Azden 35XT Handleiding
Bekijk gratis de handleiding van Azden 35XT (12 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 20 mensen en kreeg gemiddeld 4.6 sterren uit 10.5 reviews. Heb je een vraag over Azden 35XT of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/12
INSTRUCTION MANUAL
330 DUAL-CHANNEL CAMERA-MOUNT
UHF WIRELESS MICROPHONE SYSTEM
330UPR - 35BT - 35HT - 35XT
Thank you for purchasing the Azden 330 Dual-Channel Wireless Microphone system. The
components included with your system will vary depending on the system configuration you
purchased. Below are the possible system configurations available with the 330UPR Dual-Channel
Receiver.
330LT
1 x 330UPR Dual-Channel Receiver
1 x Stereo Mini-Plug to Dual XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
2 x 35BT Body-Pack Transmitter
2 x EX-503L Lavalier Microphone
330LH
1 x 330UPR Dual-Channel Receiver
1 x Stereo Mini-Plug to Dual XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35BT Body-pack Transmitter
1 x EX-503L Lavalier Microphone
1 x 35HT Handheld Microphone / Transmitter
330LX
1 x 330UPR Dual-Channel Receiver
1 x Stereo Mini-Plug to Dual XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35BT Body-Pack Transmitter
1 x EX-503L Lavalier Microphone
1 x 35XT XLR Plug-in Transmitter
CAUTION
• Do not use batteries other than the ones specified in this manual. Do not mix fresh battery with
used battery.
• When installing batteries, make sure the battery polarity is correct as marked inside the battery
compartment.
• Remove the batteries before long-term storage of the transmitters or receiver.
• Do not submerge any of the components in water.
Quick Start Guide
1. Install new AA alkaline batteries into the receiver and transmitters.
2. Connect the EX-503L lavalier microphone(s) to the MIC input on the 35BT(s).
3. Turn on your transmitters. You should see information displayed on the LCD. Be sure to also turn
the AUDIO switch to ON.
4. Set the transmission frequency for each transmitter by pressing the Channel Up/Down buttons.
Each transmitter will need to be set to a different frequency in order to run them at the same time
without interference. Keep the group number the same (1st two digits) and separate the
frequency numbers (2nd two digits) by at least 16.
5. Turn on both channels of the receiver. You can toggle the information for each channel by pressing
the DISP 1/2 button located below the LCD.
6. Set the group and frequency numbers on each channel of the receiver to match those set
previously on the transmitters.
7. The receiver should now be connected to the transmitters. To check, you can connect headphones
to the PHONE jack of the receiver and listen for audio.
For a more detailed description of component controls, functions and setup, please continue
reading this manual.
3
Product specificaties
| Merk: | Azden |
| Categorie: | Niet gecategoriseerd |
| Model: | 35XT |
Heb je hulp nodig?
Als je hulp nodig hebt met Azden 35XT stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Niet gecategoriseerd Azden
10 Mei 2023
1 April 2023
24 Maart 2023
16 Maart 2023
2 November 2022
Handleiding Niet gecategoriseerd
- TVS
- 8BitDo
- Sungrow
- Eufy
- WHD
- Truper
- Clearblue
- Wamsler
- PulseAudio
- Avteq
- Pressalit
- Zalman
- Monster
- IOptron
- Active Era
Nieuwste handleidingen voor Niet gecategoriseerd
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025