Bushman Original SC35-52 Handleiding

Bushman Vriezer Original SC35-52

Lees hieronder de 📖 handleiding in het Nederlandse voor Bushman Original SC35-52 (2 pagina's) in de categorie Vriezer. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
A 100% AUSTRALIAN OWNED FAMILY
COMPANY SINCE 1982
WARRANTY
DP Refrigeration trading as Bushman Portable Fridges ABN 89 152 366 478 (Bushman) warrants, to the original owner, that this product is free
from defects in workmanship and material for a period of three years (5 years for the compressor only) from the purchase date. This warranty shall
be limited to repairing or replacing, at Bushman’s option and without charge to the purchaser, defective components. All warranty work shall be
performed at a Bushman approved facility. Shipping charges related to returning the product to the Bushman facility are not covered under this
warranty. However, this warranty covers shipping charges related to returning the repaired product to the customer. This warranty does not apply
to damage or wear to the product caused by accident, abuse, misuse, neglect, unauthorized alteration or repair, or if the product was not operated
in accordance with Bushman printed installation and operating instructions. To obtain service under this warranty, the defective product must
be returned to Bushman together with original purchase receipt. Any product repaired or replaced under this warranty will be warranted for the
balance of the warranty period with respect to the original purchased product.
3 Contour Close, Research VIC 3095 Australia
P +61 3 9437 0737
E aus@bushman.com.au
www.bushman.com.au
MEASUREMENTS
(3) CHECK ALL CONNECTIONS
Check all connections and solder points inside
all sockets and plugs. Check your car 12 V socket
connection by turning on the fridge and wiggling
the connections to see if the power light flickers.
REPAIR CAR WIRING
OR BATTERY
REPLACE
CONTROL PANEL
(CONTACT
HEAD OFFICE)
REPLACE LEAD OR
REPAIR CONNECTION
(1) USE A DIFFERENT POWER SUPPLY
Run the fridge using a 240V to 12V adaptor. If
not available, use a different outlet with the car
running, or in a different car.
(2) OVERRIDE THE CONTROL PANEL
Flick the override switch located on the back of the
Bushman control panel, then turn on the fridge.
This will bypass the control panel and run the
compressor non stop. For normal operation the
switch must be set to off.
FRIDGE RUNS
FRIDGE RUNS
FAULTY CONNECTION
TROUBLESHOOTING FLOW CHART
We solve 9 out of 10 Bushman issues by using this flow chart:
DP Refrigeration
Trading as Bushman Portable Fridges
ABN 89 152 366 478
THE
ORIGINAL
BUSHMAN
FRIDGE
FREEZER
12V / 24V / 240V : 35L – 52L
OWNERS MANUAL &
OPERATING INSTRUCTIONS
MODEL: SC 35-52
PLEASE READ CAREFULLY BEFORE
USE AND INSTALLATION
A 100% AUSTRALIAN OWNED FAMILY
COMPANY SINCE 1982
IMPORTANT
INFORMATION
• Do not lay your Bushman on its back or sides or at any
angle exceeding 30º.
• Never operate your Bushman directly from 240 V mains
power without using a 240 V – 12 V adapter.
• Never place items on top of the vents above the
compressor, heat will not be able to escape and
overheating could occur.
• Do not use a modified sine wave inverter to operate
your Bushman.
• Do not remove the rubber feet.
FITTING THE EXTENSION
COLLAR AND HIGH LID
When you first fit your extension collar and high lid,
adjustment to the hinges may be necessary if they do not sit
flat. If required, please adjust your hinges as follows:
1. Remove the flat lid.
2. Slide on your extension collar followed by your high lid.
3. Release the tension on all hinge screws.
4. Close the high lid and extension collar and clip them down.
5. Retention all screws with the high lid and extension collar
in the clipped down position.
12V INSTALLATION
6mm wiring direct to battery
Having a good power supply is key to your Bushman operating at
its best. For optimum results, we recommend using minimum
6mm automotive wire directly from your 12 V power outlet to
your cars battery through a 10 Amp fuse. Ensure the earth is
wired back to your battery, not to the chasse. If your wiring is not
minimum 6mm or is not direct to your battery, your Bushman
may cut out early due to power drop in your wiring.
100 Ah battery
We recommend using a minimum 100 Ah deep cycle battery
for the best long term results.
Matching 12V fittings
Your Bushman is supplied with a 12 V cigar plug. If you are using
your Bushman in a 4WD then we recommend fitting a matching
12 V socket and 12 V plug set. Different cars have varying sized
12 V power sockets, so having a matching set will provide your
12 V lead with the best possible connection at all times.
If you decide to fit a different type of 12 V fitting other than the
one supplied, note that the smooth side of the 12 V lead or the
one with writing on it, is the positive.
240V INSTALLATION
Plug your 12 V lead into the 240 V adaptor and then direct to
mains power.
Never run direct from the refrigerator to mains power without
a 240 V adaptor, irreversible damage can occur.
EFFICIENT OPERATION
Ventilation
Always allow sufficient air ventilation around the rear, sides and
top of the compressor compartment. This will ensure heat can
escape easily from the compressor and condensor.
Transit cover
Your transit cover is designed to protect your Bushman from
scratches, minor dints and direct sunlight.
Equalising fridge temperature
If you run your Bushman using the 240 V adapter for 4 or 5
hours before placing in your vehicle, this will ensure that the
internal air temperature, condensor and insulation has had time
to equalise. Doing this will result in shorter cycle times and
more efficient operation once you run your Bushman on 12 V.
Normal Operating Sounds
You may hear faint gurgling, bubbling or whirring sounds when
your Bushman is running. This is normal as the refrigerant is
being pumped through the refrigerant coils.
USING A GENERATOR
Only use a high quality pure sine wave generator to operate
your Bushman. Fluctuations in generator current will damage
the refrigerator and / or the 240V adaptor.
For fail safe operation with a generator we recommend running
a battery charger from your generator outlet to a 12 V battery,
and then running your Bushman directly from the battery.
USING THE CONTROL PANEL
Adjusting the set temperature
1. Flick the power switch to the ON position. The red power
light and blue screen will light up.
2. To display the set temperature, hold down the SET button.
3. To adjust the set temperature, hold down the SET button
whilst pressing either the UP or DOWN button until the
desired set temperature is displayed.
4. Pressing MAX COOL will set the temperature to -18oC
Cycle times
When your Bushman is running it will operate at 2˚C either
side of set temperature. For example, with your Bushman
set at 0˚C it will run until reaches –2˚C and then stop. The
green energy saving light illuminates when the compressor is
cycled off. The compressor will cut back in when the cabinet
temperature reaches +2˚C.
By running 2˚C either side of the set temperature the
compressor will not cut in and out excessively and this will
reduce your power consumption.
CLEANING
Internal Cleaning
Wash the inside of your Bushman with luke warm water and
a mild soap. Never use abrasive or corrosive cleaning agents,
steel wool or scouring sponges.
TROUBLE SHOOTING
RED LED ERROR LIGHT
From mid 2016 onwards all Bushman SC35-52 are fitted with a red LED error light inside the compressor compartment. If your
Bushman cuts out or will not operate, look inside the compressor compartment for a flashing red LED light. The number of
flashes corresponds to the following error type.
NO. OF
FLASHES
ERROR TYPE
1 BATTERY PROTECTION CUT-OUT
The voltage is outside the cut-out setting, Refer to VOLTAGE ISSUES below.
2 FAN OVER-CURRENT CUT-OUT
The fan loads the electronic unit with more than 0.5 A avg.
3 MOTOR START ERROR
The rotor is blocked or the differential pressure in the refrigeration system is too high ( 5 bar).>
4 MINIMUM MOTOR SPEED ERROR
Refrigeration system is too heavily loaded. Motor cannot maintain minimum speed approx 1,850 rpm.
5 THERMAL CUT-OUT OF ELECTRONIC UNIT
Refrigeration system too heavily loaded or ambient temperature is high. Electronic unit will run too hot.
6 THERMOSTAT FAILURE
If the NTC thermistor is short-circuit or has no connection.
CUT IN / CUT OUT
Your Bushman has built in battery protection and needs a
minimum 10.9 V to start and 9.6 V to continue operating.
During operation a load is placed on the power supply and
voltage can drop by as much as 2 V, especially if the wiring in
insufficient (less than 6mm direct to battery) or if there is a
loose connection somewhere.
If this occurs when you try and start your Bushman and the
power supply drops under 10.9 V it will not start. If this occurs
when your Bushman is running and the power supply drops
below 9.6 V it will stop.
COMMON 12V
POWER SUPPLY ISSUES
Wiring
Often the standard wiring from the car battery to the 12V outlet
is too small. A minimum 6mm automotive wiring should be
used and the earth should be wired directly back to the battery.
Battery
The car battery could be old, undersized or have a dead cell
causing too much voltage drop.
Connections
The 12 V plug, car 12 V socket or any of the connections
between the fridge and the battery could be faulty or have
come loose since installation.

Product specificaties

Merk: Bushman
Categorie: Vriezer
Model: Original SC35-52

Heb je hulp nodig?

Als je hulp nodig hebt met Bushman Original SC35-52 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Vriezer Bushman

Bushman

Bushman Original SC35-52 Handleiding

11 Juni 2023

Handleiding Vriezer

Nieuwste handleidingen voor Vriezer

Electrolux

Electrolux LUS7ME28X Handleiding

26 April 2024
Philco

Philco PCF 198 DFPI Handleiding

25 April 2024
Siemens

Siemens GS36NA31 Handleiding

21 April 2024
Dometic

Dometic DT-11 Handleiding

16 April 2024
Insignia

Insignia NS-UZ70SS4 Handleiding

16 April 2024
Dometic

Dometic DT-01 Handleiding

16 April 2024
Dometic

Dometic DT-20 Handleiding

16 April 2024
Dometic

Dometic DT-04 Handleiding

16 April 2024
Dometic

Dometic DT-03 Handleiding

16 April 2024
Dometic

Dometic DT-02 Handleiding

16 April 2024