BeamZ S1800VH DMX Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor BeamZ S1800VH DMX (8 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 115 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
- 1 -
S1800VH DMX
160.496
INSTRUCTION MANUAL
GEBRUIKSAANWIJZING
BEDIENUNGSANLEITUNG
- 2 -
Warning:
- The smokemachine must be placed at least 100 cm away from inflammable materials such as curtains,
books, etc. Make sure that the housing cannot be touched by accident.
- For indoor use only.
- During installation, nobody should stand beneath the mounting area.
- Prior to the first use, have the unit checked by a qualified person.
- The unit contains voltage carrying parts. DO NOT open the smokemachine
- Never plug or unplug the unit with wet hands.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains
outlet. It needs to be repaired by a qualified technician.
- Only connect this unit to an earthed mains outlet of 230Vac/50Hz .
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside the housing.
Please let the unit reach room temperature prior to use.
- When you unplug the unit from the mains always pull the plug, never the lead.
- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid
chain, a steel cable, etc. which has to be fastened separately from the mounting bracket.
- The supplied bracket is the main fixing and must be used to solidly mount the light effect.
- In order to avoid accidents in public premises, the local legal requirements and safety
regulations/warnings must be fulfilled.
- Keep out of the reach of children.
Safety
Plug the smoke machine only in an earthed mains outlet or extension cord! ATTENTION: the powercord can
only be replaced by an original replacement, supplied by Tronios.
Be careful when filling the fluid tank. First of all, unplug the mains lead! Then unscrew the cap on the tank and
fill it by means of a funnel.
Only use the original Skytec smoke fluid which is environmental friendly and, if used correctly, leaves no
residues.
Do not obstruct the openings on top of the case to guarantee a good ventilation. The heating element of the
smoke machine generates heat which needs to be removed. Dont put any objects on the smoke machine.
Installation and Use
Unpack the fog machine. Do not connect yet the net cable. Connect the lead of the manual control with the 3-
pin plug at the rear of the smoke machine. Fill the fluid tank by means of a funnel. Plug the unit into a mains
outlet. Thus the heating element is automatically switched on. Depending on the room temperature, it takes
about 5 to 10 minutes until the working temperature is reached. Then the thermostat is clicking and the LED on
the manual control lights up.
Push the switch once and the smoke machine will produce a nice thick fog. Once the smoke machine has
reached its working temperature (the LED is lit) the smoke machine can produce continuously fog during about
2 minutes.
After this period of time, the fog generator is cooled so much down that the thermostat switches off. Wait a few
minutes until the working temperature is reached again. It is recommended to produce smoke with small pauses
in between so that the temperature is maintained and the thermostat doesn’t switch off.
Location
Select a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied
holder and fixing screws.
Switching the unit off
Switch the unit off by unplugging it from the mains. Otherwise the 1800W heating element will draw
unnecessarily current.
- 3 -
Specifications
Power supply: ................................................... 220-240V~/50Hz
Heating element:......................................................... 1800 watts
Heat up time: ...........................................................5-10 minutes
Continuous use:................................................... Max. 2 minutes
Smoke production:..........................................ca. 200 m3/minute
Tank capacity:............................................................ ca 2.5 liters
Dims:.............................................................420 x 263 x 142mm
Weight.................................................................................8.9 kg
Accessories
Smoke fluid, high quality fluid on water basis, specially designed for Beamz smoke machines. Guarantees a
trouble-free use.
5 liter packaging, ref. no. 160.583
1 liter packaging, ref. no. 160.644
Flavor, adds a pleasant fragrance to the air. One bottle is sufficient for 5 liter smoke fluid.
coconut 160.650 tropical 160.653
mint 160.651 strawberry 160.654
vanilla 160.652
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
Do not attempt to make any repairs yourself. This would invalid your warranty.Do not make any changes to the unit. This would also
invalid your warranty.The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the
warnings contained in this manual.Tronios BV cannot be held responsible for personal injuries caused by a disrespect of the safety
recommendations and warnings. This is also applicable to all damages in whatever form.


Product specificaties

Merk: BeamZ
Categorie: Niet gecategoriseerd
Model: S1800VH DMX

Heb je hulp nodig?

Als je hulp nodig hebt met BeamZ S1800VH DMX stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd BeamZ

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd