Bobrick B-169 Handleiding

Bekijk gratis de handleiding van Bobrick B-169 (3 pagina’s), behorend tot de categorie Spiegel. Deze gids werd als nuttig beoordeeld door 34 mensen en kreeg gemiddeld 4.3 sterren uit 3 reviews. Heb je een vraag over Bobrick B-169 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

continued . . .

PARTS/TOOLS NEEDED:

Sidelit MirrorMounting HardwareElectric DrillRomex Connector

Finished Floor

40"

40"

IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS

Read all instructions before using this mirror.

MIRRORS SHOULD ONLY BE INSTALLED USING THE FOLLOWING INSTRUCTIONS.

FAILURE TO FOLLOW THESE INSTRUCTIONS WILL VOID THE WARRANTY.

WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons:

• Turn o power before putting on or taking o parts.

• Close supervision is necessary when this mirror is used by, or near children, invalids, or disabled persons.

• Use this mirror only for its intended use as described in these instructions. Do not use attachments not recommended by

Bobrick.

• This product shall be installed by a licensed electrician in accordance with local codes and regulations.

• Never operate this mirror if it has damaged wires, if it is not working properly, if it has been dropped or damaged, or dropped

into water. Contact Bobrick for a replacement mirror.

• Never drop or insert any object into any opening.

• Do not use outdoors.

• Exposing the mirror edges to liquids may cause a permanent discoloration to the mirror etching that is NOT covered by

Bobrick warranty.

• Electrical Specs: 100-277V | 50/60HZ | 100W Max | 1.3A Max

CLEANING INSTRUCTIONS

• Clean mirrors with warm water and a soft, lint free cloth, do not allow liquids to seep under the edges. Don’t use abrasive, acid or

alkali cleaners or products with ammonia or vinegar.

• Apply mild cleaners directly to a cloth, do not spray directly on the mirror. Applying liquids directly to the mirror’s surface may allow

the liquid to seep/wick between the layers on the edge of the mirror. If this occurs there may be a permanent discoloration on the

mirror etching which is NOT covered by Bobrick warranty.

• Dry mirror immediately following cleaning and make sure all joints and edges are dry.

ADA requires that “Mirrors shall be mounted with the bottom edge of the

reflecting surface no higher than 40 (1015mm) above the finished floor.”

For lit mirrors this means the dimension is to the inner most edge of the lit

portion (not required by cULus).

1. Mark the location of the mounting holes. See individual

product specifications on page two for mounting hole

locations. Two bar mirrors can only be mounted in

portrait orientation.

NO

YES

INSTRUCTIONS FOR INSTALLATION

BOBRICK MODEL B-169 SIDELIT MIRROR

Product specificaties