur van het product:	Zwart
Breedte:	884 mm
Diepte:	3000 mm
Hoogte:	425 mm
Gewicht verpakking:	23000 g
Montagewijze:	Plafond
Maximale gewichtscapaciteit:	272 kg
Certificering:	UL
Montage interface compatibiliteit (min):	200 x 100 mm
Montage interface compatibiliteit (max):	800 x 400 mm
Aantal displays ondersteund:	2
Bereik kantelhoek:	-20 - 7.5 °
Maximale schermgrootte:	90 "
Code geharmoniseerd systeem (HS):	85299097
Minimale schermgrootte:	60 "