Black Decker SG100 Handleiding

Bekijk gratis de handleiding van Black Decker SG100 (1 pagina’s), behorend tot de categorie Strijkijzer. Deze gids werd als nuttig beoordeeld door 3 mensen en kreeg gemiddeld 4.0 sterren uit 2 reviews. Heb je een vraag over Black Decker SG100 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Troubleshooting Tips

(SG100 / SG200)Copyright © 2001 Applica Consumer Products, Inc.Pub.#175659-00-RV00Printed in Italy

Save

This Guide

PROBLEMPOSSIBLE CAUSESOLUTION

Water leaking from Condensation has built up in theHold the iron away from your

the soleplate.Steam Hose because of a long pauseironing board and press the steam

(greater than 5 mins.) in ironing.button until it produces steam.

Temperature is too low.Move the Dial to the “Steam Band”

between blend and linen.

Boiler Water Tank is too full.Don’t fill the Tank to the top.

Boiler Water TankThe Power is not on.Press the ON/OFF button.

won’t heat.

The outlet is activated by a wall Plug a lamp into the outlet and see

switch or is not working.if it lights. Or, flip the wall switch.

Iron won’t startThe Boiler didn’t preheat long Allow it to preheat for 10 minutes.

steaming.enough.Wait until the Temperature Light

goes out. On some models, a Steam

Ready Indicator light will come on.

There may not be enough water inCheck the water level and fill,

the Tank.if necessary.

You may not have held the SurgePress and hold the Surge of Steam

of Steam button long enough.button 5-10 seconds. This is

important for each new ironing

session.

Steam or hissing fromSafety Fill Cap may not be on tight.After filling, be sure to tighten the

the Safety Fill Cap.Safety Fill Cap closed.

You may have tried to open theContinue ironing with full Steam

Safety Fill Cap before using up allbefore opening the Safety Fill Cap.

the steam.It’s normal to get a little hissing

when you first open the Cap.

Brown streaksYou are using a chemical descalingNever use this type of product;

coming from theagent.it can damage the steam

holes in the soleplate.generator iron.

Tap water may be high in iron or rust.Try distilled water. Never use

additives in the water for ironing

(lavender water, etc.).

There are small charred bits of fabricClean the soleplate.

built up in the soleplate holes or in

the space between the iron cover

and the soleplate.

The iron soleplateYou may be using too high a Use the fabric guide on the iron to

looks dirty ortemperature.choose the right setting for your

brown; it may stainfabric.

your fabric.

You may be using starch incorrectly.Always spray starch on the

underside of the fabric to be ironed.

ANY QUESTIONS? Call 1-800-231-9786

Steam

Generator

Iron

Product specificaties