BEKO WB 6006 RS Handleiding

BEKO Wasmachines WB 6006 RS

Lees hieronder de 📖 handleiding in het Nederlandse voor BEKO WB 6006 RS (4 pagina's) in de categorie Wasmachines. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Dear Customer,
We wish that this product, manufactured at modern facilities with Total Quality Notions, will deliver you the best
performance. In order to guarantee this, please read this instruction booklet thoroughly and keep it for your
future reference.
Control Panel
1. Top lid
2. Auxiliary function buttons
3. Thermostat adjustment knob
4. Program selection knob
5. Detergent dispenser
6. Front door
7. Door Handle
8. Kick plate
9. Kick plate opening screw
Technical Features
Capacity (dry fabric) (kg.)
Height (cm.)
Width (cm.)
Depth (cm.)
Net weight (kg.)
Power requirement
Nominal current (A)
Power (W)
Washing speed (rpm)
Spin speed (rpm)
5
85
60
54
67
2 0 V,50 Hz.3
10
2250
70
600
WB 6006 RS
Program
selection knob
Temperature
adjustment
knob
On/off button
Detergent drawer
Rinse hold button
No spin button
Led indicator
The appearance and specifications are subject to
change without notice to raise the unit quality. The
graphics shown in the manual are schematic and
it is possible that they not conform with your
washing machine.
6
2 3 4
5
1
7
F U L L Y A U T O M A T I C W A S H I N G M A C H I N E
8
9
No
Spin
WB 6006 RS
On / Off
Rinse
Hold
No
Spin
WB 6006 RS
On / Off
Rinse
Hold
Plastic plugs, supplied inside the protective bag and
designated as “P”, should be placed in the safety bolt
holes according to the direction shown.
Attention! Please keep the safety bolts for future
transportation
and reinstate them before transporting your machine.
Never transport your machine without the transport
bolts in position. Any resultant damage is not covered
by the warranty.
1. Removing transport safety bolts at the rear of the machine
3. Water connections
a) Water inlet hoses
Feet adjustment
b) Drain hose
4. Stability
To ensure quiet and stable operation, the machine should be
positioned correctly and levelled on its feet. Your machine
comes with two adjustable feet. If the machine is unstable,
loosen the plastic lock nut and screw or unscrew the adjustable
foot until the machine is levelled perfectly. After positioning,
tighten the lock nut for stability. Ensure a clearance is present
each side of the machine to allow slight side ways movement
during washing and spin drying operations.
2. To open the door,
Make sure the on/off switch is in the off position, always allow one to two minutes for the door safety lock
to release the lock. Pull the handle to open the door.
Washing Machine is to be connected to
the water mains using new hose-sets and
old hose-sets should not be reused.
The transport safety bolts must be
removed before any operation of the
machine. Bolt heads, marked “C”.
“C”, should be turned in an anti
clockwise direction until the bolt
can be partially withdrawn.
Remove transport safety bolts and rubber
bushes by pulling outwards. (An up/down
action and a small squirt of washing up
liquid should ease removal.)
The drain hose should be placed and secured
either at the side of the hand basin or directly
to the drain. The hose should not be bent.
The waste pipe must
only be connected into
the foul drains not
surface water drainage
system.
The hose should
be placed between
60 and 100 cm.
from the ground,
and must not be extended.
Otherwise the machine
may not empty the waste
water.
P
C
C
100 cm
60 cm
Attention! Never place your machine
on a carpet. This prevents air circulation.
The electrical components of the machine may
overheat and may cause damage.
For proper operation,
the pressure of water should be
between 1 and 10 atm. (1 atm
corresponds to more than 8 liters per
minute ow rate at fully open tap.)
To prevent water
leaks two rings are supplied
with the water inlet hose inside the
machine, Place these rings on
each side of the hose and tighten
both ends fully.
In order to
prevent any water leak damages,
keep the water taps closed when
not in use. Connect the cornered
end of the hose to the machine
water inlet.
Your machine
comes with only cold
water connection. Find the
blue hose supplied by the
manufacturer for water
connection. Connect the
cold water using the
blue hose.
No
Spin
WB 6006 RS
On / Off
Rinse
Hold
Detergent dispenser
a. Compartment I. detergent
compartment for prewash cycle.
b. Compartment II. detergent
compartment for wash cycle.
c. " " Compartment for fabric softener.
d. Siphon.
6. Operation
Select the program
Attention!
Before any operation
of the machine check the
following.
A-Did you close the front
door?
B-Is the tap open?
C-Is water drain hose placed
properly?
D- Is power connected?
No Spin
If you press this button, spinning program will not be executed.
5. Electrical connection
Connect the power cord to the appropriate electrical socket with an
equivalent current rating indicated at the back of the machine.
(•) Options available
Program selection table
A
PROGRAMMES
B
X
M
C
D
F
G
J
H
K
DISPENSER
COMPARTMENT
I + II
II
II
II
I + II
II
II
RINSE HOLD
*
*
*
*
LOAD kg.
Normally soiled cottons and linens
Lightly soiled cottons and linens
FABRIC TYPE
Heavy soiled cottons and linens
Very lightly soiled and linens
Heavy soiled synthetics and delicates
Normally soiled synthetics and delicates
Lightly soiled synthetics and delicates
5
2
.
5
S
N
SYNTHETICS
COTTON
Prewash
Mainwash
Colorfast
Rapid wash
Cold wash
Spin
Prewash
Main wash
Rapid wash
Cold wash
Spin
Main wash
Pump-spin
Lightly soiled linens
5
5
5
5
2
.
5
2
.
5
2
.
5
1.
5
Lightly soiled synthetics and delicates
Woolens
Pump-spin
*
NO SPIN
*
*
*
*
*
*
*
*
*
*
*
TEMPERATURE °C
II
II
II
Rinse Hold Button
If you desire to leave your synthetic / woolen, delicate
fabrics in the machine after the
wash program you may select the Rinse hold button to prevent them getting wrinkled.
To continue the program, you can either press the Rinse hold button again or select
H /K on the program selection knob to discharge the water.
Fill the fabric
softener to the marking. Do not
overll above the max mark as any excess
amount will mix into the wash water and you will
have to re-ll the compartment. Concentrated
softener may clogg the siphon, in this case
add some water to the
softener liquid.
Turn the knob clockwise to
select the required program
O p t i o n a l f u n c t i o n s
It is possible to smell an odour caused by motor during rst few cycles.
It is a transient situation.
This should not be supposed to be a fault!
There is one heating step of 10-20
minutes without drum rotation in all
wash programs. This should not be
regarded as a fault.
S
oftener
Rinse
Max 90 °C
Max 60 °C
Max 40 °C
Max 60 °C
Max 40 °C
Max 40 °C
No
Spin
On / Off
Rinse
Hold
Make sure that you have
grounded power outlet.
The program can be started by pressing the On/Off
knob to “ON” position. The door will be locked and
the indicator will light. The indicator will turn off
automatically at the end of program cycles.
WOOLEN / DELICATE
*


Product specificaties

Merk: BEKO
Categorie: Wasmachines
Model: WB 6006 RS

Heb je hulp nodig?

Als je hulp nodig hebt met BEKO WB 6006 RS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasmachines BEKO

Handleiding Wasmachines

Nieuwste handleidingen voor Wasmachines