Caple TSB600WH Handleiding

Caple Afzuigkap TSB600WH

Lees hieronder de 📖 handleiding in het Nederlandse voor Caple TSB600WH (4 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4



Glass splashback

Installation Guide

Please refer to the checklist prior to installation

Contact Caple on 0117 938 1900 or email service@caple.co.uk

Fitting steps – Splashbacks

Fitting steps – Splashbacks Fitting steps – Splashbacks

Ensure Silicone is used

around enti

enti

entientire

rere splashback

Do not

not

notnot allow Splashback to

rest directly on work surface

– silicone should seal the gap

left by spacers

Assembly guide - Splashbacks

Assembly guide - Splashbacks Assembly guide - Splashbacks

IMPORTANT

Unfitted glass is fragile. Do not place on hard surfaces prior to fitting. Special care should be taken with

the corners of the product as impact will cause the product to crack.

To prevent product failures ensure that:

• All fitting steps are completed.

• A space of at least 2mm

A space of at least 2mm

A space of at least 2mmA space of at least 2mm is left between th

is left between th

is left between th is left between the product an

e product an

e product ane product and all surf

d all surf

d all surfd all surfaces.

aces.

aces. aces.

The gaps must be filled with

The gaps must be filled withThe gaps must be filled with silicone

silicone

silicone silicone.

• The surface to which the product is applied is flat, variations in level in excess

of 5mm should be packed with silicone prior to fitting.

• You do not use any form of adhesive other than silicone as certain adhesives

will degrade the finish of the glass.

Glass cutting

Glass can be cut by a suitably experienced professional. Specialist glass cutting tools should be used.

Glass must not be cut into pieces of less than 30mm wide neither should less than 30mm be trimmed

from the splash back when cutting to size.

Safe handling of glass

All products are supplied with a safety backing but we recommend that glass is handled with care and in

particular eye protection and suitable gloves should be worn.

After care

Do not use abrasive cleaners. For the best results use:

• Hot water with a mild soap detergent.

Before you start

• Check that all components are present.

• Ensure that you have all tools to hand.

Tools needed to fit the splashback

• Tape measure.

• Sealant gun.

• Silicone sealant - only use low modular neutral cure silicon (BS 5889 A).

• 2mm tile spacers.

Drilling and cutting should only be undertaken by an

experienced professional with the correct tools.

Product specificaties

Merk:	Caple
Categorie:	Afzuigkap
Model:	TSB600WH
Kleur van het product:	Roestvrijstaal
Ingebouwd display:	Nee
Breedte:	600 mm
Hoogte:	750 mm
Gewicht verpakking:	691 g
Breedte verpakking:	20 mm
Diepte verpakking:	700 mm
Hoogte verpakking:	850 mm
Soort:	Afzuigkap spatpaneel
Hoogte (min):	750 mm
Materiaal:	Glas
Aantal per verpakking:	1 stuk(s)
Merkcompatibiliteit:	Caple