Canarm 212 Handleiding

Bekijk gratis de handleiding van Canarm 212 (6 pagina’s), behorend tot de categorie Ventilator. Deze gids werd als nuttig beoordeeld door 3 mensen en kreeg gemiddeld 4.8 sterren uit 8 reviews. Heb je een vraag over Canarm 212 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

9200_9200_VIB_UserGuide_02_09_2023Page 1 of 3

9200 SERIES

BLOWERS

INSTALLATION AND MAINTENANCE INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

GENERAL SAFETY

Rotating parts, (pulleys, shafts and belts) on fans should not be exposed. Where

these components are not protected by ductwork, cabinets or covers, appropriate

guards should be employed to restrict exposure to rotating parts. Access doors

should not be opened with the fan operating to avoid foreign objects being drawn

into the system. On initial start-up, a careful inspection should be carried out to

ensure no foreign material is present which could become airborne in the system.

Read installation and operation instructions carefully before attempting to install,

operate or service Canarm/Delhi 9200 Series. Failure to comply with instructions

could result in personal injury and/or property damage.

Retain instructions for future reference.

BEFORE YOU BEGIN

Inspect unit for damage, report any shipping damage to carrier. Check all fasteners, re-tighten as required. Rotate the blower wheel by

hand to ensure free rotation. If rubbing occurs, loosen the set screw(s), re-position the wheel to the shaft center, re-tighten set screws.

INSTALLATION

9200 series blowers are suitable for suspension or base mounting.

BASE MOUNTSUSPENDED MOUNT

RIGID

 MOUNT

OR

OR

RUBBER

ISOLATOR

RIGID MOUNT

SPRING

ISOLATOR

* Flexible inlet and outlet collars are recommended to minimize vibration transmission.

9200 SERIES 

BLOWERS

9200 SERIES 

BLOWERS

BASE MOUNTING

For base mounting secure unit through 4 - 7/8" diameter holes located in the "hat section" channel in the bottom of the unit. Ensure

unit is level.

SUSPENSION MOUNTING

Drill 4 - 7/8" diameter holes through the top using the inside top "hat section" channel as a guide. Extend 1/2" diameter threaded

mounting rod through the cabinet and the bottom channel and secure to both top and bottom. Ensure unit is level.

Installation or Product problems? Do not return to store of purchase.

Contact Canarm Service at 1-800-265-1833 (CANADA) 1-800-267-4427 (U.S.A.)

1-800-567-2513 (EN FRANCAIS) Monday to Friday 8:00 - 5:00pm e.s.t.

Canarm Ltd. - Corporate Head Office 2157 Parkedale Avenue, PO Box 367 Brockville, Ontario Canada K6V 5V6

Tel: (613) 342-5424; Fax: (613) 342-8437

www.canarm.com [email protected]

Product specificaties