Casio 5468 Handleiding

Casio Horloge 5468

Lees hieronder de 📖 handleiding in het Nederlandse voor Casio 5468 (3 pagina's) in de categorie Horloge. Deze handleiding was nuttig voor 11 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
Operation Guide 5468/5495
E-9
5. Use to move the World City hand to the city that matches your current B
location (time zone).
x Holding down moves the hand at high speed.B
x For information about time zones, see the City List on page E-15.
Example: TOKYO (TYO)

Align the hand with the
center of the city name.
E-8
3. Use to move the alarm hands to the same setting as the main hands.B
x The alarm time does not distinguish between a.m. and p.m.
x Holding down moves the hands at high speed.B

10:08
4. Hold down for about two seconds.A
x This will cause the World City hand to make one revolution.
E-7
x When setting the minute hand, move it four or ve minutes past the desired
setting, and then back it up.
Example: To set a time of 10:08

E-6
Adjusting the Time Setting
Perform the procedure below whenever the position of any of the hands is incorrect.
Important!
xWhen setting the time, be sure to set the position of all of the hands. If you change
the position of only one hand, the other hands will still be incorrect.
1. Just as the second hand reaches 12 o’clock, pull out the crown to the
second click.
x This will stop the second hand.
2. Rotate the crown to set the main hour and minute hands.
x Take care that you set the correct AM or PM time. Watch the day indicator when
the hour hand passes 12 o’clock. If the day indicator changes, it means you just
passed midnight.
x Set the hands to a time that is a few minutes past* the actual current time.
* Since you will re-start timekeeping in step 8 of this procedure, you should allow
a few minutes to perform the other steps before that.
E-5
Indicators and Crown Operation

Second hand
Day indicator
Click 2
Main hour hand
Main minute hand
Crown
Click 1
World City hand
Alarm hands (12-hour)
World Time hands (12-hour)
World Time
x Shows the current time in the selected
World City.
Alarm
x Shows alarm time setting when alarm is
on, current time when alarm is off.
E-4
Low Battery Alert ............................................................................. E-21
If watch operation is abnormal ... .................................................... E-22
Specifi cations ................................................................................... E-23
Operating Precautions ...................................................................... E-24
User Maintenance ............................................................................ E-34
E-3
Contents
Before Using the Watch for the First Time .......................................... E-2
Indicators and Crown Operation ......................................................... E-5
Adjusting the Time Setting ................................................................. E-6
To change the day indicator setting ............................................................E-12
World Time ....................................................................................... E-13
Using the Alarm ................................................................................ E-17
To set an alarm time and turn on the alarm .................................................E-18
To cancel a previously set alarm .................................................................E-20
To test the alarm ........................................................................................E-20
E-2
Before Using the Watch for the First Time
Crown Operations
Some water-resistant models (100meters, 200meters)
have a screw-in crown. When you need to perform a crown
operation, rotate it towards you to unscrew it. Then pull
the crown out. Avoid applying undue force when pulling.
The watch loses its water resistance while the crown is
unscrewed. After performing a crown operation, fully screw
the crown back in.
Crown
Loosen
If your watch has a rotary bezel...
You can rotate the bezel to align its mark with
the minute hand. Then you will be able to tell how
much time has elapsed since aligning the mark.
Start
Elapsed time
Current
E-1
ENGLISH
x Be sure to keep all user documentation handy for future reference.
x Your watch may differ somewhat from the one shown in the illustration.
MA1604-EB © 2016 CASIO COMPUTER CO., LTD.
Operation Guide 5468/5495
E-19
3. Push the crown back in.
x Setting an alarm time turns on the alarm.
x To change to a different alarm time, repeat steps 1 through 3.
4. The alarm will sound when the main hands are at the same position as the
alarm time setting.

x After the alarm sounds, it turns off automatically and the alarm time setting
changes to the current time.
x To stop an ongoing alarm sound operation, press or A B.
E-18
To set an alarm time and turn on the alarm
1. Pull the crown out to the rst click.
2. Use the button to set the alarm to the desired time.B
x Holding down moves the hands at high speed.B
Example: To set a time of 1:15

E-17
Using the Alarm
The watch will perform a single 20-second alarm sound operation when the alarm
time is reached (One-time Alarm). You can set an alarm time in one-minute steps up
to 11 hours and 59 minute from the current time.
Important!
x Check the points below before using the alarm.
Make sure the current time setting is correct (page E-6).
E-16
Important!
x To check the current time in a location that is not among the 24 city names, select
a city that is in the same time zone as the one you want to check.
Example: To check the time in Osaka (Offset: +9), select Tokyo, which has the
same offset.
x To check the current time in a city where summer time is in effect, select a city in a
time zone with a time that is one hour ahead of the desired city.
Example: To check the time in NEW YORK (Offset: –5) during summer time,
select SANTIAGO (Offset: –4).
Note
x Holding down (+) or (–) will move the hand at high speed.A B
E-15
City UTC Offset/GMT
Differential *1
LONDON (LON) 0
PARIS (PAR) +1
ATHENS (ATH) +2
JEDDAH (JED) +3
DUBAI (DXB) +4
KARACHI (KHI) +5
DHAKA (DAC) +6
BANGKOK (BKK) +7
HONG KONG (HKG)/
BEIJING (BJS) *
2+8
TOKYO (TYO) +9
SYDNEY (SYD) +10
NOUMEA (NOU) +11
WELLINGTON (WLG) +12
City UTC Offset/GMT
Differential *1
PAGO PAGO (PPG) –11
HONOLULU (HNL) –10
ANCHORAGE (ANC) –9
LOS ANGELES (LAX) –8
DENVER (DEN) –7
CHICAGO (CHI) 6
NEW YORK (NYC) –5
SANTIAGO (SCL) –4
RIO DE JANEIRO (RIO) –3
F. DE NORONHA (FEN) –2
PRAIA (RAI) –1
*1 UTC: Universal Time Coordinated;
GMT: Greenwich Mean Time
*2 HONG KONG or BEIJING, depending
on model.
E-14
1. Use the and buttons to move the World City hand to the city (time A B
zone) whose time you want to check.
x This will cause the World Time hands to move to the current time in the selected
city.
Example: NEW YORK (NYC)

New York Time: 8:08
E-13
World Time
This mode displays the current time in any one of 24 cities (24 time zones) around
the world.
Important!
x The World Time display does not distinguish between a.m. times and p.m. times.
x Check the points below before using World Time.
Make sure the crown is pushed all the way in.
Make sure the current time setting is correct (page E-6).
E-12
To change the day indicator setting
1. Pull the crown out to Click 1.
2. Rotate the crown away from you to set the day.
3. Push the crown back in.
Note
x The day indicator setting uses a 31-day month. Make adjustments for months of
shorter lengths.
x Avoid changing the day indicator setting between the hours of 9 p.m. and 1 a.m.
Otherwise, the day indicator may not change correctly at midnight.
E-11
Note
x Holding down for about two seconds will cycle the currently selected hand in A
the sequence below.
Alarm hands World Time handsWorld City hand
A
AA
8. When the hands are at the desired setting (10:08 in this example), push the
crown back in.
x This will start normal timekeeping.
E-10 B
6. Hold down for about two seconds.A
x This will cause the World Time Hour hand to make two revolutions.
7. Use to move the World Time hands to the same setting as the mainB
hands.
x Holding down moves the hands at high speed.B

10:08
Operation Guide 5468/5495
E-23
Specifi cations
Accuracy: ±20 seconds average per month
World Time: 24 cities (24 time zones) and Coordinated Universal Time
Alarm: One-time alarm
Number of Alarms: 1
Alarm Sounds: 20 seconds
Other: Low battery alert
Battery: One silver oxide battery (Type: SR927W)
Battery Life: Approximately 3 years (assuming alarm operation 20 seconds per day)
x Approximate battery life can be shortened by more frequent operation.
E-22
If watch operation is abnormal ...
1. Pull the crown out to the second click.
2. While holding down , press . Keep both buttons depressed for about B A
three seconds.
x The alarm hands will move slightly and then stop.
3. Set the hands to the current time (page E-6).
4. Push the crown back in.
x Normal second hand movement should start at this time.
E-21
Low Battery Alert
Second hand moves in 2-second increments when power is low. Replace the battery
as soon as possible.
2-second jump
E-20
To cancel a previously set alarm
1. Pull the crown out to the rst click.
2. Hold down and the alarm hands will start to move.B
xKeep depressed until the alarm hands stop at the current time position.B
3. Push the crown back in.
x This cancels (turns off) the alarm.
To test the alarm
1. Pull the crown out to the rst click.
2. Hold down for at least two seconds.A
x The alarm will sound as long as is depressed.A
3. Push the crown back in.


Product specificaties

Merk: Casio
Categorie: Horloge
Model: 5468

Heb je hulp nodig?

Als je hulp nodig hebt met Casio 5468 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Horloge Casio

Handleiding Horloge

Nieuwste handleidingen voor Horloge