Bazooka FAST-9999 Handleiding

Bekijk gratis de handleiding van Bazooka FAST-9999 (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 106 mensen en kreeg gemiddeld 4.2 sterren uit 9 reviews. Heb je een vraag over Bazooka FAST-9999 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

How to install the FAST-9999 with the FAST-BTAH

The FAST-9999 universal harness uses the patented Posi-Tap connector from Posi-Products for making

FAST secure connections to your OEM wire harness.

Posi-Tap Patent # 5,228,875 5,695369 5,868,589 6,692,313 Jap 2881414, Aus 708700, Tia 103534, Can 2204826TM

Mex 200626 Korea 477279, China Z197105562.9 & others pending

Disconnect negative battery clamp from battery.

For easiest installation remove the radio and disconnect

the harness from the back of the radio.

Connect the Posi-Tap connectors to the corresponding

wires of your radio harness. Consult your car or radio

manufacturer’s manual to get the correct color codes

for your vehicle.

Red (+) 12V Power. Turns on when ignition/accessory is on.

Blue/White Turns on remote accessories (amplifiers, etc.).

If there is no Remote Amplifier wire, you can often use the

power antenna wire.

White (+) Left Front Speaker

White/Black (-) Left Front Speaker

Gray (+) Right Front Speaker

Gray/Black (-) Right Front Speaker

Make sure the end with the 6 pin Molex connectors is

toward the radio. Run the BTAH harness behind radio,

dash and along the edge of the vehicle until you get

to the place you have decided to mount the tube.

Continue to thread until the cap

is tight and the wire is pierced.

Make sure to attach all 6 of the

FAST-9999 harness wires to

your OEM harness.

Plug the FAST-9999 harness into

the FAST-BTAH. Mount grounding

ring and plug the 14 pin connector

into the BASS TUBE. For more information

on placement and mounting, consult

your amplified tube instruction manual.

FAST-9999

14 pin connector

to the BAZOOKA

Ground to

chassis of

vehicle

FAST-BTAH

Remove the top cap. Place the wire

that is going to be tapped. In the

grove of the cap as far down as it

will go.

Make sure not to cross thread the

cap when screwing it back in place.

Product specificaties