Buffalo GC883 Handleiding

Bekijk gratis de handleiding van Buffalo GC883 (4 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 24 mensen en kreeg gemiddeld 4.1 sterren uit 2 reviews. Heb je een vraag over Buffalo GC883 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Please read and keep indoor use only. Don’tdiscard

the instruction

GC882 and GC883 Aluminium Heat Shades

OPERATING INSTRUCTIONS

INTRODUCTION

1.Read the instructions beforeusing the appliance.

2.Clean Heat Shadethoroughly before and after each use following the cleaning

instructions provided in this manual.

ELECTRICAL REQUIREMENTS

This product should only be connected to the mains electricity supply by a qualified electrician. Hardwire the

Heat Shade into a suitable power supply with correct voltage and sufficient power capacity. Refer to the

product label (serial plate) on the warmer for voltage and wattage requirements.

SAFETY INSTRUCTIONS

1.All power must be disconnected at power source before any service procedure is performed.

2.This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep

combustible materials, such as drapes and other furnishings, away from appliance.

3.Extreme caution is necessary when any appliance is used by or near children and whenever the

appliance is left unattended.

4.Always disconnectappliance before cleaning, maintaining and adjusting it.

5.Do not operate any appliance with a damaged cord or plug if the appliance malfunctions or has been

dropped / damaged.Return appliance to an authorised service facility for examination, electrical or

mechanical adjustment, or repair.

6.Do not use outdoors. This appliance is not intended for wet or moist locations. Never locate appliance

where it may fall into water.

7.Avoid the use of extensioncords. Do not run cord under carpeting, runners, or the like. Arrange cord away

from traffic area and where it will not create a trip hazard.

8.This appliance has electrical parts. Do not use it in areas where gasoline, paint, or flammable liquids are

used or stored.

9.This appliance is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or

instruction concerning use of the appliance by a person responsible for their safety. Children should be

supervised to ensure that they do not play with the appliance.

10.If the supply cord is damaged, it must be replaced by the manufacturer, it’s service agent or similarly

qualified persons in order to avoid a hazard

WARNING!

This unit only suitable for R40 or BR40 type incandescent lamps.

The lamp is excluded from the warranty.

Buffalo Telephone Helpline:- 0845 146 2887 (United Kingdom)

PREPARATION

1.Remove the Heat Shadeassembly from the carton.

2.Remove tape and protective packaging from all surfaces of unit.

3.Make sure the installation site providesthe proper installation

clearances for the unit

Product specificaties