Black And Decker BDBBC2C Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Black And Decker BDBBC2C (48 pagina's) in de categorie Acculader. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/48
English 2
Deutsch 5
Français 9
Italiano 13
Nederlands 17
Español 21
Português 25
Svenska 29
Norsk 32
Dansk 35
Suomi 38
Ελληνικά 41
2
ENGLISH
English
Intended use
Your Black & Decker ‘Car to Car Simple Start’ is designed to
boost a depleted battery on a host vehicle from a donor
vehicle.
Note: This unit will not start a flat battery.
Safety instructions
Warning! When using battery-powered appliances, basic
safety precautions, including the following, should always be
followed to reduce the risk of fire, electric shock, personal
injury and material damage.
Read all of this manual carefully before using the
appliance.
The intended use is described in this manual. The use
of any accessory or attachment or the performance of
any operation with this appliance other than those
recommended in this instruction manual may present a
risk of personal injury.
Retain this manual for future reference.
Using your appliance
Always take care when using the appliance.
This appliance is not intended for use by young or in firm
persons without supervision.
The appliance is not to be used as a toy.
Use in a dry location only. Do not allow the appliance to
become wet.
Do not immerse the appliance in water.
Do not open body casing. There are no user serviceable
parts inside.
Do not operate the appliance in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust.
To reduce the risk of damage to plugs and cords never
pull the cable to remove the plug from a socket outlet.
After use
When not in use, the appliance should be stored in a
dry, well ventilated place out of the reach of children.
Children should not have access to stored appliances.
When the appliance is stored or transported in a vehicle
it should be placed in the boot or restrained to prevent
movement following sudden changes in speed or
direction.
The appliance should be protected from direct sunlight,
heat and moisture.
Inspection and repairs
Before use, check the appliance for damaged or
defective parts. Check for breakage of parts, damage to
switches and any other conditions that may affect its
operation.
Do not use the appliance if any part is damaged or
defective.
Have any damaged or defective parts repaired or
replaced by an authorised repair agent.
Never attempt to remove or replace any parts other than
those specified in this manual.
Specific safety instructions for battery chargers
Read these instructions before use:
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the battery charger to water.
Do not open the battery charger.
Do not probe the battery charger.
Batteries
Warning! Never attempt to charge a frozen battery.
Never attempt to open for any reason.
Do not expose the battery to water.
Warning! Battery fluid is a diluted sulphuric acid and may
cause personal injury or damage to property. In case of skin
contact, immediately rinse with water. If redness, pain or
irritation occurs seek medical attention. In case of eye
contact, rinse immediately with clean water and seek
immediate medical attention.
When disposing of batteries, follow the instructions given in
the section ‘Protecting the environment’.
Warning! Risk of explosive gas mixtures. Working in the
vicinity of a lead-acid battery is dangerous. Batteries
generate explosive gases during normal battery operation.
For this reason, it is of utmost importance that each time, you
read this manual and follow the instructions exactly.
Use of an attachment not recommended or sold by Black &
Decker may result in a risk of fire, electric shock, or injury to
persons.
Warning! A marine (boat) battery must be removed and
charged on shore. To charge it on board requires equipment
specially designed for marine use. This appliance is NOT
designed for such use.
Vehicles may have electrical and electronic systems
(e.g. engine management system, mobile phone) that
may be damaged if subjected to high starting voltages
and voltage peaks. Before connecting the appliance to
the vehicle read the vehicle's owner's manual to confirm
that external-starting assistance is allowed.
3
ENGLISH
Follow these instructions and those published by the
battery manufacturer, vehicle manufacturer and
manufacturer of any equipment you intend to use with
this unit. Review warning labels on these products and
on the vehicle.
This appliance is not designed to be used as a
replacement for a vehicular battery. Do not attempt to
operate a vehicle that does not have a battery installed.
The appliance must only be connected to a 12 V lead-
acid battery. Do not use the appliance for charging dry-
cell batteries that are commonly used with home
appliances. These batteries may burst and cause injury
to persons and damage property.
Warning! Explosive gas may be vented from the lead-acid
batteries when charging and under extreme conditions
battery leakage may occur. Make sure that the area is well
ventilated when conducting jump starting and charging
procedures.
The following symbols are marked on the appliance:
Features
1. Power LED indicator
2. Boosting LED indicator
3. Plug storage
4. Cord storage
5. 12 Vdc accessory plugs
6. Housing
Use
Warning! Make sure that the car is in neutral and the parking
brake is applied.
Step 1
Connect the black 12 Vdc accessory plug (5) into the
12 V outlet on the working vehicle and make sure that
the power LED (1) lights.
Start the engine on the working vehicle.
Step 2
Warning! Make sure that car is in neutral and the parking
brake is applied.
Fully unwind the cord from the cord storage (4) and
connect the orange 12 Vdc accessory plug (5) into the
12 V outlet on the dead vehicle and make sure that the
boosting LED (2) lights.
Step 3
When the dead car is sufficiently boosted to start the
engine both the power LED (1) and the boosting LED (2)
will change colour to green (approx. 20 minutes).
Remove the orange 12 Vdc accessory plug (5) from the
dead car and try starting the vehicle in 3-5 second
bursts.
Note: The housing (6) and the 12 Vdc accessory plugs (5)
will become warm during the boosting process. This is
normal.
Step 4
Remove the black 12 Vdc accessory plug (5) from the
working car and coil the cable around the cord storage
(4) and fit the 12 Vdc accessory plugs (5) into the plug
storage apertures (3).
Maintenance
Your Black & Decker tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
care and regular cleaning.
Warning! Before performing any maintenance or cleaning
on the appliance, unplug the appliance.
From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do
not immerse the appliance in water.
Clean the outside case with a soft cloth and, if
necessary, mild soap solution.
Do not allow liquid to enter the unit. Do not operate
when the unit is wet.
Keep the cords coiled during storage to prevent damage
to the cords.
Troubleshooting
If the power and boosting LED’s (1 & 2) do not light up check
the following:
Check that the donor vehicles 12 V accessory socket is
live, some cars require the key to be in the accessory
position before the socket is live.
Check that the 12 Vdc accessory plugs (5) are fully
inserted.
Check for blown fuses in the 12 Vdc accessory
plugs (5).
If your car fails to start:
Repeat steps 2-4 in the ‘use’ section and continue the
boosting process for a further 10 minutes or until the
LED’s change to green.
If your car still fails to start we suggest you have your
battery checked by a qualified auto-electrician.
Power LED indicator.
Boosting LED indicator.


Product specificaties

Merk: Black And Decker
Categorie: Acculader
Model: BDBBC2C

Heb je hulp nodig?

Als je hulp nodig hebt met Black And Decker BDBBC2C stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Acculader Black And Decker

Handleiding Acculader

Nieuwste handleidingen voor Acculader