Chapin 61808 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Chapin 61808 (36 pagina's) in de categorie Verfspuit. Deze handleiding was nuttig voor 61 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/36
Model 61808 • 4G/ 15L
011553 R0713
Carefully Read These Instructions Before Use
Chapin International, Inc
P.O. Box 549
700 Ellicott St.
Batavia, NY 14021-0549 U.S.A.
1-800-950-4458
www.chapinmfg.com
WARNING
DO NOT RETURN THIS
SPRAYER TO STORE
Call: 1-800-950-4458
www.chapinmfg.com
WARNING
WARNING: Handling the brass parts of this product will expose you to lead, a chemical
known to the State of California to cause birth defects and other reproductive harm.
Wash hands after handling.
CAUTION
1E
WARNING: Improper use or failure to follow instructions can result in explosive
failure causing serious eye or other injury. For safe use of this product you must read
and follow all instructions. Do not leave a pressurized sprayer in the hot sun. Heat can cause
pressure build-up resulting in possible explosion. Do not store or leave solution in tank after
use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when
spraying. Never use any tool to remove pump if there is pressure in the pressure chamber.
Never pressurize sprayer by any means other than the original pump. Do not attempt to
modify this sprayer. Replace parts only with manufacturer’s original parts. Never spray
ammable, caustic, acidic, chlorine, bleach or other corrosive solutions or
heat, pressure, or gas producing chemicals. Always read and follow chemical
manufacturer’s instructions before use with this sprayer as some chemicals may
be hazardous when used with this sprayer.
• PRE-USE CHECK: Before each use check tightness of hose nut to be sure hose is
securely attached to the shut-off assembly. Insure hose is securely attached to the
pump outlet by tightening hose nut. Insure that all nozzle and wand connections
are tight. Insure the three bolts (underside of base) used to attach the piston
cylinder are tight.
• Do Not exceed a tank solution temperature of 120º F/ 49º C.
NOTE: The tank and hose may have residual water in it due to quality testing
performed on the sprayer.
SK 1158-1
1. Poly
Nozzle Cap
2. Retaining
Nut
3. Nozzle
Body
4. Nozzle
Gasket
5. Elbow
Figure 2Figure 1
Nozzle
Gasket
Retaining Nut
Elbow
Fan Nozzle Tip
2E
APPLICATIONS & USE FOR YOUR SPRAYER
Avoid using a sprayer for general cleaning purposes if plant protection or herbicide chemicals have
already been used in the sprayer. If a sprayer has been used for plant protection or as an herbicide, clean
the sprayer completely (see cleaning section) before using.
Plant Food: Use different spray patterns for optimum foliage feeding or for fungicide and pesticide
application.
Herbicides: Reduce weeds and unwanted plants but avoid using the same sprayer for plant feeding or
protection without thoroughly cleaning (see cleaning section) the sprayer first.
General Household Use: Apply detergents, cleaning solutions, warm water (do not exceed
120°F/49°C) or nontoxic household cleaning chemicals for carpets, floors, walls, glass, counter tops and
ceilings. DO NOT use sprayer that has been used with herbicides, pesticides or other toxic chemicals for
household applications.
General Outdoor Use: Use the sprayer for cleaning windows or with a detergent for general purpose
cleaning.
SPRAYER COMPONENTS & USE INFORMATION
NOZZLE ASSEMBLY
Figure 1
Unscrew the nozzle cap (1) from the nozzle body (3) with retaining nut (2) fastened tightly to the
elbow (5). Unscrew the retaining nut . Push the nozzle body (2) (3) (4) with the nozzle gasket out of
the retaining nut . To reinstall the nozzle, reverse the above instructions.(2)
Figure 2
Unscrew the retaining nut from the elbow and push the fan nozzle tip and gasket out of the retaining
nut. To reinstall the nozzle, reverse the above instructions.
Product specificaties
| Merk: | Chapin |
| Categorie: | Verfspuit |
| Model: | 61808 |
Heb je hulp nodig?
Als je hulp nodig hebt met Chapin 61808 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Verfspuit Chapin
24 Juni 2023
20 Juni 2023
18 Juni 2023
18 Juni 2023
12 Juni 2023
11 Juni 2023
8 Juni 2023
4 Juni 2023
3 Juni 2023
26 Mei 2023
Handleiding Verfspuit
- Verfspuit Bort
- Verfspuit Deco
- Verfspuit Defort
- Verfspuit Easymaxx
- Verfspuit Einhell
- Verfspuit Elektra Beckum
- Verfspuit Ferm
- Verfspuit Holzmann
- Verfspuit Magnum
- Verfspuit Metabo
- Verfspuit Paintmaxx
- Verfspuit Parkside
- Verfspuit Pattfield
- Verfspuit Powerplus
- Verfspuit Silverline
- Verfspuit Wagner
- Verfspuit Westfalia
- Verfspuit Jocca
- Verfspuit Ozito
- Verfspuit 3M
- Verfspuit Black And Decker
- Verfspuit Cocraft
- Verfspuit Meec Tools
- Verfspuit Aerotec
- Verfspuit Cotech
- Verfspuit Power Craft
- Verfspuit Truper
- Verfspuit Fieldmann
- Verfspuit Sun Joe
- Verfspuit Probuilder
- Verfspuit Birchmeier
- Verfspuit Yato
- Verfspuit Meister Craft
- Verfspuit Wagner SprayTech
- Verfspuit XU1
Nieuwste handleidingen voor Verfspuit
3 April 2024
16 Maart 2024
16 Maart 2024
8 Februari 2024
8 Februari 2024
8 Februari 2024
7 Februari 2024
7 Februari 2024
18 December 2023
18 December 2023