Chief SLM312 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Chief SLM312 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
8800-002323 Rev00
©2012 Milestone AV Technologies,
a Duchossois Group Company
12/12
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
6436 City West Parkway, Eden Prairie, MN 55344
• P: 800.582.6480 / 952.225.6000 • F:877.894.6918 / 952.894.6918
I N S T A L L A T I O N I N S T R U C T I O N S
SLB-312 and SLM-312 Interface Brackets
SLB-312 and SLM-312 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific installation instructions
provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place four nylon spacers over four threaded inserts in bottom of projector.
4. Place the interface bracket onto the spacers on bottom of the projector, aligning the mounting holes in the bracket with the spacers and
the threaded inserts in the bottom of the projector, and ensuring that bracket faces front of projector as noted in above graphic.
5. Position M6 x 20mm mounting screws into the threaded inserts and bracket. Tighten all fasteners at this time, securing the bracket to the
projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (4) Screw, Phillips Flat Head, Machine, M6 x 20mm
(6) 10-24 Thumb Nuts ** (4) Spacer, Nylon, .875 x .330 x .375"
(1) All-Points Security Kit (1) 5/32" Security Hex Key
**Only used when installing SLB interface brackets.
SLB-312 SLM-312
Towards front
of projector
Towards front
of projector


Product specificaties

Merk: Chief
Categorie: Niet gecategoriseerd
Model: SLM312
Kleur van het product: Zwart
Aantal per verpakking: 1 stuk(s)
Type product: Interfacebeugel

Heb je hulp nodig?

Als je hulp nodig hebt met Chief SLM312 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Chief

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd