Chief Kontour KRA208B Handleiding

Chief Flat panel steun Kontour KRA208B

Lees hieronder de 📖 handleiding in het Nederlandse voor Chief Kontour KRA208B (4 pagina's) in de categorie Flat panel steun. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
I N S T A L L A T I O N I N S T R U C T I O N S
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Kontourâ„¢ Extension Arm
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
KRA208
KRA208 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® and Kontour™ are registered trademarks of Milestone
AV Technologies. All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the K1D100/200 Monitor
Arm up to (and including) the display does not exceed 20 lbs
(9.07 kg) per arm when using the KRA208 extension arm.
Use with products heavier than the maximum weight
indicated may result in collapse of the mount and its
accessories causing possible injury.
IMPORTANT ! : The KRA208 extension arm is only
designed to be attached to the K1D100 and K1D200
Kontourâ„¢ arms. Do NOT attach the KRA208 to any other
mounting arm!
WARNING: Do not use this product outdoors.
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
6.75
171.5
3.32
84.4
Installation Instructions KRA208
3
TOOLS / PARTS FOR INSTALLATION
3/16" (included)
1/8" (included)
A (1)
[KRA208 arm]
B (1)
[pivot pin]
C (2)
[steel washer]
D (1)
[chrome ring] E (1)
[pivot ring]
F (1)
5/16-18 x 1" G (1)
5/16" H (1)
[plastic washer]
J (1)
1/4-20 X 3/4"
K (1)
3/16"
L (1)
1/8"
ASSEMBLY AND INSTALLATION
1. If already installed, remove display from Kontourâ„¢ arm
using quick connect faceplate.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the K1D100/200 Monitor
Arm up to (and including) the display does not exceed 20 lbs
(9.07 kg) per arm when using the KRA208 extension arm.
Use with products heavier than the maximum weight
indicated may result in collapse of the mount and its
accessories causing possible injury.
2. Disassemble mounting arm of Kontourâ„¢ mount by
unscrewing button head cap screw and removing three
assembled washers. (See Figure 1)
3. Remove arm from pin by lifting arm off of pin. (See Figure 1)
Set arm and removed hardware aside for reuse.
Figure 1
4. Use 5/16-18 x 1" button head cap screw (F), two steel
washers (C), plastic washer (H) and 5/16" washer (G) to
secure KRA208 arm (A) to pin on base of Kontourâ„¢ mount.
Follow the exact order shown in Figure 2. (See Figure 2)
5. Place chrome ring (D) and pivot ring (E) on outer hole of
extension arm (A). (See Figure 2)
6. Use 1/4-20 x 3/4" set screw (J) to secure pivot pin (B) to
extension arm (A). (See Figure 2)
Figure 2
7. Use hardware removed in Step 2 to attach removed arm
onto extension arm pin (B). (See Figure 3)
Figure 3
8. Install display to Kontourâ„¢ arm using quick connect
faceplate.
32
(K1D100 shown)
(F)
(C) x 2
(G)
(E)
(D)
(B)
4
6
(J)
(A)
5
5
(K1D100 shown)
(H)
removed
screw
removed
washers
Kontour arm (B)
7
(K1D100 shown)

Product specificaties

Merk: Chief
Categorie: Flat panel steun
Model: Kontour KRA208B

Heb je hulp nodig?

Als je hulp nodig hebt met Chief Kontour KRA208B stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Flat panel steun Chief

Chief

Chief RXF3 Handleiding

16 April 2024
Chief

Chief PNR2536B Handleiding

9 Juli 2023
Chief

Chief K4G210B Handleiding

9 Juli 2023
Chief

Chief MF26000B Handleiding

9 Juli 2023
Chief

Chief FSB018BLK Handleiding

9 Juli 2023
Chief

Chief TPK1 Handleiding

9 Juli 2023
Chief

Chief PDR2612B Handleiding

9 Juli 2023
Chief

Chief CMA395 Handleiding

9 Juli 2023
Chief

Chief JHSUB Handleiding

9 Juli 2023
Chief

Chief KTG225S Handleiding

9 Juli 2023

Handleiding Flat panel steun

Nieuwste handleidingen voor Flat panel steun

Sven

Sven T51-44 Handleiding

26 April 2024
Sven

Sven FS27-88 Handleiding

26 April 2024
Sven

Sven C81-44 Handleiding

26 April 2024
Sven

Sven FS17-21 Handleiding

25 April 2024
Sven

Sven FS31-44 Handleiding

25 April 2024
Sven

Sven F48-64 Handleiding

25 April 2024
Sven

Sven С77-22 Handleiding

25 April 2024
Mount-It!

Mount-It! MI-1879 Handleiding

17 April 2024
Mount-It!

Mount-It! MI-4881 Handleiding

17 April 2024
GPX

GPX TM15 Handleiding

16 April 2024