Chief SSM122 Handleiding
Chief
Projector accessoire
SSM122
Lees hieronder de 📖 handleiding in het Nederlandse voor Chief SSM122 (1 pagina's) in de categorie Projector accessoire. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-000113 Rev B
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-122, SSM-122, SLB-122 and SLM-122 Interface Brackets
SSB-122, SSM-122, SLB-122 and SLM-122 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place 1/2" spacers over the threaded inserts on raised area of projector, and place 5/8" spacers over the threaded inserts on lower area
of projector.
4. Place interface bracket over projector bottom and align the mounting holes in bracket with the threaded inserts in projector.
5. Secure interface bracket to projector using M4 x 20mm Phillips pan head screw and M4 x 20mm Phillips flat head screw with flat washers
(i.e., in shorter spaces of projector). Use M4 x 25mm Phillips pan head screw and M4 x 25mm Phillips flat head screw with flat
washers (i.e., in longer spacers of projector). Tighten all fasteners at this time.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (1) Screw, Phillips Flat Head Machine M4 x 25mm ****
(4) 10-24 Thumb Nuts ** (1) Screw, Phillips Pan Head, Machine, M4 x 20mm ****
(1) All-Points Security Kit (1) Screw, Phillips Flat Head, Machine, M4 x 20mm ****
(2) 1/2" x .257 x 5/8" Nylon Spacer **** (2) Washer, Flat, M4
(2) 1/2" x .194 x 1/2" Round Spacer **** (1) Screw, Phillips Pan Head, Machine, M4 x 25mm ****
**Only used when installing SLB/SSB interface brackets. ****Used when mounting surface of projector is recessed.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
SLB-122 SLM-122
Towards front of
projector
Towards front of
projector
(Note: SSM-style interface bracket connection
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(
Note: SSB-style interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
Product specificaties
| Merk: | Chief |
| Categorie: | Projector accessoire |
| Model: | SSM122 |
Heb je hulp nodig?
Als je hulp nodig hebt met Chief SSM122 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Projector accessoire Chief
22 Februari 2024
9 Juli 2023
9 Juli 2023
9 Juli 2023
9 Juli 2023
9 Juli 2023
9 Juli 2023
9 Juli 2023
9 Juli 2023
9 Juli 2023
Handleiding Projector accessoire
- Projector accessoire Casio
- Projector accessoire Panasonic
- Projector accessoire Barco
- Projector accessoire BenQ
- Projector accessoire Hitachi
- Projector accessoire InFocus
- Projector accessoire Manhattan
- Projector accessoire Nec
- Projector accessoire Nedis
- Projector accessoire Newstar
- Projector accessoire Peerless
- Projector accessoire Sanyo
- Projector accessoire Viewsonic
- Projector accessoire Vogels
- Projector accessoire XGIMI
- Projector accessoire Omnitronic
- Projector accessoire Optoma
- Projector accessoire Sanus
- Projector accessoire Vision
- Projector accessoire Gabor
- Projector accessoire Lindy
- Projector accessoire Da-Lite
- Projector accessoire AV:link
- Projector accessoire Peerless-AV
- Projector accessoire Projecta
- Projector accessoire Chipolino
- Projector accessoire Tempest
- Projector accessoire Premier Mounts
- Projector accessoire Elite Screens
- Projector accessoire Kingpin Screens
- Projector accessoire Kanto
- Projector accessoire V7
- Projector accessoire Christie
- Projector accessoire Smart Media
Nieuwste handleidingen voor Projector accessoire
10 April 2024
10 April 2024
10 April 2024
19 Maart 2024
19 Maart 2024
19 Maart 2024
19 Maart 2024
19 Maart 2024
15 Februari 2024
15 Februari 2024