Blaupunkt XLf 220 A Handleiding

Blaupunkt Subwoofer XLf 220 A

Lees hieronder de 📖 handleiding in het Nederlandse voor Blaupunkt XLf 220 A (8 pagina's) in de categorie Subwoofer. Deze handleiding was nuttig voor 20 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8

VELOCITY POWER

ACTIVE SUBWOOFER

XLf 220 A

Operating and Installation Instructions

Proper system planning is vital in order to maximize the

device’s performance and road safety. Plan your installa-

tion carefully to avoid compromising performance reli-

ability of the system. Consult an authorized Blaupunkt

dealer for installation or reparation. Read the manual

carefully before operating the device for the rst time.

Safety Notes

Ensure to follow below safety notes during

installation and wiring connection : -

•

Installation and Connection Instructions

•

Voltage Supply

•

Integrated Fuse

The integrated fuse in the device protects the

output voltage and the entire electrical system in

case of malfunction. Do not replace damaged

fuse with higher current.

CAUTIONS

Switching On/O

This device will automatically turn on if a music

signal is detected. The device will also

automatically turn o if no music signal is received.

Remote Control

Disclaimer

In no event shall Blaupunkt be liable for any direct,

indirect, punitive, incidental, special consequential

damages to property or life and whatsoever arising out

of or connected with the use or misuse of our products.

USA & CANADA: This product is not intended for sale in

the United States and Canada. If purchased in the U.S. or

Canada, this product is purchased on as-is basis. No

warranty, whether expressed or implied is provided in

the U.S. or Canada.

Recycling and Disposal

Do not dispose of your old unit in the

household trash!

Use the return and collection systems

available to dispose of the old device.

This manual may be updated from time to time without

any notice.

Disconnect the negative terminal of the

battery. Refer to the safety notes of vehicle

manufacturer.

Ensure positions of the holes are nowhere

near the vehicle component to avoid any

damage during drilling.

Ensure cross section of the cable is no less

than 2.5mm if the positive and negative

cables are too long.

Incorrect installation may result in

malfunction of the device or the car sound

system.

Select a dry and well-ventilated location

to install the device.

The device must not be installed in overly

exposed location such on the rear shelf,

rear seat etc.

The installation location must be suitable for

screw holes and have stable ground support.

Use the supplied power extension cable to

connect to the positive battery terminal.

Firmly and carefully connect the ground lead

to a bare metal point on the vehicle chassis.

The control of the device should be a

two-channel control, either via the preamplier

outputs or the loudspeaker, output of the car

sound system.

A control solely via the right or left channel is

also possible since the low-frequency portion

of the music is generally identical on both

channels.

•

Gain adjustment :

Turn the gain knob to adjust

the volume to the desired

level.

Phase (0° ~ 180°)

Frequency (50Hz ~ 100 Hz)

Input Gain (200mV ~ 6V)

Remote Control

RCA Input (LCH, RCH)

High Input

Fuse (15A)

+12V Battery

Remote (Turn-on)

Ground (Chasis)

FUNCTIONS CONTROLLING DIAGRAM

10.

1 2 3 5 6 7 8 9 10

SPECIFICATION

Speaker Size : 8”

Cone Composition : Aluminium

Magnet Type : Ferrite

Enclosure Housing Material : Aluminium

Enclosure Dimension (L x W x H) : 504 x 340 x 85mm

Enclosure Net Weight : 5kg

Amplier Technology : Class AB

Normal Output Power (RMS) : 220W

Max Output Power : 550W

Audio in Sensitivity : RCA input 82mV, Speaker

input 0.8V

Signal/Noise Ratio : 91dB

Output Impedance : Dual (2 ohms+2 ohms)

Frequency Response : 30Hz-150Hz

Low Pass Filter (LPF) : 50Hz-100Hz

Voltage : 14.4V (10V-16V)

Phase Switch : 0° /180°

Automatic On/O : High Level Only

Fuse Rating : 15A

Gain : 200mV ~ 6V

Thermal Short & Overload Protection Circuits :

Included

Remote Controller : Wired

Screws (Parker-Type) : 14 x (M5 x 18mm)

Screws (M-Type) : 4 x (M4 x 50mm)

Overall Net Weight : 9kg (Without accessories)

Dual Subwoofer

•

Amplier

•

Accessories

•

Product specificaties

Merk:	Blaupunkt
Categorie:	Subwoofer
Model:	XLf 220 A

Heb je hulp nodig?

Als je hulp nodig hebt met Blaupunkt XLf 220 A stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Subwoofer Blaupunkt

Blaupunkt XLc 200 A Handleiding

10 Mei 2023

Blaupunkt XLf 150 A Handleiding

27 April 2023

Blaupunkt GTr 110 A Handleiding

21 April 2023

Blaupunkt TW 1600.4 Handleiding

20 April 2023

Blaupunkt Txt 1500.4 Handleiding

23 Februari 2023

Blaupunkt GTr 130 A Handleiding

11 Februari 2023

Blaupunkt XLc 170 A Handleiding

27 Januari 2023

Blaupunkt GBW120 Handleiding

23 Januari 2023

Blaupunkt XLf 220 A Handleiding

3 December 2022

Blaupunkt XLf 200 AW Handleiding

1 December 2022

Handleiding Subwoofer

Nieuwste handleidingen voor Subwoofer

RCF S 19 Handleiding

10 April 2024

RCF S 29 Handleiding

10 April 2024

KEF KC92 Handleiding

6 April 2024

Klipsch Reference Premiere RP-1200SW Handleiding

3 April 2024

Klipsch Reference Premiere RP-1000SW Handleiding

3 April 2024

Velodyne Deep Waves 10 Handleiding

27 Maart 2024

Klipsch PRO-1000SW Handleiding

27 Maart 2024

Totem KIN Sub Handleiding

27 Maart 2024

Velodyne Deep Waves 12 Handleiding

27 Maart 2024

Kanto SUB8V Handleiding

27 Maart 2024