Braun Saphir-Jet PV 2550 Handleiding

Braun Strijkijzer Saphir-Jet PV 2550

Lees hieronder de 📖 handleiding in het Nederlandse voor Braun Saphir-Jet PV 2550 (4 pagina's) in de categorie Strijkijzer. Deze handleiding was nuttig voor 28 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Saphir-jet electronic
PV 2550 Type 4693
Steam iron
English
Use Instructions
Guarantee
Service Centers
English
Super hard sole plate
Your Braun steam iron has a unique sole plate
made out of a special resistant alloy, polished
with sapphire particles. This process developed
by Braun makes the sole plate extremely durable
and scratch resistant. Even ironing over sharp-
edged fasteners, studs or zippers will not cause
scratches that may snag or damage sensitive
fabric. Thanks to its extra hardness, this sole
plate will maintain its easy gliding properties
throughout the life of the iron.
2 3
Our products are engineered to meet the
highest standards of quality, functionality
and design. We hope you thoroughly enjoy
your new Braun steam iron.
Notice: Should the sole plate of your model have
a protective plastic covering, take it off before
using the iron.
Important Safeguards
• Read all instructions carefully before using the iron. Keep the use instructions during the
entire life of the iron.
• Before filling with water, always disconnect the plug from the socket first.
• Always pull the plug and not the cord.
• Electric irons reach high temperatures during operation that could lead to burns.
• Keep the iron away from children, and when it is turned on, keep the unit under supervision.
• Disconnect the plug when leaving the room where you are ironing, even if it is only briefly.
• Never iron or dampen clothes while wearing them.
• During ironing pauses, always place the iron upright in its heel rest.
• Never immerse the iron in water or other liquids.
• The cord should never come into contact with hot objects or the sole plate.
• Check the cord periodically for possible damage.
• Do not use a damaged iron.
• Take it to a Braun Service Center for repair.
• Braun electric appliances meet applicable safety standards.
• This appliance can only be opened by an authorised Braun Service Centre for repairs.
• The cord of this appliance may only be replaced by an authorised Braun Service Centre since
special tools are required.
• Faulty, unqualified repair work may cause accidents or injury to the user.
• Make sure your voltage corresponds to that printed on the iron. Connect the iron to an alternating
current (~) outlet only.
Table of features for each model
Jet of steam
●
Shot of steam
●
Spray
●
Automatic shut-off
●
Specifications
Voltage/wattage: See typeplate at the
bottom of the unit.
Water tank capacity: 215 cc (approximately
1 filling beaker q
of water filled up to the
mark = 1 tank filling).
Description
1
Temperature selector
2
Water tank with sliding shutter opening
3
Water spray nozzle
4
Steam regulator / self-cleaning activator
5
Jet of steam button
6
2-function button
(water-spray/shot of steam)
7
Green pilot light
(temperature «thermostat»)
8
Yellow pilot light
(automatic shut-off «auto-off»)
9
Swivel cord
j
Heel rest
k
Cord storage/typeplate
l
Transparent water tank
L
Maximum marking («max.»)
m
Sole plate with 71 steam vents
n
Full-lenght button groove
o
Slim pointed tip
p
Jet of steam outlet
q
Filling beaker
jet
max
min
jet
saphir-jet
max
sc
shot
spray
shot
spray
jet
max
min
sc
shot
jet
876
5
4
3
2
1
16
15 17 14 13 12a
12
11
9
10
s
e
l
f
c
l
e
a
n
i
n
g
jet
jet
spray
shot
ba
g
f
c
d e
4
Automatic shut-o
Important: The automatic shut-off ist mercury-
free. The shut-off mechanism causes a slight
rattling noise in the iron during ironing. This
rattling noise is normal and in no case indicates
a fault of the iron.
The yellow pilot light 8
will flash when the
automatic shut-off is activated within
approximately:
– 30 seconds – if the iron is standing
horizontally on its sole plate and not being
moved.
– 15 minutes – if the iron is left standing upright
on its heel and not being moved.
To turn the iron on again: Move the iron briefly
and the yellow pilot light 8
stops flashing. This
means that the electrical power is on again. You
can continue ironing as soon as the previously
selected temperature has been reached.
Praktical Guidelines
Type of Water to be Used
This iron is designed for tap water. However,
if you have hard water we recommend to use a
mixture of 1/2 part tap water and 1/2 part distilled
water from drug stores or grocery stores.
Important: Never use distilled water (battery
water). Do not add any additives (e. g. starch) to
the water.
To fill iron
1. Pull the plug out of the wall outlet.
2. Put the steam regulator 4
in position «
•
»
(= steam off).
3. Open sliding shutter 2
.
4. Place the iron in the upright position and fill
with water slowly through the tank opening
2
to the «max.» marking L
(a), using the
beaker q
.
5. Close sliding shutter.
Selecting the temperature
Connect the iron to a safely located wall outlet
and select the ironing temperature with the
temperature selector 1
(b). As soon as the
green pilot light 7
goes out, the iron has
reached the temperature selected. To avoid
water dripping, always rest the iron upright while
heating it up keep the steam regulator 4
in
position «
•
» (= steam off) (c).
You will usually find the following symbols in your
garments:
The temperature selector 1
is marked with
these symbols:
min. The iron is connected
●
Synthetics (acrylic, acetate)
●●
Silk/rayon/nylon/polyester/
cotton blends/wool
●●●
Cotton/linen
max. Linen
Select the temperature you need according to
these symbols.
Spray, shot of steam, jet of steam
Before you start ironing, we recommend to press
the buttons 3 or 4 times, in order to activate
these functions.
Dry ironing
Set the steam regulator 4
in position «
•
»
(= steam off) (c) for dry ironing. The water
spray 6
may be used at any temperature
setting to dampen the laundry. The jet of steam
5
and the shot of steam 6
buttons can be
activated during dry ironing, provided that the
temperature selector 1
is within the continuous
red area
Steam ironing
Temperature selection: Set the temperature
selector 1
within the red
range steam (b) and wait
until the iron has reached the selected
temperature (i. e. the green pilot light 7
goes
off). Steam ironing is possible in the entire red
range. Steam ironing at lower temperatures may
cause water drops instead of steam. Should this
happen, turn the steam regulator 4
to the
position «
•
» (= steam off) (c).
Steam regulator 4
:
Select the quantity of
steam required (c) for
each garment with the
steam regulator 4
. You
can increase the quantity
by turning the steam
regulator clockwise (wide
markings) to the end of the red marking.
Caution: While ironing do not turn the steam
regulator further, otherwise hot water may come
out from the sole plate (see section
«Decalcifying/Self-cleaning»).
By turning the steam regulator anti-clockwise
you can reduce the quantity of steam or turn the
steam off «
•
» (= steam off) (see «Ironing
Guide»).
Constant steam: Your Braun steam iron is
equipped with a special tank configuration to
5
provide constant steam even when the water
level in the tank is low.
Jet of steam*
(coming from the
outlets p
at the slim
pointed tip o
):
Caution: Keep children
away from the jet of
steam and do not hold
your fingers in front of the
outlets p
when activating this function.
When ironing within the red range
area the jet of steam function can
be used (d). To do so, press the button 5
at
intervals of no less than 5 seconds. The jet of
steam has been designed not only for steaming
hard to reach areas like pleats, inside of pockets
etc., but also for steaming hanging clothing (e. g.
velvet skirts, curtains etc.) (f). The jet of steam
functions between horizontal and upright
positions. Be careful not to touch sensitive
textiles with the hot sole plate.
Spray / shot of steam
2-function button:
The functions «water
spray» and «shot of
steam» can be activ-
ated with a 2-function
button. The desired
function can be selected
by turning the button 6
as far as it will go. The
marking (blue = water
spray or red = shot of
steam) must point to the
respective function (e).
Turn the button from blue
(spray) to red (shot of
steam) anti-clockwise
and from red to blue clockwise (e).
Shot of steam*
(coming from the vents
in the sole plate):
When ironing within the
red area
the shot
of steam function can be
used. It gives an extra,
particularly powerful shot of steam penetrating
deep into the textiles in order to straighten
creases, collars and pleats. The function «shot
of steam» can be used in normal ironing and
also horizontally for steaming hanging clothing
(e. g. velvet skirts, curtains etc.) (f). Press the
shot of steam button 6
at intervals of no less
than 5 seconds. When steaming be careful not to
touch sensitive textiles with the hot sole plate.
* If pressed too frequently, it can drip.
Should this happen, wait a few seconds
before using it again.
Spray (coming from the
nozzle 3
): The spray
function can be used at
any temperature, to
dampen laundry. To do
so, press the button 6
(water spray = blue).
Storage
After ironing, always pull the plug out of the wall
outlet. Set the temperature selector 1
to «min.»
(b) and the steam regulator 4
to «
•
» (= steam
off) (c).
To empty the iron hold it with the open water tank
opening 2
downwards (g) and shake it 1 or 2
times. The swivel cord 9
conveniently winds up
around the cord storage k
.
IMPORTANT: Store the cool steam iron in a dry
place and always standing on its heel rest
j
.
The sole plate may be damaged by remaining
water if it is stored horizontally. The warranty
does not cover faults or damage resulting from
improper storage of the iron.
Maintenance and Cleaning
To remove residues of minerals/starch from the
sole plate always use steel wool. Never use a
scouring pad, vinegar or other chemicals. The
steam vents m
and jet of steam outlets p
may
be cleaned manually with a toothpick, if
necessary. Clean the sole plate regularly if you
use starch or other aids on the clothes for
ironing.
Decalcifying / Self-cleaning
Braun automatic shut-off irons have a built-in
system (anti-calc. valve) to prevent calcification.
It allows you to clean residues from the steam
chamber. Do not use commercial decalcifiers;
they may damage the sole plate.
We recommend to use the self-cleaning function
every 3 months.

Product specificaties

Merk: Braun
Categorie: Strijkijzer
Model: Saphir-Jet PV 2550

Heb je hulp nodig?

Als je hulp nodig hebt met Braun Saphir-Jet PV 2550 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Strijkijzer Braun

Braun

Braun CareStyle 7 Pro IS 7285 Handleiding

12 Juli 2023
Braun

Braun CareStyle 3 Pro Handleiding

25 April 2023
Braun

Braun TexStyle 7 SI 7066 Handleiding

8 April 2023
Braun

Braun TexStyle 5 SI 5006 BL Handleiding

19 Maart 2023
Braun

Braun CareStyle 1 IS 1012 Handleiding

12 Maart 2023
Braun

Braun TexStyle 7 TS 725 Handleiding

1 Februari 2023
Braun

Braun CareStyle 7 IS 7043 Handleiding

6 December 2022
Braun

Braun TexStyle 7 SI 7088 Handleiding

3 December 2022
Braun

Braun CareStyle 3 IS 3132 Handleiding

3 December 2022
Braun

Braun CareStyle 7 IS 7055 Handleiding

27 Oktober 2022

Handleiding Strijkijzer

Nieuwste handleidingen voor Strijkijzer

Di4

Di4 Jet Pressing 2850W Handleiding

15 April 2024
Di4

Di4 Vapore Stiro 3000 Handleiding

15 April 2024
Di4

Di4 Jet Pressing Infinity Handleiding

15 April 2024
Di4

Di4 Jet Pressing Facile Handleiding

15 April 2024
Di4

Di4 Jet Pressing Pro 5b Handleiding

15 April 2024
Melissa

Melissa 16390057 Handleiding

11 April 2024
Hacienda

Hacienda CSI232 Handleiding

11 April 2024
Bosch

Bosch Serie 8 VarioComfort TDS8060DE Handleiding

9 April 2024
Essentiel B

Essentiel B Iris EFV 2402 Handleiding

9 April 2024
Philips

Philips Perfective GC5010 Handleiding

5 April 2024