Bauknecht BCIF 5O41 PLEGTS Handleiding

Bauknecht Afwasmachine BCIF 5O41 PLEGTS

Lees hieronder de 📖 handleiding in het Nederlandse voor Bauknecht BCIF 5O41 PLEGTS (13 pagina's) in de categorie Afwasmachine. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/13
EN
1
THANK YOU FOR PURCHASING A BAUKNECHT PRODUCT.
To receive more comprehensive help and support, please register your product at:
www.bauknecht.eu/register
1 2 3 4 5 6 7 8 9 10
1. Upper rack
2. Cutlery rack
3. Foldable aps
4. Upper rack height adjuster
5. Upper sprayer arm
6. Power Clean support
7. Lower rack
8. Lower sprayer arm
9. Filter Assembly
10. Salt reservoir
11. Detergent and Rinse Aid dispensers
12. Rating plate
13. Control panel
1. ON-OFF button
2. CYCLES 6 buttons for direct access popular cycles
3. EXTRA CYCLES button. Access to other cycles
4. INFO button. Provide info for selected cycle
5. DISPLAY - Indicators area
6. DISPLAY - Information area
7. PREVIOUS button for options/settings
8. OK button. Select/change options and settings
9. NEXT button for options/settings
10. START button
PRODUCT DESCRIPTION
Before using the appliance carefully read Safety Instructions guide.
The control panel of this dishwasher activates pushing by ON/OFF button.
For energy saving the control panel deactivates automatically after 10 minutes if no cycle has started.
CONTROL PANEL
DISPLAY - Indicators
A. START DELAY
B. ECO CYCLE
C. MULTIZONE - Cutlery rack
D. CLOSED WATER TAP
E. ADD SALT
F. MULTIZONE - Upper Rack
G. MULTIZONE - Lower Rack
H. ADD RINSE AID
I. TABLET
A B C
I H G F
D
E
1
7
2
3
4
6
5
11
13
12
10
8
9
0000 000 00000
Service:
2
EN
After connecting the appliance to the power supply for the rst time,
the display will guide you to set up the appliance for rst use.
1. The language selection
To select preferred language please
press button „<” or „>”.
Conrm by pressing „OK” button.
After language conrmation, the appliance will go through the rst time
use conguration menu.
2. Setting the water hardness
The water hardness is by default set
to level 3. To change water hardness
l
evel press button „< or „> repeatedly.
To conrm your choice press „OK”
button. The level must be set
according to the table below.
To allow the water softener to work
in a perfect way, it is essential that the water hardness setting is based
on the actual water hardness in your house. This information can be
obtained from your local water supplier.
3. Filling the water softener
When water hardness is set, it is
required to ll water softener with
water and special regeneration salt.
Remove the lower rack and unscrew
the reservoir cap (anticlockwise)
As a rst step it is needed to ll
reservoir with water ( ~1.5 litres).
Once done, proceed to the next
step by pressing „OK” button.
Position the funnel (see gure) and ll the salt reservoir right up to its
edge (approximately 1 kg); it is not unusual for some water will spill out.
Remove the funnel and wipe any salt residue away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Once done, proceed to the next step by pressing OK” button.
Only use salt that has been specically designed for dishwashers.
4. Setting the brightness level
The brightness level is by default set
to level 5. To change brightness level
press button „<” or „>” repeatedly.
To conrm Your choice press OK
button.
5. Detergent type operation
In this step it is very important to
choose what type of detergent will
be used (tablet/capsule or
gel/powder).
If you prefer to use All-in-one
detergent in tablet or capsule for
washing - press „OK”, then go to
step on the 7. Open tap operation
next page.
The symbol on display will be lit. If you prefer to use gel or
powder detergent for washing, press „<” or >”, then go to step 6.
Rinse aid operation.
6. Rinse aid operation*
*If All-in-one detergent was chosen in the previous step, this step will
be skipped by the appliance.
LANGUAGE: ENGLISH?
<> = CHANGE OK = YES
ENGLISH
SELECTED
WATER HARDNESS = 3
<> = CHANGE OK = YES
WATER HARDNESS
(1=MIN, 5=MAX)
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5 Very hard 35 - 50 61 - 90 43 - 62
POUR WATER
OPERATION
INSERT 1,5 LITER OF
OK = DONE
WATER IN THE
OK = DONE
WATER SOFTENER
OK = DONE
INSERT SALT
OPERATION
ADD 1KG OF SALT
OK = DONE
IN THE SALT DISPENSER
OK = DONE
ADJUST BRIGHTNESS
(1=MIN, 5=MAX)
BRIGHTNESS = 5
<> = CHANGE OK = YES
DETERGENT TYPE
OPERATION
DO YOU USE
<> = NO OK = YES
DETERGENT?
<> = NO OK = YES
“ALL IN ONE”
<> = NO OK = YES
RINSE AID
OPERATION
INSERT RINSE AID
OK = DONE
IN THE DISPENSER
OK = DONE
A
B
FIRST TIME USE
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
Residual saline solution or grains of salt can lead to corrosion,
irreparably damaging the stainless steel components.
The guarantee is not applicable if faults are caused by such
circumstances.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
EN
3
1. Open the dispenser by pressing and pulling up the tab on the lid.B
2. Carefully introduce the rinse aid as far as the maximum (110 ml) re-
ference notch of the lling space - avoid spilling it. If this happens, A
clean the spill immediately with a dry cloth.
3. Press the lid down until you hear a click to close it.
4. Conrm operation by pressing „OK” button.
NEVER pour the rinse aid directly into the tub.
Setting rinse aid level
(not necessary when using tablets/capsules)
The rinse aid dosage can be adjusted to the detergent used. The lower
the setting, the less rinse aid is dispensed. The factory setting is for (5)
level.
To change, follow instructions in section “SETTINGS / MENU.
7. Open tap operation
Check water tap is open. If closed, open it then conrm by pressing
„OK” button.
8. First cycle operation
Before normal use of appliance it is
recommended to run Intensive cyc-
le rst, to calibrate the appliance.
Insert a detergent into dispenser
chamber (see below), then press D
„OK” button.
Intensive cycle will be selected
automaticly. Press „START”
button and close the appliance
door within 4 sec.
This rst cycle can be up to 20
minutes longer as a result of the
automatic calibration process.
After this process the appliance is ready for normal use.
OPEN TAP
OPERATION
OPEN THE
OK = DONE
WATER TAP
OK = DONE
FIRST CYCLE
OPERATION
REMEMBER TO RUN THE
OK = EXIT
INTENSIVE CYCLE
OK = EXIT
WITH EMPTY BASKETS
OK = EXIT
TO COMPLETE
OK = EXIT
THE FIRST SET UP
OK = EXIT
ADDING A DETERGENT
To achieve the best washing and drying results, the combined use of
detergent, rinse aid liquid and rened salt is required.
We recommend using detergents that do not contain phosphates or
chlorine, as these products are harmful to the environment.
Good washing results also depend on the correct amount of deter-
gent being used.
Exceeding the stated amount does not result in a more eective wash
and increases environmental pollution.
The amount can be adjusted to the soil level. In the case of normally
soiled items, use approximately either 35g (powder detergent) or
35ml (liquid detergent) and additional tea spoon of detergent directly
inside the tub. If tablets are used, one tablet will be enough.
If the crockery is only lightly soiled or if it has been rinsed with water
before being placed in the dishwasher, reduce the amount of deter-
gent used accordingly (minimum 25 g/ml) e.g. skip the powder/gel
putted inside the tub.
To open the detergent dispenser,
press button . Introduce the deter-C
gent into the dry dispenser only. D
Place the amount of detergent for
pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are D
indications to help the detergent
dosing.
2. Remove detergent residues from the edges of the dispenser and
close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If you are using a All-in-one detergents, we recommend that you add
salt in any case, especially if the water is hard or very hard (follow the
instructions given on the packaging).
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
C
D


Product specificaties

Merk: Bauknecht
Categorie: Afwasmachine
Model: BCIF 5O41 PLEGTS

Heb je hulp nodig?

Als je hulp nodig hebt met Bauknecht BCIF 5O41 PLEGTS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Afwasmachine Bauknecht

Handleiding Afwasmachine

Nieuwste handleidingen voor Afwasmachine